What Causes Smoke from the Exhaust Pipe with a Burnt Smell?

1 Answers
OLila
07/29/25 5:15pm
White smoke from the exhaust pipe is generally normal, but if it appears in large quantities, it may indicate a faulty engine piston that has started burning oil. As for the smell, it is usually caused by the release of odor from the silicon material inside the catalytic converter when heated, which is also normal. However, if the pungent smell becomes increasingly strong, it is advisable to have it inspected and repaired at a service center. Below is more related information: 1. Normal white smoke: Normal white smoke occurs because the exhaust gases exiting the pipe are at a high temperature, causing the high-temperature water vapor to rapidly condense into tiny droplets in the cooler air, resulting in "white smoke," which is physically known as liquefaction. If there is a large amount of white smoke, it could be due to a damaged engine piston burning oil. 2. Excessive moisture: If there is too much moisture in the gasoline, it is recommended to clean the throttle body. If the gasoline contains water, check for leaks at the junction of the cylinder head and gasket. If leaks are found, it may indicate a damaged cylinder gasket. 3. White smoke in low temperatures: White smoke during cold starts is normal and should disappear as the engine warms up. However, if the smoke increases and persists when accelerating, accompanied by a worsening pungent smell, it is best to have it inspected and repaired at a 4S shop.
Was this review help?
5
4
Share
More Forum Discussions

How to Solve High Fuel Consumption in Diesel Vehicles?

During the operation of diesel engines, polymer deposits adhere to valves, valve seats, fuel injectors, and piston tops. These carbon deposits increase fuel consumption and should be promptly removed. When diesel generator sets operate under overload conditions, they emit black smoke due to the incomplete combustion of fuel. Conduct regular or irregular mechanical inspections and perform frequent maintenance and repairs.
11
5
Share

What to Do When Your Car Runs Out of Battery on the Road?

Open the hoods of both cars. Connect the negative terminal of the jumper cable to the negative terminal of the dead battery and the other end to the negative terminal of the other car's battery. Repeat the same process for the positive terminals. Then, start the other car and rev the engine slightly. Next, try starting the car with the dead battery. This should help jump-start the dead car.
5
0
Share

What are the methods for escaping from inside a car?

Most vehicle models can be unlocked and opened from the inside when locked out. Simply press the central locking switch or pull the door handle twice to unlock. Fold down the rear seats, then pull the internal trunk release switch to open the trunk and escape. Window breaker: Easy to use, requiring minimal force, operable by women and children with basic operational ability.
14
2
Share

How to Straighten a Crooked Handlebar?

Clamp the bicycle's front wheel between your legs and adjust the handlebars with both hands to keep them level. Loosen the alignment screws on both sides of the handlebar. Rotate the crooked handlebar until the kickstand and handlebar form a 90-degree angle, ensuring the handlebar is balanced. Use a hex wrench to tighten the alignment screws, then securely fasten the top cap screw.
13
5
Share

How to reset the maintenance wrench on Great Wall Fengjun 5?

Turn off the car, press and hold the right button on the dashboard (the reset button), then turn on the ignition switch while keeping the reset button pressed for several seconds. Enter the reset mode, then you can release the reset button. Within 20 seconds of releasing the reset button, press the left button on the dashboard to confirm the reset. At this point, the maintenance light will return to its normal display mode, meaning the flashing maintenance light has been reset.
10
1
Share

What to Do If the Vehicle Green Book Is Lost?

When the motor vehicle registration certificate is lost, the owner of the motor vehicle should promptly apply for a replacement at the vehicle management office under the jurisdiction of the motor vehicle. If the transfer procedures have not been completed, contact the original owner. The original owner must personally bring their ID card and driving license and drive the vehicle to the vehicle management office for a replacement. The current owner must personally bring their ID card and driving license and drive the vehicle to the vehicle management office for a replacement. This is the only motor vehicle-related service that cannot be handled by a proxy.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.