···
Log in / Register

What Causes the Jerking During Startup of the Verano?

3 Answers
JackLynn
08/26/25 5:38am
Buick Verano's jerking during startup is due to reasons such as automatic transmission acceleration and upshifting, damaged solenoid valves, and high transmission temperature. The details are as follows: Automatic Transmission Acceleration and Upshifting: Jerking during startup in an automatic transmission car is a normal phenomenon. If you want to accelerate quickly while driving, you need to press the accelerator deeply. At this time, the automatic transmission will automatically downshift to increase the engine speed. When the speed reaches a certain level, it will upshift again. After upshifting, the speed will drop significantly, resulting in a relatively obvious jerking sensation. Damaged Solenoid Valves: Damaged solenoid valves are an important cause of jerking. The sensation of jerking is like being kicked from behind. Jerking can be divided into occasional and fixed-time occurrences. The distinction is simple: occasional jerking occurs without any pattern, while fixed jerking happens at a certain speed or when shifting between specific gears at a fixed speed. High Transmission Temperature: High transmission temperature can degrade the quality and friction characteristics of automatic transmission fluid, increasing friction and wear. This leads to transmission noise, and sludge, impurities, or dirt can also form inside the transmission, such as in the valve body, causing jerking and impact in the transmission.
Was this review help?
11
2
Share
LukasDella
09/08/25 7:56am
I've experienced the jerky start issue several times while driving my Verano. It feels like the car suddenly lurches forward, which can be quite startling. Common causes include potential automatic transmission problems. The Buick Verano uses a dual-clutch transmission that's prone to jerking, possibly due to oil accumulation in valves or worn clutch plates, leading to unstable power output during acceleration. Poor engine combustion can also contribute, such as aging spark plugs or faulty ignition coils causing unstable idle and subsequent jerking. Other factors might be incorrect sensor signals from the ECU (Electronic Control Unit) or driving habits like aggressive throttle input. I'd recommend checking your transmission fluid and maintenance records first - adding some fuel additive significantly improved my own vehicle. For safety, if the jerking is severe, visit a professional repair shop immediately to prevent potential driving hazards.
Was this review help?
8
2
Share
Expand All
DaniellaRose
10/22/25 8:02am
Haha, I've been driving the Verano for over five years, and the jerky start is quite common, mostly due to minor issues with the engine or transmission. For example, excessive carbon buildup in the engine's intake system can clog the throttle valve, causing uneven combustion of the air-fuel mixture at idle and making the car wobble like a drunkard when starting. It could also be a delay in the TCU control of the automatic transmission—Buick's dual-clutch tends to stutter at low speeds. Additionally, insufficient fuel pump pressure or dirty fuel lines can also cause this. I once experienced it, and changing the spark plugs made it much smoother. The key is regular maintenance—don't wait until symptoms become severe to address them. Safe driving is paramount, as jerky starts increase the risk of rear-end collisions.
Was this review help?
9
0
Share
Expand All
More Forum Discussions

How to Use the Nissan Sylphy Automatic Transmission?

The method for using the Nissan Sylphy automatic transmission is as follows: 1. Press the start button directly without stepping on the brake, at this time the ACC light will turn on. Press the start button again, and the vehicle will perform a self-check; 2. Step on the brake, then press the start button to ignite and start the engine. Release the foot brake, and you can choose to warm up the car in place; 3. Step on the foot brake again, shift to D gear, and release the handbrake; 4. Slowly release the foot brake, and smoothly press the accelerator to add fuel according to road conditions. Taking the 2021 Nissan Sylphy as an example, it belongs to the compact car category, with body dimensions of: length 4631mm, width 1760mm, height 1503mm, a wheelbase of 2700mm, a fuel tank capacity of 50 liters, and a trunk capacity of 510 liters.
16
5
Share

What Causes Wavy Patterns on Car Glass?

Wavy patterns on car glass refer to continuous undulations visible on the glass surface, which can sometimes be felt by touch in severe cases. There are primarily four reasons for this phenomenon: 1. Furnace Temperature: Excessive temperature or prolonged heating time in the tempering furnace. This can be resolved by adjusting tempering process parameters, reducing the heating temperature or shortening the heating time. 2. Roller Deformation: Bent or deformed rollers, or individual rollers exceeding diameter/height specifications. This can be fixed by replacing or adjusting roller height. 3. Roller Rotation: Slow rotation or transmission speed of rollers. The solution is to appropriately increase roller rotation or transmission speed. 4. Cooling Process: During the tempering cooling phase, glass makes reciprocating movements on the roller bed of the furnace's cooling device. If the rapid cooling temperature is too high or air pressure too low during this stage, it can cause wavy bending of the glass surface. In such cases, furnace temperature and heating time should be promptly reduced.
20
1
Share

What to Do When the EPC Yellow Light Comes On in a Volkswagen?

When the EPC yellow light comes on in a Volkswagen, it is necessary to clean the vehicle's throttle body. The following are the reasons for the EPC yellow light coming on: 1. The issue is caused by a dirty throttle body. 2. It may be due to excessive carbon buildup. 3. Once the throttle body has a problem, it can lead to insufficient engine power, and in severe cases, it may cause the engine to stall while driving, affecting the normal operation of the vehicle. The throttle body of a motor vehicle is a controllable valve that regulates the air entering the engine. After the air enters the intake pipe, it mixes with gasoline to form a combustible mixture, which then burns to perform work. The throttle body is connected to the air filter at the top and to the engine block at the bottom, and is known as the throat of the car engine. The throttle body is one of the more important components in a vehicle.
14
0
Share

How to automatically fold the rearview mirrors of Audi Q5?

Adjusting the exterior rearview mirrors means turning the rotary knob to the corresponding position. Fold the exterior rearview mirrors. To unfold the mirrors, turn the knob to another position. The automatic folding function of the rearview mirrors when the car is locked can be turned on and off in the infotainment system. More relevant information is as follows: 1. Introduction: The Audi Q5 is a dynamic and versatile SUV. With its excellent performance and technological advantages, the Michelin Pilot Preceda PP2 high-performance sports tires have recently become the original equipment tires for the premium midsize SUV Audi Q5. 2. Configuration: The off-road safety performance of the SUV and the excellent comfort and flexible interior space of the station wagon inherit many of the advantages of the third-generation top SUV Audi Q7. The powerful green-efficient engine, quattro permanent all-wheel-drive system, and responsive driving mechanism make it easy to handle both on-road and off-road driving.
12
3
Share

What is the small iron block on the car hub?

The small iron block on the car hub is a wheel balancing weight. Its function is introduced as follows: The wheel balancing weight is a counterweight component installed on the wheel of the vehicle. Uneven mass distribution will affect the stability of the rotating object. The higher the rotational speed, the greater the vibration will be. The function of the balancing weight is to minimize the mass difference of the wheel to achieve a relatively balanced state. The introduction of tire dynamic balance is as follows: The wheel of a car is a whole composed of the tire and the hub. However, due to manufacturing reasons, the mass distribution of each part of this whole cannot be very uniform. When the car wheel rotates at high speed, it will form a dynamic imbalance state, causing the wheel to shake and the steering wheel to vibrate during driving. To avoid this phenomenon or eliminate the already occurred phenomenon, it is necessary to correct the balance of each edge part of the wheel by adding counterweights under dynamic conditions. This correction process is commonly known as dynamic balancing.
14
3
Share

How Many Drain Holes Does a Car Sunroof Have?

Five drainage holes. Below is relevant knowledge about drainage holes: 1. Water tank drainage hole: Most designs are upwardly inclined, so they may contain substantial water. For safety reasons, such drainage pipes are designed with special channels for water discharge. 2. Door-side drainage hole: Typically located near rubber seals, these appear concealed and may require removal as some windows aren't perfectly sealed, allowing rainwater ingress that can easily clog them. 3. Sunroof drainage outlet: If your sunroof frequently leaks, it's likely due to clogged drainage pipes preventing rainwater discharge, causing water to seep through gaps into the vehicle. 4. Engine drainage hole: This is the most prone to clogging. During rain, if you notice poor drainage, water may spread to the engine compartment, potentially causing starting issues. 5. Condensate drainage hole: Usually positioned below the car's evaporator. Normally, discovering water puddles beneath the vehicle indicates problems with the condensate drainage system.
18
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.