What Causes a Nissan Trunk to Not Open?

What Happens If You Don't Change the Air Filter for 40,000 Kilometers?

Not changing the air filter for 40,000 kilometers will affect the engine's air intake, leading to sluggish acceleration. Consequences of not replacing the air filter in time: The air filter cannot effectively remove suspended particles from the air, causing accelerated engine wear and carbon buildup, shortening the engine's lifespan. In severe cases, it may even lead to "cylinder scoring," so regular replacement of the air filter is crucial. Here’s an introduction to car air filters: The typical replacement interval for an air filter is 10,000-20,000 kilometers, but this varies significantly depending on driving conditions. If the environment is poor, earlier replacement may be necessary. Whether an air filter can last 30,000-40,000 kilometers depends on its condition, but it’s best not to exceed the recommended replacement period. Always replace it within the specified timeframe. When installing a new air filter, ensure the correct orientation—there is a raised plastic tab on the lower right side to prevent incorrect installation. To install the air filter properly, the plastic tab must be secured into the filter housing's slot.

13

2

Share

What Does Factory Defect Mean?

Factory defect refers to minor issues in the appearance or non-critical parts of the vehicle that do not affect its normal performance. Here are some precautions to consider when picking up a new car: Inspect the car body for any scratches or wear on the paint. It's best to check for color differences under ample sunlight. Examine the vehicle's identification plate, which is usually located on the driver's side door or in the engine compartment, and pay attention to the manufacturing date. Body defects not covered under the three-guarantee policy: During the three-guarantee period, if the cumulative repair time exceeds 35 days; if the same quality issue requires more than five repairs; if there are two repairs for serious safety faults; within 60 days from the purchase date or within 3,000 kilometers of driving, if the steering system fails, the braking system fails, the body cracks (note: the body, not the paint surface), or there is fuel leakage.

16

0

Share

What do the terms dry boiling point and wet boiling point of brake fluid mean?

Brake fluid dry boiling point refers to the boiling point when the fluid is freshly added to the brake system from a sealed container; wet boiling point indicates the boiling point after 2 years of use when the fluid contains 3.5% water. Below are precautions for brake fluid usage: 1. Do not mix: Avoid mixing different types or brands of brake fluid. Due to differing formulations, mixing can degrade the fluid's performance indicators. 2. Moisture or contaminant absorption: When brake fluid absorbs water or contains impurities, it should be promptly replaced or filtered, otherwise it may lead to insufficient braking pressure and affect braking performance. 3. Replacement: For vehicles driven normally for 40,000 km or when brake fluid has been in continuous use for over 2 years, the fluid is prone to deterioration due to prolonged use and should be replaced promptly.

20

2

Share

Is a License Replacement Required for Annual Vehicle Inspection?

Annual vehicle inspection does not require license replacement. Annual inspection refers to the yearly examination of vehicles that have already obtained official license plates and registration certificates, conducted in accordance with the 'Technical Conditions for Motor Vehicle Operation Safety.' Overview of Vehicle Annual Inspection: Vehicle annual inspection refers to the yearly examination of vehicles that have already obtained official license plates and registration certificates, conducted in accordance with the 'Technical Conditions for Motor Vehicle Operation Safety.' The purpose is to check the main technical conditions of the vehicle, encourage enhanced maintenance, ensure the vehicle remains in good condition, and guarantee driving safety. Timing of Vehicle Annual Inspection: For passenger vehicles used for commercial purposes, inspections are conducted once a year within the first 5 years. After 5 years, inspections are conducted every 6 months. For cargo vehicles and large or medium-sized non-commercial passenger vehicles, inspections are conducted once a year within the first 10 years. After 10 years, inspections are conducted every 6 months. Vehicle annual inspections are categorized into initial inspections and regular inspections.

3

4

Share

Which lane should I take for a left turn on a three-lane road?

When making a left turn on a three-lane road, you should enter the leftmost lane. Typically, the rightmost lane is designated for right turns, the middle lane for going straight, and the leftmost lane for left turns. Therefore, when turning left on a three-lane road, you should use the leftmost lane. The relevant regulations from the "Implementation Regulations of the Road Traffic Safety Law of the People's Republic of China" are as follows: 1. Article 51: At intersections with designated lanes, enter the appropriate lane based on your intended direction. Vehicles preparing to enter a roundabout must yield to vehicles already inside the roundabout. When turning left, stay to the left of the center of the intersection, use your turn signal, and at night, drive with low beams on. 2. Article 52: At intersections with traffic signs or markings, yield to the party with the right of way. At intersections without traffic signs or markings, stop before entering to observe and yield to vehicles coming from the right. Turning vehicles must yield to vehicles going straight, and right-turning vehicles from the opposite direction must yield to left-turning vehicles.

2

1

Share

Can I switch from manual to automatic transmission after passing Subject 1?

If you have registered for a manual transmission driver's license test (C1) and have already passed Subject 1, you cannot switch to an automatic transmission driver's license test (C2). Before taking the Subject 1 test, you can negotiate with the driving school to change the relevant procedures and pay the additional fees to switch your registration to an automatic transmission driver's license test (C2). The process for the Subject 1 test is as follows: First, follow the instructions of the staff to collect your driving training file in order at the waiting area; carry and present your ID card for inspection by the supervising officer. Please note that you must turn off your mobile phone when entering the test area, no loud noise is allowed, and the regulation textbooks are not allowed to be brought into the test area (or put in your bag). After the test, keep your ID card safe and submit the file to the "Document Submission Window" at the front of the test area. Candidates who pass the test will sign under the guidance of the staff at the exit of the test area and then leave. Candidates who fail the test can leave the test area immediately and wait for the driving school staff to notify them of the retake time.

20

0

Share

What Causes a Nissan Trunk to Not Open?

What Happens If You Don't Change the Air Filter for 40,000 Kilometers?

What Does Factory Defect Mean?

What do the terms dry boiling point and wet boiling point of brake fluid mean?

Is a License Replacement Required for Annual Vehicle Inspection?

Which lane should I take for a left turn on a three-lane road?

Can I switch from manual to automatic transmission after passing Subject 1?

Why won't the daytime running lights turn on?

What does Shouqi binding order mean?

Can Expired Brake Fluid Be Used?

Test Drive: Do You Drive Yourself or Someone Else Drives?