What causes interference stripes in the reversing camera?
3 Answers
Interference stripes in the reversing camera are usually caused by loose wiring or poor contact between the display and the camera. Simply unplug and reconnect the connector to resolve the issue. The reversing camera, also known as a parking assist system, reverse visual system, or onboard monitoring system, is designed to aid in parking. Here’s how to use the guidelines on both sides of the reversing camera: 1. The green line indicates a safe distance, meaning there is ample space between the obstacle and the rear of the vehicle, allowing you to reverse with confidence. 2. The yellow line serves as a cautionary marker, indicating a distance of 60cm from the rear of the vehicle. You may continue reversing but should reduce speed and monitor the distance to the obstacle closely. 3. The red line is a warning marker, indicating a distance of 30cm from the rear of the vehicle. At this point, you should stop reversing immediately to avoid collision with the obstacle.
I've encountered the issue of interference stripes appearing in the reverse camera display several times. It's usually caused by electrical noise in the system, such as electromagnetic interference from car chargers or mobile phones placed too close, resulting in vertical bars or snow patterns on the screen. If the vehicle has incompatible aftermarket accessories installed, like poorly shielded power cables for added reverse cameras, this problem can easily occur. When I check it myself, I first try turning off other electronic devices. If the situation improves, it indicates external interference, and you can try parking in a different location to avoid the signal source. Then test whether the reverse light power supply is stable. If unstable, you may need to reinforce the ground wire or have a professional check the circuit. The reverse camera is crucial, so don't delay when problems arise. Address them promptly to prevent misjudging distances while parking.
Interference stripes appearing on the reverse camera display? I suspect it might be due to loose or damaged wiring connections. Think about it – the camera cable runs near the tire area, and prolonged vibration could cause connector loosening or wire insulation wear, leading to signal transmission errors and those horizontal bar interferences. When working on my car, I regularly check the rear camera connector – unplug it, clean the contacts, and firmly reconnect it. If that doesn't work, try replacing the cable with a new one, preferably choosing well-shielded cables to minimize external signal interference. Also check if there are any interference-related settings in the head unit – sometimes a simple system reset might solve the issue. Remember, reversing safety comes first – ensuring all connections are secure can prevent many headaches.
