What Causes Oil Leakage at the Top of the Transmission?

What Causes a Burning Smell in the Car?

Reasons for smelling a burning odor in the car: 1. A plastic burning smell indicates overheating wires or an electrical short circuit; 2. A rubber burning smell suggests a fault in rubber components such as tires or belts. Burnt wires are usually accompanied by localized heating or smoke, and a careful inspection can identify the source of the issue and determine the faulty part. Check if any belts in the engine compartment are loose or slipping. If a belt is loose and emits a burning smell, it should be sent for repair immediately. Inspect the brake pads and tires for overheating. When the brakes or tires emit this smell, it's best to pull over immediately and wait for the brake pads to cool down naturally before driving again. Never pour cold water on the brake pads.

19

4

Share

Where is the hood switch located on the Bestune X40?

The hood switch of the Bestune X40 is located on the left side of the driver's footwell, near the lower part of the A-pillar on the driver's side. It is a cable-connected unlocking device that can be pulled to release the hood. Steps to open the hood: 1. Open the driver's door; 2. Engage the handbrake to prevent the vehicle from rolling; 3. Pull the hood switch located on the left side of the driver's footwell; 4. Lift the engine hood upwards; 5. Secure the hood with the support rod to ensure it is firmly held in place and to avoid any hazards. The Bestune X40 is a compact SUV with a 5-door, 5-seat configuration. Its dimensions are 4310mm in length, 1780mm in width, and 1680mm in height, with a wheelbase of 2600mm.

15

4

Share

What does it mean when the car EPC light is on?

The EPC indicator light can illuminate in two states: during power-on self-test and under other circumstances. The power-on self-test is an indication that the vehicle is monitoring the status of all sensors before driving. Generally, if the vehicle is not started after power-on, the light will turn off by itself after about 3 seconds. If the EPC light stays on under other circumstances or does not turn off for a long time after the vehicle is started, the main reasons for the EPC light staying on include faults in the engine intake system, throttle valve, fuel system, engine, ECU control unit, or brake lights. Below is a detailed introduction to the reasons for the EPC light illuminating under other circumstances: Engine intake system fault: The EPC light will illuminate if the engine intake is obstructed or insufficient. Throttle valve fault: Carbon buildup is a common issue with the throttle valve. Additionally, dirt on the main body can also affect intake, causing the indicator light to illuminate. Fuel system fault: Examples include substandard fuel, deteriorated fuel, or poor fuel atomization. Engine fault: Insufficient engine pressure or issues with the intake valve and other power system components can also trigger the EPC light. ECU control unit fault: Examples include interference with the vehicle computer signals or false alarms from the vehicle computer. Brake light fault: Situations such as brake lights not working, brake switch failure, or brake circuit issues. Solutions for when the car EPC light is on: Troubleshoot intake system issues, use fuel with the appropriate octane rating, clean the throttle valve, etc. Remove carbon deposits from related parts. Re-flash ECU-related data. If the EPC light is on, the owner can first try turning off the engine and restarting it to see if the EPC light remains on. If it does not illuminate again, there may be no issue, and the EPC light might have been affected temporarily. If the EPC light stays on or frequently illuminates, drive to the nearest vehicle repair point for professional assistance in troubleshooting to eliminate potential safety hazards promptly. The full English name of EPC is Electronic-Power-Control, which translates to electronic power control. Most people refer to it as the engine electronic stability system. The EPC system mainly includes controllers and sensors related to the power system. When sensor data in the system is abnormal, the EPC system will take predefined measures for the power system. Common EPC indicator lights are generally displayed in two colors: yellow and red. If the EPC fault light is yellow and the car can still drive normally, proceed slowly to a repair point for vehicle inspection. If the EPC fault light is red, it indicates a more serious situation, and the driver should pull over immediately and contact relevant repair personnel for maintenance. Forcing the car to drive under these conditions can directly affect the vehicle's core components or driving safety.

18

2

Share

Is an Automatic Clutch Considered an Automatic Transmission?

An automatic clutch is indeed part of an automatic transmission. Automatic transmission vehicles utilize an automatic clutch system, and the absence of a clutch pedal is due to the torque converter being located within the flywheel housing between the engine and the transmission. The torque converter assembly is secured to the rear plane of the flywheel with screws. During gear shifting, the automatic clutch system operates without any manual intervention, which explains why automatic transmission vehicles do not have a clutch pedal. The automatic clutch is an intelligent clutch control system developed for manual transmission vehicles. Without altering the transmission or clutch, it adds an independent operating system controlled by the vehicle's computer to manage the clutch. Automatic clutches can be categorized into two types: mechanical motor-driven automatic clutches and hydraulic automatic clutches. The ECU of a mechanical automatic clutch gathers signals from the accelerator pedal, engine speed sensor, vehicle speed sensor, etc., and drives the clutch mechanically.

15

5

Share

What Are the Reasons Why Airbags Fail to Deploy?

Reasons why airbags fail to deploy: 1. The manufacturer's preset deployment conditions are not met. Different automakers have varying criteria for airbag deployment, and if the triggering threshold is not reached, the airbag will not inflate. 2. The vehicle collision occurs at an angle that fails to activate the impact sensors, such as hitting the headlight area, front wheel position, or small objects. 3. The airbag warning light remains lit without timely inspection and repair. 4. Seat covers may cause side airbags to malfunction. 5. The airbag has reached the end of its service life. Precautions: 1. Airbags exert significant force upon deployment, so always use them in conjunction with seat belts. 2. Maintain proper seating posture with your back against the seat and minimal space between your head and the headrest. 3. Avoid placing objects near airbag compartments as they may become dangerous projectiles during deployment. 4. Never modify vehicle wiring without professional assistance, especially circuits related to airbag systems.

13

2

Share

How to Operate a Manual Transmission Car When Turning

Steps for operating a manual transmission car when turning: 1. After turning on the turn signal, slow down by pressing the foot brake. After turning, engage the accelerator. When shifting gears, press the clutch—always press the brake before pressing the clutch. 2. When shifting gears, press the clutch to downshift to 2nd or 3rd gear, then immediately release the clutch without pressing it again. 3. After downshifting to 2nd gear, release the clutch, steer the wheel, and rest your foot on the accelerator. 4. Maintain speed while steering to complete the turn. If turning on a crowded road or when there is a vehicle ahead, maintain an appropriate distance from the front car, shift gears promptly, and adjust speed to avoid rear-end collisions. If the road is complex or in poor condition, slow down and turn on hazard lights in advance to alert nearby pedestrians and vehicles.

9

1

Share

What Causes Oil Leakage at the Top of the Transmission?

What Causes a Burning Smell in the Car?

Where is the hood switch located on the Bestune X40?

What does it mean when the car EPC light is on?

Is an Automatic Clutch Considered an Automatic Transmission?

What Are the Reasons Why Airbags Fail to Deploy?

How to Operate a Manual Transmission Car When Turning

Where is the cabin air filter located in the Mazda 3?

How to Replace a Damaged License Plate Number?

What are the correct steps to use the one-button start in the Volkswagen Lavida?

When parking, should you press the clutch or the brake first?