What Causes the Clicking Sound When Engaging Reverse Gear in Wuling Hongguang?

[OwenAnn]

Here are the specific reasons for the abnormal noise when engaging reverse gear in Wuling Hongguang: 1. Faulty Clock Spring: If the sound comes from inside the steering wheel, it may be caused by interference from the clock spring inside the steering wheel. 2. Lack of Lubrication in Shock Absorber Top Bearing: If the abnormal noise comes from outside the vehicle when turning the steering wheel, it may be due to insufficient lubrication in the shock absorber's top bearing. Applying some grease can solve this issue. 3. Loose Stabilizer Link Bushings: If the noise does not originate from the shock absorber's top bearing, check whether the stabilizer link bushings are loose or damaged. Loose or damaged stabilizer link bushings can cause noise not only when turning the steering wheel but also when driving on uneven roads. This can be fixed by adding shims. 4. Dirty Power Steering Fluid: If the power steering fluid is too dirty, it will increase the pressure in the power steering system. It is important to replace the power steering fluid promptly.

[DelilahLynn]

I've been repairing cars for many years. The most common issue with the Wuling Hongguang making a clicking noise when shifting into reverse is wear on the reverse gear synchronizer in the transmission, which causes poor gear meshing and noise. When this small synchronizer wears out, shifting becomes less smooth, and the clicking sound is like gears fighting each other. This car mostly has manual transmissions, and older models are particularly prone to this problem. Another reason could be that the clutch isn't fully depressed, leading to a semi-engaged state when shifting, which causes impact noise. It's also possible that the shift mechanism has become loose, or the transmission oil has deteriorated, providing insufficient lubrication and causing the gears to grind dry. I recommend first trying to fully depress the clutch and shift into reverse a few times. If the noise persists, don't delay—take it to a repair shop immediately for inspection. Don't wait until the gears are damaged and the transmission is compromised, as repairs can be expensive and dangerous. Develop good driving habits and operate the controls gently in daily driving.

[DeEden]

I've been driving my Wuling Hongguang for almost five years now, and I've also experienced that scary clicking sound when reversing. After some personal troubleshooting, I found it's mostly caused by non-standard gear shifting operations - like hastily pushing the gear lever without firmly depressing the clutch, resulting in gear collisions. Sometimes it's because the transmission fluid needs changing after prolonged use; dirty fluid provides poor lubrication and makes transmission components noisier. Another possible reason is excessive wear in the reverse gear itself. While Wuling vehicles are durable, frequent overloading during cargo transport can accelerate wear. I recommend trying fresh transmission fluid or adjusting your shifting habits. If the noise persists, visit a shop for professional diagnosis. Don't ignore it - worsening gear issues could affect driving safety. Spending a little now to prevent major repairs later is cost-effective. Early intervention means peace of mind sooner.

[OKate]

I know a mechanic who says this clicking sound is mostly due to synchronizer or gear meshing issues. When shifting into reverse, the gears might not align properly, causing friction and noise. Clutch problems can also worsen this situation. Check the fluid or your shifting habits. If the noise persists, take it to a shop.