What Causes Car Antifreeze Leakage?

2 Answers
SanAshlyn
07/25/25 1:55am
The causes of car antifreeze leakage are: 1. Radiator damage, poor sealing of upper and lower water chambers; 2. Loose connections and poor sealing at the overflow tank, water pump joint surface, and cooling system pipelines; 3. Cylinder gasket damage; 4. Warping at the joint between cylinder head and cylinder block or loose cylinder head bolts. The solutions for car antifreeze leakage are: 1. Replace the radiator; 2. Tighten the screws at the overflow tank, water pump joint surface, and cooling system pipelines; 3. Replace the cylinder gasket; 4. Tighten the cylinder head bolts. The full name of antifreeze is antifreeze coolant, and its functions include: 1. Anti-corrosion; 2. High boiling point; 3. Prevention of scale formation.
Was this review help?
3
0
Share
StDamian
08/10/25 4:21pm
I've been driving for twenty years and have seen coolant leaks several times, usually due to cracks in the radiator connections or aging and damage to the hoses. High engine temperatures can soften and crack rubber. I remember last summer when the temperature light on the dashboard came on, I got out and found blue-green stains on the ground. I quickly added distilled water as an emergency measure and went to the repair shop. The mechanic said minor leaks should be fixed promptly, otherwise engine overheating could burn out the cylinder head gasket, leading to a major repair. For older cars, it's best to change the coolant every two years because old coolant is more corrosive and can easily cause component wear. Now, every time I wash the car, I check the cooling system: after starting the engine, I observe the pipe connections and expansion tank for any drips or leaks, and keep the fluid level between max and min. Delaying repairs could cost thousands, so it's better to be careful.
Was this review help?
1
4
Share
Expand All
More Forum Discussions

Will crossing the line at a traffic light intersection result in penalty points?

Normally, crossing the solid white line at a traffic light intersection will result in a 3-point penalty if caught by electronic police or traffic officers on site. Here are some additional details: 1. Under special circumstances, lane changing over the line is allowed if it does not affect other vehicles, but evidence should be preserved to apply for administrative reconsideration to cancel the penalty later. 2. If a traffic accident occurs due to crossing the solid line at a traffic light, full responsibility may be taken depending on the situation. Additional information: At intersections without traffic lights, do not blindly proceed. If you think there are few vehicles at such intersections and you can pass quickly, once vehicles on the transverse lane also pass quickly, you may only realize it when you reach the middle of the road, which can easily lead to collisions and accidents.
14
2
Share

How to Solve the Issue of the Car Airbag Light Always Being On?

Solutions for the car airbag light being on are as follows: 1. The airbag light being on indicates a fault in the airbag system. Although it does not affect normal driving, the airbags may not deploy properly in the event of a collision. 2. It is recommended to visit a 4S shop for computer diagnosis and troubleshooting: Use a fault detector to perform a computer test on the airbag system and read the fault codes. Once the specific meanings of the relevant fault codes are identified, the fault range can be narrowed down for appropriate judgment. 3. In most cases, the issue is caused by short circuits or open circuits in the system wiring, and reconnecting the wiring properly can resolve the problem.
7
0
Share

What is the size of the Jimny wiper blades?

The driver's side is 24 inches, and the passenger side is 22 inches. It is a special frameless wiper with a dedicated connector. The frameless wiper eliminates the traditional metal frame and uses a built-in steel strip to distribute pressure evenly. Below is relevant information about car wipers: The windshield wiper (WINDSHIELD WIPER) is a blade structure installed in front of the windshield, composed of a motor, reducer, four-bar linkage, wiper arm spindle, and wiper blade assembly. Car wipers are used to clear raindrops from the glass surface during rainy weather, ensuring clear and unobstructed visibility for drivers. Driving safety is of utmost importance, and car wiper blades help reduce the risk of traffic accidents, ensuring safer travel.
1
3
Share

What is 101W on a tire?

Tire 101W represents the load index and speed rating of the tire. 101 indicates a maximum load capacity of 825kg, and W means the maximum speed should not exceed 270km/h. Speed rating: The speed rating refers to the maximum speed a tire can achieve under specified load and inflation pressure standards. Load index: The load index indicates the maximum load capacity of a single tire under specified conditions. Here is a partial introduction to tires: 1. Tires are classified by usage, including load-bearing tires, passenger car tires, and mining tires, among others. Load-bearing tires must not only have the size specifications marked on the sidewall but also indicate the ply rating. 2. The ply rating of load-bearing tires does not refer to the actual number of layers but rather to the load performance of tires made with high-strength material cords, which is equivalent to the number of cotton cord layers in tires made with cotton cords.
9
3
Share

What is the wheelbase of the XTS?

XTS has a wheelbase of 2837mm. Relevant information about the XTS is as follows: 1. In terms of body dimensions, the XTS measures 5103*1852*1502mm in length, width, and height, with a wheelbase of 2837mm. 2. In terms of exterior design, the front face of the car features a large-area grille and is adorned with chrome trim. The headlights adopt a family-style design, offering high recognition when illuminated at night. 3. Regarding the exterior, the side waistline design is very layered, with a three-dimensional waistline extending from the front face to the rear of the car, visually elongating the vehicle's body length. The side of the car is also decorated with chrome trim, further highlighting its sporty character.
20
4
Share

How to Put on a Car Cover?

Spread the car cover evenly from the front to the rear of the vehicle. First, secure the side ear positions of the cover to prevent it from slipping. Then, tighten the cover over the front and rear of the car. Throw the windproof strap under the cover to the other side of the car, then fasten the buckle on the opposite side of the vehicle. Thread the steel cable through the metal ring and throw it to the other side. Finally, lock the ring and cable with an anti-theft lock to complete the process. This method can avoid friction between the fabric and the car paint, utilize air for insulation, and to some extent, increase air circulation.
6
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.