What Causes the Jerking Sensation When Accelerating a Motorcycle?

3 Answers
StChloe
07/23/25 9:38pm
Motorcycle jerking is mainly caused by the engine and clutch. The ignition, intake, and fuel injectors collectively determine the fuel supply, so weak acceleration is naturally related to these systems. Below is relevant information: 1. Engine RPM: During the break-in period, the engine RPM should be varied frequently, and all gears should be broken in. Avoid keeping the throttle at a fixed RPM for prolonged periods. The purpose is to ensure balanced load distribution across all components, but do not exceed the specified maximum RPM. 2. Oil Circulation: During the break-in period, whether starting from a hot or cold engine state, allow the engine sufficient idle time (3-5 minutes) to warm up, ensuring oil reaches all lubrication points.
Was this review help?
5
3
Share
KeeganDella
08/10/25 5:21pm
I encountered this issue when I used to ride motorcycles. Jerky acceleration is usually caused by problems in the ignition system. If the spark plugs are worn out or the ignition coils are faulty, it can lead to incomplete combustion, causing the bike to jerk during acceleration. I remember once when I replaced a spark plug, the jerking sensation disappeared. Also, check if the high-voltage wires are aged or loose, as this can affect current transmission. Poor ignition can also lead to engine carbon buildup, and if left unchecked for a long time, it may damage internal engine components. So, early inspection can save you a lot of money. A clogged air filter may also disrupt the air-fuel mixture ratio, but ignition issues are more common.
Was this review help?
8
0
Share
Expand All
MacKevin
09/23/25 5:17am
I commute by motorcycle every day, and recently I've been experiencing noticeable jerking when refueling, probably due to an issue with the fuel system. The fuel filter might be clogged with impurities, or the fuel pump could be aging and not delivering enough fuel, causing unstable engine fueling and stuttering during acceleration. It's also worth checking if the throttle cable is loose, as this directly affects the fuel response. In regular maintenance, replacing the fuel filter periodically is crucial—I check it every six months to avoid major problems. Ignoring such issues not only affects the driving experience but also increases fuel consumption and emissions, and over time, it can damage the engine. I recommend first going to a garage to test the fuel pressure with a pressure gauge—it's simple and practical.
Was this review help?
10
1
Share
Expand All
More Forum Discussions

Can a 17-year-old apply for a driver's license?

According to the "Regulations on the Application and Use of Motor Vehicle Driver's Licenses": 17-year-olds cannot take the driver's license test. The age recorded on the ID card is used as the standard, and one must reach adulthood before applying for a driver's license that meets the age requirements. However, one can enroll in a driving school in advance to learn theoretical driving knowledge. The age requirements for applying for a driver's license are as follows: To apply for a license for small cars, small automatic transmission cars, small automatic transmission passenger cars for the disabled, or light motorcycles, the applicant must be between 18 and 70 years old. To apply for a license for low-speed trucks, three-wheeled vehicles, ordinary three-wheeled motorcycles, ordinary two-wheeled motorcycles, or wheeled self-propelled machinery, the applicant must be between 18 and 60 years old. To apply for a license for urban buses, large trucks, trolleybuses, or trams, the applicant must be between 20 and 50 years old. To apply for a license for medium-sized buses, the applicant must be between 21 and 50 years old. To apply for a license for tractors, the applicant must be between 24 and 50 years old. To apply for a license for large buses, the applicant must be between 26 and 50 years old. Students receiving full-time driving vocational education who apply for licenses for large buses or tractors must be between 20 and 50 years old. Physical requirements for applying for a driver's license: Height: Applicants for large buses, tractors, urban buses, large trucks, or trolleybuses must be at least 155 cm tall. Applicants for medium-sized buses must be at least 150 cm tall. Vision: Applicants for large buses, tractors, urban buses, medium-sized buses, large trucks, trolleybuses, or trams must have uncorrected or corrected visual acuity of at least 5.0 on the logarithmic visual acuity chart. Applicants for other license types must have uncorrected or corrected visual acuity of at least 4.9 on the logarithmic visual acuity chart. Those with monocular vision impairment can apply for a license for small cars, small automatic transmission cars, low-speed trucks, three-wheeled vehicles, or small automatic transmission passenger cars for the disabled if their uncorrected or corrected visual acuity in the right eye is at least 5.0 on the logarithmic visual acuity chart and their horizontal visual field is at least 150 degrees. Color vision: No red-green color blindness. Hearing: Able to distinguish the direction of sound with each ear at a distance of 50 cm from a tuning fork. Those with hearing impairment who can meet the above requirements with hearing aids can apply for a license for small cars or small automatic transmission cars. Upper limbs: Both thumbs must be intact, and each hand must have at least three other fingers intact, with normal limb and finger movement. Those with missing finger tips or three intact fingers on the left hand and complete palms on both hands can apply for a license for small cars, small automatic transmission cars, low-speed trucks, or three-wheeled vehicles. Lower limbs: Both lower limbs must be intact and have normal movement, with a length difference of no more than 5 cm. Those with a missing or non-functional left lower limb can apply for a license for small automatic transmission cars. Torso and neck: No movement dysfunction. Those with missing or non-functional right lower limbs or both lower limbs who can sit independently and meet the upper limb requirements can apply for a license for small automatic transmission passenger cars for the disabled. Those with one missing hand, an intact thumb on the other hand, at least two other intact fingers, normal upper limb and finger movement, and meeting the lower limb requirements can apply for a license for small automatic transmission passenger cars for the disabled. Applicants for a motor vehicle driver's license must submit their application to the vehicle management office according to the following regulations: Applicants residing in their registered permanent residence must apply at their registered permanent residence. Applicants residing in a temporary residence can apply at their temporary residence (in Ningbo, a temporary residence permit valid for at least 3 months is required). Active military personnel (including armed police) must apply at their place of residence. Foreign nationals must apply at their place of residence. Applicants applying for an additional license type must apply at the place where their current driver's license was issued.
9
3
Share

Why do 4S shops only apply film after license plate registration?

Because new cars cannot pass vehicle inspection after film application, making license plate registration impossible. Therefore, 4S shops generally apply film to new cars only after license plate registration. The following are the functions of film application: 1. Blocking ultraviolet rays: After film application, cars can block ultraviolet rays, especially in hot summers when sunlight is strong. Film can block part of visible light and ultraviolet rays, helping to reduce the temperature inside the car. 2. Improving car privacy: Many car owners choose darker films because they have good one-way perspective function. Looking from outside the car into the interior creates visual reflection, making it difficult to see the situation inside the car clearly.
4
0
Share

What is the general height of a tanker truck?

The height of most tanker trucks is 10.5 meters. Below are specific details about concrete mixer trucks: Function: A concrete mixer truck is a specialized vehicle used to transport construction-grade concrete, with a rotating drum during transit to prevent the concrete from solidifying. Composition: A concrete mixer truck consists of a truck chassis and specialized concrete mixing and transport equipment. Working Principle: The power from the truck chassis is extracted via a power take-off device, which drives a hydraulic system's variable pump, converting mechanical energy into hydraulic energy that is transmitted to a fixed displacement motor. The motor then drives a reduction gear, which in turn drives the mixing mechanism to agitate the concrete.
8
1
Share

Will gas stations underfill your tank?

Gas stations generally do not underfill your tank. Precautions when refueling: Choose reputable gas stations: If the gasoline quality is poor, it can cause carbon buildup on valves, fuel injectors, intake manifolds, and combustion chambers, leading to cold start difficulties, engine shaking, cold engine knocking, and issues like catalytic converter clogging or sintering. Select appropriate fuel: Choose the right gasoline based on your car's engine power output. Generally, when purchasing a car, you can find a label near the engine indicating the recommended gasoline grade, so there's no need to use more expensive fuel.
12
3
Share

How to Solve the High Fuel Consumption Issue in the 2010 Hyundai ix35?

Regular maintenance ensures fuel efficiency. During daily use, it is essential to perform frequent maintenance and checks, and address any issues immediately. Reduce vehicle weight by regularly cleaning the trunk and avoiding unnecessary items in the car. Correct driving habits: For automatic transmissions, ease off the accelerator when the RPM reaches 2000–3500. Maintain steady acceleration—avoid sudden throttle releases, as the engine control unit may not immediately determine whether the driver intends to decelerate or accelerate. Avoid coasting in neutral, as it consumes idle fuel, equivalent to the fuel used at 60 km/h.
13
5
Share

Why is the car antifreeze being used up quickly?

Here are the specific reasons for rapid antifreeze consumption in cars: 1. Radiator damage: Poor sealing of the upper and lower water chambers leads to antifreeze leakage. Regularly inspect all sealing points and connections. 2. Loose pipe fittings: Loose connections at the overflow tank, water pump interface, and various cooling system pipe joints with poor sealing cause antifreeze leakage. 3. Cylinder issues: Damaged cylinder gaskets, excessive flatness deviation or warping of the cylinder head and block mating surfaces, and loose cylinder head fastening bolts allow high-temperature, high-pressure gases to enter the cooling system, resulting in excessive antifreeze consumption.
12
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.