What Causes the Engine to Make Loud Noises When Accelerating?

1 Answers
DelIsabelle
07/30/25 8:19am
The sound of the engine is directly related to its RPM—the higher the RPM, the louder the sound. When you press the accelerator, the engine's RPM increases, and so does the noise. Here are the specific details: 1. If you notice that acceleration is sluggish, power is lacking, and the engine makes a hysterical noise, this is most likely to occur when the engine is hot or cold or when it's low on oil. Possible causes include issues with the air filter, spark plugs, ignition wires, fuel, fuel filter, carburetor, or fuel pump. 2. If acceleration is normal while driving and ignition is functioning properly, but you observe that the engine RPM is too high while maintaining a constant speed without a corresponding increase in speed, check the coolant. Another possibility is incorrect ignition timing settings, which can also cause such symptoms. 3. If the engine produces a hissing sound, similar to steam or air escaping from the engine, and you notice a rapid loss of power afterward, it could be due to engine overheating, a blocked exhaust system, or a leaking or broken vacuum tube. 4. A whooshing sound from the engine during acceleration or deceleration may indicate low power steering fluid. 5. If the engine's damping components have aged, their shock-absorbing effectiveness decreases, leading to increased vibration and noise felt by passengers. 6. Inspect the vehicle's sealing strips. If replacing them doesn't make much difference, consider enhancing the overall sound insulation system of the car.
Was this review help?
19
0
Share
More Forum Discussions

Can a Water-Damaged Car Still Be Driven?

A water-damaged car should not be driven and must undergo inspection and repair before use. Depending on the duration of water exposure, the following scenarios may occur: 1. Based on the extent of water intrusion, if water has entered the vehicle interior or reached a high level, do not attempt to enter or move the vehicle; 2. For vehicles that have been water-damaged but repaired without completely eliminating potential hazards, the risks of continued use remain significant; 3. If a vehicle stalls while driving through water or immediately after being submerged, do not attempt to restart it. Forcing ignition may cause the engine to ingest more water, resulting in severe engine damage.
2
4
Share

What causes jerking between 1500 to 2000 RPM in a car?

It may be due to excessive carbon deposits or oil sludge clogging the throttle body. Below is some information about engine jerking: Throttle Body: The throttle body is a controllable valve that regulates air intake into the engine. After entering the intake manifold, the air mixes with gasoline to form a combustible mixture for power generation. Connected between the air filter and engine block, it's often called the "throat" of an automobile engine. Types: There are two main types - traditional cable-operated and electronic throttle bodies. Conventional throttle mechanisms use either a cable (flexible steel wire) or linkage rod, connecting the accelerator pedal to the throttle linkage plate. Electronic throttle systems primarily rely on throttle position sensors to adjust the throttle opening angle based on engine demand, thereby regulating air intake volume.
11
0
Share

What are some tips for fixing a malfunctioning central control touchscreen?

Here are some tips for dealing with a malfunctioning central control touchscreen: 1. Incomplete removal of the screen protector: Residual film adhering to the surface can affect sensitivity. This is the easiest issue to resolve—simply remove the screen protector completely. 2. Issues with the screen itself: There can be various causes for this, such as damage to the touchscreen itself, faulty wiring, or loose connections, among others. Most problems caused by the screen itself require professional inspection and repair at a specialized repair shop or 4S dealership. 3. Prolonged use of the screen: You can use a paperclip or toothpick to press the RST hole (reset button) on the central control screen, effectively restoring it to its initial state. Afterward, reinstalling the system should allow normal use.
3
3
Share

Will Flashing Pilot Lights Get You Fined?

Flashing pilot lights can result in fines. Here are the specific details about pilot lights: 1. Definition: Refers to daytime running lights (DRLs). Daytime running lights are designed to make the vehicle more visible to others during the day and are typically installed on both sides of the front end. 2. Purpose: Makes the vehicle more noticeable during daytime driving. Their function is not to help the driver see the road but to signal to others that a vehicle is approaching. Therefore, these lights are not for illumination but serve as signal lights. The goal of daytime running lights is to enhance traffic safety. As a result, many countries have established regulations in recent years to ensure that the production and installation of DRLs effectively contribute to safety.
4
4
Share

What Causes the Clanking Noise from the Chassis on Rough Roads?

The reasons for the clanking noise from the chassis on rough roads include: 1. Excessive clearance in the steering linkage ball joint, which can cause noise not only on bumpy roads but also during turns, and in severe cases, may lead to steering wheel vibration and uneven tire wear; 2. Excessive clearance or looseness in the lower control arm; 3. Loose or deformed chassis components; 4. Worn-out brake pads reaching their limit, resulting in direct friction with the disc. The chassis refers to the combination of the transmission system, running gear, steering system, and braking system in a vehicle. It supports and installs the engine and its various components and assemblies, forming the overall shape of the vehicle, bearing the engine's power, and ensuring normal operation.
1
1
Share

Is Gasoline Soluble in Water?

Gasoline is not soluble in water. If there is water in the fuel system, it can lead to decreased engine power, increased fuel consumption, vehicle shaking, and difficulty starting in winter. Water in the car's fuel tank can cause issues such as hard starting, engine backfiring, excessively high idle speed, or insufficient power. Therefore, it is essential to remove water from the fuel as soon as possible. Gasoline is produced by refining various gasoline components such as straight-run gasoline fractions, catalytic cracking gasoline fractions, and catalytic reforming gasoline fractions, which are then blended with high-octane components. It is primarily used in spark-ignition internal combustion engines for automobiles and mainly consists of organic compounds obtained from crude oil distillation and various additives.
1
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.