There are multiple conditions under which the ABS light may illuminate, with different causes and solutions for each condition, as detailed below: Condition 1: ABS warning light remains constantly illuminated (most common). Cause 1: The ABS wheel speed sensor's sensing area is covered by dirt, mud, or other contaminants, affecting its ability to detect the corresponding speed signal. This prevents the ABS control module from determining the vehicle speed and wheel slip rate, thus failing to issue appropriate commands to regulate braking. Solution: Clean the contaminants from the wheel speed sensor and adjust the gap between the sensor and the signal ring to restore normal function. Cause 2: Poor signal transmission due to loose connections in the system wiring or poor contact in the ABS relay, leading to system malfunction. Solution: Inspect wiring connections and reconnect any loose connections. Condition 2: ABS warning light intermittently illuminates but turns off during acceleration. Cause: When multiple electrical components are in use, the battery voltage drops below 10.5V. As engine speed increases, voltage rises, and the ABS indicator turns off. Alternatively, the ABS system's power supply voltage may be too low due to poor terminal contact or grounding issues. Solution: Check the battery's specific gravity; inspect the charging system; examine the power supply (e.g., voltage relay or poor power contact). Condition 3: ABS warning light remains illuminated after engine start and only turns off when the engine is turned off (IGFF). Cause: Poor grounding contact in the ABS hydraulic valve body; poor electrical connector contact in the ABS hydraulic valve body; ABS control module malfunction. Solution: Loosen the grounding screw on the hydraulic valve body, then retighten it, cleaning the contact surface if necessary; check if connector gaps have widened; replace the ABS or ABS/ASR control module. Condition 4: ABS warning light illuminates during high-speed driving. Cause: During high-speed driving, the ABS control module detects a significant discrepancy between rear and front wheel speed signals; incorrect tire or wheel rim specifications. Solution: Refer to the vehicle's tire and wheel rim specifications, as indicated on the label near the fuel tank cap. Condition 5: ABS warning light intermittently illuminates. Cause: Improper adjustment of the brake light switch; poor internal contact in the brake light. Solution: With the engine running, press the brake pedal and use a finger to push the brake switch linkage fully downward, then release the brake pedal to complete self-positioning; replace the brake light switch if necessary. If the ABS warning light is illuminated, it is recommended not to continue driving, as this indicates a malfunction in the vehicle's anti-lock braking system. During emergency braking, if the wheels lock up, the vehicle may skid uncontrollably, preventing the driver from slowing down or adjusting the vehicle's trajectory, posing significant safety risks.
