What Causes the Puttering Sound in a Car Engine?

1 Answers
ZaneMarie
07/29/25 7:18pm
Car engine puttering sound can be caused by: 1. Faulty spark plugs, ignition wires, or ignition coils; 2. Clogged fuel injectors; 3. Leaking valves, carbon buildup on pistons, or leaking piston rings. Solutions for engine puttering include: 1. Repairing or replacing spark plugs, ignition wires, and ignition coils; 2. Cleaning fuel injectors; 3. Fixing valves and pistons. An engine is a machine that converts one form of energy into another, typically transforming chemical energy into mechanical energy. Its working principle involves converting the thermal energy of gasoline into mechanical energy by burning it in a sealed cylinder, where expanding gases push the pistons to perform work, thereby providing power to the vehicle.
Was this review help?
14
1
Share
More Forum Discussions

What is the difference between dual throttle cables and single throttle cables?

Here are the differences between dual throttle cables and single throttle cables: 1. The number of throttle cables differs: If it is a single cable, there is only one throttle cable under the right-hand throttle grip. In contrast, if it is a dual cable setup, there are two throttle cables under the right-hand throttle grip. 2. The precision of throttle control varies: Dual throttle cables offer more precise control compared to single cables. 3. The throttle return effect differs: Dual throttle cables provide better throttle return than single cables. 4. Their applications vary: Constant vacuum carburetors often use dual throttle cables, while slide carburetors typically use single throttle cables.
11
5
Share

What is the Difference Between Guide Lanes and Variable Guide Lanes?

Here are the differences between guide lanes and variable guide lanes: 1. Different in nature: (1) Guide lanes: These are lane markings that guide direction. They are used to indicate the direction vehicles should follow when entering an intersection. (2) Variable guide lanes: The direction after entering this lane must be determined according to the corresponding lane traffic light. 2. Different in use: (1) Guide lanes: Used to indicate the direction vehicles should follow at an intersection. (2) Variable guide lanes: Adjust traffic flow in different directions to reduce congestion. 3. Different route requirements: (1) Guide lanes: The driving direction is fixed, and vehicles must follow the lane markings. Special attention should be paid to left-turn lanes, where overtaking is not allowed. (2) Variable lanes: Multiple diagonal lines are drawn inside the lane.
9
1
Share

Can You Wear Contact Lenses for a Driver's License Test?

You can wear contact lenses for a driver's license test. Here are the relevant details: 1. Vision correction requirements: For drivers applying for large passenger vehicles, medium-sized passenger vehicles, tractors, city buses, large trucks, trolleybuses, or tram licenses, the naked or corrected vision of both eyes must reach 5.0 or above on the logarithmic visual acuity chart; for drivers applying for other license types, the naked or corrected vision of both eyes must reach 4.9 or above on the logarithmic visual acuity chart. 2. Examination room requirements: Contact lenses can be worn during the test in the examination room, but no electronic devices such as mobile phones or headphones are allowed. Additionally, according to the latest regulations, wearing slippers during the test is prohibited.
11
4
Share

What are the reasons for an automatic transmission being stuck in P gear and unable to move?

Possible reasons for an automatic transmission being stuck in P gear and unable to move include: a faulty gear limit switch or brake light switch, a damaged brake light fuse, or a malfunctioning P gear solenoid valve or wiring. Below is an introduction to the automatic transmission gears: 1. P-Parking, the parking gear, used when starting the vehicle. 2. R-Reverse, the reverse gear, used when backing up. 3. N-Neutral, the neutral gear, used for temporary stops (such as at a red light). 4. D-Drive, the forward gear, also known as the driving gear. 5. L-Low, the low-speed gear. 6. S-Sport, indicating sport mode; when engaged, gears can be freely switched, but the shifting timing is delayed. 7. OD-Overdrive, the overdrive gear, used for high-speed driving to save fuel.
15
4
Share

How Much Fuel Evaporates from a Car Tank in One Month?

Gasoline in the fuel tank will evaporate over a month, but the amount of evaporation is minimal and negligible. The fuel tank is not a completely sealed device. To prevent fuel splashing during refueling, the tank is equipped with a vent pipe connected to a charcoal canister, which in turn has a pipe leading directly to the atmosphere. However, since it passes through the charcoal canister, it does not cause pollution to the atmosphere. Below are the hazards of parking a car for one month: 1. Premature failure and aging of oil seals, leading to oil leaks: When a vehicle is parked in one place for an extended period, the contact pressure around the oil seals becomes uneven. Over time, this can cause permanent deformation of the oil seals, resulting in oil leaks, which can lead to various hidden dangers in the vehicle. 2. Significant reduction in battery life: The vehicle's battery charges while the car is running. If the car remains parked for a month without use, the battery cannot recharge. Some electronic devices, such as the anti-theft module, continue to operate even when the car is turned off and parked. For older vehicles, the battery may die within 2-3 weeks. 3. Tire deformation: When a car is parked, the entire weight of the vehicle is borne by the areas of the four tires in contact with the ground, causing those areas to compress and deform. The longer the car remains parked, the harder it is for the deformed areas to recover, leading to uneven weight distribution around the tires and irregular rolling radii, resulting in unbalanced tires. Once the car is driven at high speeds, this can cause body vibrations, accelerate tire wear, and pose safety risks. 4. Fluid deterioration: If a vehicle is parked for an extended period, the oxidation of engine oil becomes more severe. Oxidized oil affects the lubrication performance of the engine, and acidic substances can corrode mechanical components. The longer the vehicle remains parked, the more severe the oil oxidation becomes. Additionally, the oil will settle back into the oil pan, and when the car is started again, dry friction between the cylinders and pistons will accelerate component wear and increase starting resistance.
2
1
Share

What is the model of the Passat low beam bulb?

The model of the Passat low beam bulb is H7. Introduction to car headlights: Also known as car front lights or car LED daytime running lights, as the eyes of a car, they not only relate to the external image of a car owner but are also closely connected to safe driving at night or under bad weather conditions. Maintenance of car headlights: Pay attention to checking whether there are cracks in the headlights, as although surface cracks do not affect the lighting performance of the headlights, moisture can seep into the lamp along the cracks, which will inevitably reduce the lifespan of the bulb. The calibration of the headlight beam direction should also be included in the maintenance checklist, as to ensure the maximum safety of the driver, the headlights must provide good forward lighting for the moving vehicle.
19
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.