What Causes the Idle Vibration in Hyundai Elantra?

How to spray windshield washer fluid and which button to use?

Here is the relevant introduction on how to spray windshield washer fluid and which button to use: 1. Windshield washer fluid button switch: Generally located on the right-hand control stalk of the steering wheel. The design of the stalk may vary between different car models, but the operation to spray the washer fluid is basically the same. 2. Pull the stalk switch toward yourself: This will spray the windshield washer fluid. While the fluid is being sprayed, the wipers will automatically activate to clean the windshield until you release the stalk to stop the operation. 3. Notes: When operating the windshield washer switch, if the fluid does not spray after pulling the stalk, do not hold the stalk for an extended period. Otherwise, it may cause the motor to overheat and malfunction.

9

3

Share

At what temperature does the BMW 320 thermostat open?

BMW 320's thermostat generally starts to open automatically when the temperature at the engine's coolant inlet reaches 103 degrees Celsius, without requiring DME control. Working principle of the thermostat: The commonly used thermostat is a wax-type thermostat. When the coolant temperature is below the specified value, the refined paraffin in the thermostat's temperature-sensing body remains solid, and the thermostat valve closes the passage between the engine and the radiator under the action of the spring. The coolant returns to the engine via the water pump, performing a small circulation within the engine. When the coolant temperature reaches the specified value, the paraffin begins to melt and gradually turns into a liquid, increasing in volume and compressing the rubber tube, causing it to contract. As the rubber tube contracts, it exerts an upward thrust on the push rod, which in turn exerts a downward counter-thrust on the valve, causing it to open. At this point, the coolant flows through the radiator and the thermostat valve, then returns to the engine via the water pump, performing a large circulation. Signs of a damaged thermostat: If coolant continues to flow out from the upper water chamber inlet pipe of the radiator when the engine starts cold, it indicates that the main valve of the thermostat cannot close. If there is no coolant flowing out from the upper water chamber inlet pipe of the radiator when the engine coolant temperature exceeds 70 degrees Celsius, it indicates that the main valve of the thermostat cannot open normally, and repair is needed at this time.

11

1

Share

How to Match a Car Remote Key?

Go to a 4S shop or a professional car lock company for matching. The basic components of a remote key are as follows: 1. Transmitter: Composed of a transmission switch, transmission antenna, integrated circuit, etc., containing an identification code storage circuit and an amplitude modulation circuit, with a button-type lithium battery on the opposite side of the circuit. The transmission frequency uses radio waves, and the transmission switch button sends a signal once each time it is pressed; 2. Receiver: After the transmitter sends the identification code using shortwave modulation, it is received by the car's shortwave antenna, and then enters the shortwave high-frequency amplification processor of the receiver's electronic control unit through a distributor for demodulation, and is compared with the demodulator's identification code.

9

0

Share

Regulations on New Vehicle License Plate Registration Time?

There is no specific regulation on the time for new vehicle license plate registration, but temporary license plates or formal registration must be obtained before the vehicle can be driven on the road. The details are as follows: 1. Temporary driving within the administrative jurisdiction: For vehicle owners who have obtained a motor vehicle but have not yet registered it and need to drive temporarily within the administrative jurisdiction, temporary license plates with a validity period of no more than 15 days will be issued. 2. Temporary driving across administrative jurisdictions: For those who need to drive temporarily across administrative jurisdictions, temporary license plates with a validity period of no more than 30 days will be issued. If the vehicle owner needs to apply for temporary license plates multiple times, the vehicle management office may issue temporary license plates no more than three times.

10

3

Share

How to Check if a Car Has a Loan?

Here are the relevant methods for checking if a car has a loan: 1. Method 1: Check the Motor Vehicle Registration Certificate. You can look at the 'Motor Vehicle Registration Certificate' of the car, where the lending institution will be indicated on the second page of the certificate. Then, you can inquire at that institution. Note that if you are not the owner, you cannot make such an inquiry. 2. Method 2: Visit the personal loan department of the lending bank's branch. This way, the borrower can not only check the loan balance but also request the bank to print a repayment schedule for the year following the inquiry, providing a clear understanding of the loan situation within that year. 3. Method 3: Check via online banking. After activating online banking, you can check the balance without leaving your home. Borrowers typically perform this operation through Personal Loans, My Loans, and Loan Inquiry sections.

14

1

Share

How to Read a Car's Oil Dipstick?

Here is the method to read a car engine's oil dipstick: 1. Pull out the oil dipstick and use a tissue to completely wipe off the oil stuck to the dipstick head. 2. Reinsert the cleaned dipstick all the way in, then pull it out again. 3. Observe the position of the oil stuck on the dipstick. 4. If the oil level is between the upper and lower marks, it indicates the engine oil quantity is appropriate. If it's below the lower mark, you need to add oil. The following conditions are required for reading the dipstick: 1. The engine oil temperature must not be below 60 degrees; 2. Park the vehicle on a level surface, turn off the engine, and wait for three minutes to allow the oil to drain back into the oil pan. Then you can start checking the oil level.

8

5

Share

What Causes the Idle Vibration in Hyundai Elantra?

How to spray windshield washer fluid and which button to use?

At what temperature does the BMW 320 thermostat open?

How to Match a Car Remote Key?

Regulations on New Vehicle License Plate Registration Time?

How to Check if a Car Has a Loan?

How to Read a Car's Oil Dipstick?

What to Do If Your Car Is Vandalized with Scratches?

What is the fuel tank capacity of the Enclave?

Is the power of the GLB200 sufficient?

What does 'AC off to protect the engine' mean?