What Causes Increased Idle Speed After an Oil Change?

1 Answers
DelElaina
07/29/25 12:05pm
Normally, changing the oil has no direct relationship with idle speed. If the idle speed increases after an oil change, it could be due to the following two reasons: 1. The vehicle previously used winter-grade oil with higher viscosity, and now it has been replaced with all-season oil with lower viscosity, reducing engine resistance and causing the idle speed to rise. 2. It could be due to the use of counterfeit oil. Counterfeit oil can cause significant damage to the engine, ranging from accelerated engine aging to complete engine failure. Therefore, it is essential to have the oil changed at a reputable automotive service center.
Was this review help?
14
1
Share
More Forum Discussions

What are the solutions for oil accumulation in the throttle of the new Mondeo?

When oil accumulates in the throttle of the new Mondeo, it can be resolved by replacing the throttle. Below is a detailed introduction about the automotive throttle: 1. Overview: The throttle is a controllable valve that regulates the air entering the engine. After the air enters the intake pipe, it mixes with gasoline to form a combustible mixture, which then burns to generate power. Connected to the air filter at the top and the engine block at the bottom, it is referred to as the throat of the car engine. 2. Classification: Throttles are divided into two types: traditional cable-operated and electronic. The traditional engine throttle operates through a cable (flexible steel wire) or linkage rod, with one end connected to the accelerator pedal and the other to the throttle linkage plate. The electronic throttle primarily uses a throttle position sensor to control the opening angle of the throttle based on the engine's power requirements, thereby adjusting the amount of air intake.
10
2
Share

Why is the price of used Lotus L5 cars low?

Lotus L5 used cars have low prices due to their low resale value. Here is a detailed introduction to automobile resale value: 1. Calculation: A car's resale value is calculated based on the original ex-factory price of the vehicle. According to the automotive industry's "10-year depreciation method," the car depreciates by 15% annually for the first 3 years, 10% annually for years 4-6, and 5% annually for years 7-10. 2. Influencing factors: Automobile resale value refers to the ratio of a car's selling price after a period of use to its original purchase price. It mainly depends on factors such as the vehicle's performance, price fluctuation range, spare parts costs, and maintenance convenience, essentially reflecting the comprehensive level of the vehicle. Models with high resale value have the advantage that their prices in the used car market are less affected by price reductions, thereby reducing the risk of economic losses due to product depreciation for some car owners.
16
5
Share

Where Should the Height of the Safety Headrest Be?

Safety headrests should be adjusted to be level with the head, or the softest part of the headrest should be aligned with the top of the ears. Here is some extended information about safety headrests: 1. Classification: Seat safety headrests are divided into adjustable or fixed types. Adjustable headrests can be further categorized into manual or electric adjustments, used to regulate the height and angle of the headrest. Most passenger vehicle seat headrests today are adjustable, allowing the headrest to better conform to the shape of the occupant's neck and back, with better fit leading to higher safety. 2. Selection: Some luxury cars feature front-row headrests with electric four-way adjustments (up, down, forward, backward). Economy car seat headrests are typically manually adjustable or fixed, with manual adjustments usually limited to up and down movements. From the perspective of protecting occupant safety, adjustable headrests should be chosen to accommodate the needs of occupants of different heights.
17
4
Share

Where is the fog light switch for Subject Three?

The fog light switch is located on the vehicle's lighting combination switch, specifically positioned behind the left side of the steering wheel. Here are some relevant details: 1. Usage: In foggy conditions or when visibility is extremely low, you can turn on the fog lights and also activate the hazard warning flashers. During the Subject Three driving test, you should check before the exam whether all lighting switches are reset (in the off position). If you hear the voice prompt or the examiner instructs you to turn on the fog lights, you can do so. After the test, remember to turn off all lights. 2. Avoid using fog lights in clear weather: On sunny days, do not keep the fog lights on continuously, especially the rear fog lights, as they can resemble brake lights from a distance, potentially causing confusion for drivers behind you and compromising safety. Therefore, it's important not only to know how to turn on the fog lights but also to use them correctly.
13
1
Share

What are the reasons for the inability to increase vehicle speed?

The reasons for the inability to increase vehicle speed are as follows: 1. Fuel supply system failure: The main power source for car acceleration is the engine, which operates by burning fuel. Therefore, if there is an issue with the fuel supply system, the vehicle speed will naturally fail to increase as required during rapid acceleration. 2. Failure to control fuel pressure, fuel injection quantity, or ignition timing as required: During rapid acceleration of a vehicle, fuel pressure, fuel injection quantity, and ignition timing are all critical factors. If these three aspects do not meet specifications, it is highly likely that the vehicle speed will not increase. 3. Problems with spark plugs and high-voltage wires: Spark plugs and high-voltage wires are important components of a car. The main function of spark plugs is to generate sparks to ignite the mixed gas in the cylinder, thereby increasing the vehicle speed. Therefore, when there are issues with spark plugs and high-voltage wires, attempting rapid acceleration may result in the vehicle speed failing to increase.
3
3
Share

What are the solutions for a malfunctioning start-stop system in the Sylphy?

You should immediately turn off the engine and reinstall the car battery. Below is a detailed introduction about the Sylphy: 1. Overview: The Sylphy is a mid-size sedan under Dongfeng Motor Co., Ltd. and is one of the most typical mainstream family cars in the Chinese market (alongside models like the Octavia PRO, Sagitar, Lavida, Corolla, and Bora). Its fuel consumption ranges from 4.9 to 6.1L/100km, and it has a displacement of 1.6L. 2. Other Details: It is equipped with a 1.6L naturally aspirated engine that meets the China VI emission standards, delivering a maximum power of 99kW (135 horsepower) and a peak torque of 159Nm. The transmission system is paired with a CVT gearbox. It also features the new Nissan-Connect super-smart connectivity system and comes with an 8-inch HD capacitive touchscreen.
9
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.