What Causes the Fuel Consumption on the Dashboard to Fluctuate?

How to solve the heavy throttle issue of BYD F0?

BYD F0 heavy throttle can be resolved by cleaning the throttle body or replacing the throttle cable. The throttle, a device on an internal combustion engine that controls the fuel supply, is generally controlled by a pedal in car engines, also known as the accelerator pedal, which is the device that controls the fuel supply to the engine. Additional information: 1. For manual transmission models where the throttle cannot return to its position, immediately press the clutch and shift the gear lever to the neutral position. This action is equivalent to the engine revving without transmitting power to the wheels. Then, you can slowly stop the car by the roadside as you normally would when braking, turn off the engine, and check the throttle pedal. If it is not stuck by foreign objects or floor mats but the throttle itself is stiff or stuck, do not continue driving. 2. For automatic transmission models, try to press the brake pedal. If the throttle is not stuck too deeply, forcing the brake can generally reduce the car's speed to a very low level, and then you can shift the gear lever to the N (neutral) position and pull over to stop.

17

5

Share

How to turn off the rear window wiper of Audi Q3?

Audi Q3 wiper switch: pulling inward activates the front wiper, pushing outward activates the rear wiper. When in the rear wiper position, push upward to turn off the rear wiper. Below is an introduction to the wiper: 1. The wiper, also known as the windshield wiper, is a device used to remove rain and dust attached to the vehicle's windshield, improving the driver's visibility and increasing driving safety. Due to legal requirements, almost all vehicles are equipped with wipers. Rear windows of hatchbacks and SUVs also have wipers. Besides cars, other means of transportation such as trains and trams are also equipped with wipers. Some engineering machinery, such as cranes, also have wipers. 2. The wiper assembly includes a motor, reducer, four-bar linkage, wiper arm spindle, and wiper blade assembly. When the driver presses the wiper switch, the motor starts. The motor's speed, through the torque-increasing effect of the worm gear, drives the swing arm. The swing arm drives the four-bar linkage, which in turn drives the shaft installed on the front panel to swing left and right. Finally, the shaft drives the wiper blade to sweep the windshield.

9

1

Share

Which country's brand is Baojun?

Baojun is a domestic brand. It is an independent automobile brand created by SAIC-GM-Wuling in 2010. The new passenger car brand "Baojun Auto" officially released by SAIC-GM-Wuling marks the formal entry of this Chinese microcar leader into the booming sedan market. The origin of the Baojun brand, "Jun" originally means a fine horse, and Baojun is people's most beloved fine horse. The following is a related introduction to Baojun Auto: 1. Baojun is produced in two major manufacturing bases in Liuzhou and Qingdao, with products covering sedans, MPVs, SUVs, new energy vehicles and other fields. 2. The Baojun brand is a passenger car brand suitable for global emerging markets, which SAIC-GM-Wuling has focused on creating by integrating more than 20 years of automobile manufacturing experience, the essence of eight years of joint venture operation, and fully leveraging the advantages of the three shareholders of SAIC, GM, and Wuling.

8

5

Share

Can I Add Antifreeze by Myself?

You can add car antifreeze by yourself. Yes, as long as the colors match, you can add it directly. Method for adding antifreeze: Before completely replacing the antifreeze, conduct a thorough inspection to check for any signs of leakage or cracks in the pipes, with a special focus on the five-way water pipe. The five-way pipe gets its name from the five interfaces that connect various parts. Antifreeze flows through the five-way pipe and is then distributed to different parts of the car to function. If there is any leakage of antifreeze in this section, replace the water pipe or re-secure the interface as needed. Drain the old antifreeze, then flush the liquid channels with clean water. Add clean water to the antifreeze reservoir and continue filling it until water flows continuously through the engine cooling system. Then, start the engine and let it idle for 3 to 5 minutes to circulate the water. Initially, the water flowing out of the reservoir may have a faint pink tint. Continue adding clean water until the outflowing water is clear. Remember to remove the heater water pipe and drain the water from the heater. Antifreeze composition: The main components of antifreeze are: 50% pure water, 40% methanol, and 10% other substances.

2

5

Share

What to Do When the Car Shows Insufficient Tire Pressure?

Insufficient tire pressure indicates that there is a leak in the car tire that needs to be repaired promptly. Visually inspect whether the tire can still continue to drive. If it can, drive to the nearest tire repair shop for treatment; if the tire pressure is already too low to drive, it is recommended to use an onboard air pump to inflate the tire, then go to the nearest repair shop for servicing; or replace it with the spare tire and then go for repair. The following is an introduction to car tire pressure: 1. Tire pressure, strictly speaking, refers to the pressure of the air inside the tire. In car maintenance, the engine is the heart of the car, and the damage to the engine will lead to the end of the car's life. Then, the tire pressure is the blood pressure of the car, and the level of tire pressure plays a crucial role in the performance and power of the car. 2. Tire pressure monitoring is the real-time automatic monitoring of tire pressure during the car's operation, and it alerts the driver in case of tire leaks or low pressure to ensure driving safety. Tire pressure monitoring is divided into indirect and direct types. Determining the type of tire pressure monitoring in your car helps to promptly address the issue when the tire pressure monitoring light comes on.

4

Share

What engine does the Hongqi H9 have?

The engine of the Hongqi H9 is independently developed by China FAW and is a domestically produced engine. The engine model of the Hongqi H9 is CA4GC20TD-31. The 2.0T version engine has a maximum power of 185kW and a maximum torque of 380Nm, while the 3.0T version engine has a maximum power of 208kW and a maximum torque of 400Nm. For daily maintenance of the Hongqi H9 engine, the following methods can be used: Use lubricating oil of appropriate quality grade. For gasoline engines, choose SD--SF grade gasoline engine oil based on the additional devices of the intake and exhaust systems and usage conditions. For diesel engines, choose CB--CD grade diesel engine oil based on mechanical load, with the selection standard not lower than the manufacturer's requirements. Regularly change the engine oil and filter. The quality of any lubricating oil will change during use. After a certain mileage, its performance deteriorates, leading to various engine problems. To avoid malfunctions, change the oil regularly according to usage conditions and keep the oil level moderate. When oil passes through the fine holes of the filter, solid particles and viscous substances in the oil accumulate in the filter. If the filter is clogged and oil cannot pass through, the filter may burst or the safety valve may open, allowing oil to bypass through the bypass valve and bring contaminants back to the lubrication area, accelerating engine wear and increasing internal pollution. Regularly clean the crankcase. During engine operation, high-pressure unburned gases, acids, moisture, sulfur, and nitrogen oxides from the combustion chamber enter the crankcase through the gap between the piston rings and cylinder walls, mixing with metal particles from wear to form sludge. Small amounts remain suspended in the oil, while large amounts precipitate, clogging filters and oil passages, making lubrication difficult and causing wear. Regularly use a radiator cleaner to clean the radiator. Removing rust and scale not only ensures the engine operates normally but also extends the overall lifespan of the radiator and engine.

19

2

Share

What Causes the Fuel Consumption on the Dashboard to Fluctuate?

How to solve the heavy throttle issue of BYD F0?

How to turn off the rear window wiper of Audi Q3?

Which country's brand is Baojun?

Can I Add Antifreeze by Myself?

What to Do When the Car Shows Insufficient Tire Pressure?

What engine does the Hongqi H9 have?

How to Deal with Water Marks After Using New Wiper Blades?

How to Remove the Interior Rearview Mirror of the Sylphy?

How to open the fuel tank cap of the Sagitar?

What are the reasons why a car's air conditioning is not cooling well?