What Causes a Motorcycle to Fail to Start After Sitting for Two Years?

Which gear should a manual transmission car be in when parking downhill?

When parking downhill with a manual transmission, engage the reverse gear to prevent the car from sliding forward. When starting, first depress the clutch, shift to neutral, start the engine, and then shift to the starting gear. The steps for starting a manual transmission car are: 1. Sit properly in the driver's seat; 2. Start the car; 3. Depress the clutch; 4. Engage first gear; 5. Slowly release the clutch; 6. Gently press the accelerator; 7. Fully release the clutch to complete the starting process. The reasons for a manual transmission car stalling after ignition include: 1. Using substandard or poor-quality fuel; 2. Issues with the car's engine or fuel system; 3. Engine carbon buildup; 4. Excessive dirt on the idle motor valve core and throttle body; 5. Releasing the clutch too quickly when starting.

10

2

Share

Where is the air intake of a sedan located and what is its wading depth?

The air intake of a sedan is generally located in the engine compartment. The safe wading depth is the distance of the vehicle's ground clearance. Below are relevant details: 1. Exhaust pipe: When water reaches half the height of the wheel, it can basically enter the exhaust pipe, but it will not damage the three-way catalytic converter; therefore, half the height of the wheel is widely recognized as a relatively safe wading depth. 2. Air intake: The air intake of the A4L is located on the support crossbeam under the engine hood, with the opening facing forward and horizontally. The pipe connecting the air intake to the air filter has a certain curvature. If water briefly enters the air intake, it will not immediately flow into the air filter. As long as the air filter remains dry, the engine will not stall.

10

2

Share

Is 10L/100km Fuel Consumption High?

This depends on the type of vehicle and the engine used. If it's a compact family car with a small-displacement naturally aspirated engine, this fuel consumption would be considered high. However, for a mid-to-large SUV equipped with a large-displacement naturally aspirated or turbocharged engine, this fuel consumption is not considered high. Specific details are as follows: 1. Factors affecting fuel consumption: Generally, the larger the displacement, the higher the fuel consumption. However, there is no direct conversion formula between the two, as many factors influence fuel consumption, not just the engine's powertrain but also the transmission, drag coefficient, vehicle weight, and tires. Additionally, driving habits, vehicle condition, and road conditions play significant roles. 2. Reducing vehicle weight: Vehicle weight is directly proportional to fuel consumption. It is said that a 10% reduction in vehicle weight can lead to a corresponding reduction in fuel consumption by several percentage points.

19

1

Share

What is the ground clearance of the BMW 325im Sport Night Edition?

The minimum ground clearance of the BMW 325im Sport Night Edition is 138mm. Here is additional information: 1. Vehicle dimensions: The length, width, and height are 4719*1827*1459mm respectively, with a wheelbase of 2851mm (2961mm for the long-wheelbase version). 2. Powertrain: Equipped with a 2.0T turbocharged engine, delivering a maximum power of 184 horsepower, paired with an 8-speed automatic transmission. 3. Features: Includes front and rear parking sensors, 360-degree panoramic camera, cruise control, driving mode selection, auto hold, hill start assist, electric sunroof, keyless start, paddle shifters, 12.3-inch full LCD instrument cluster, 10.25-inch central control screen, GPS navigation, car connectivity, and voice recognition control system.

18

0

Share

What Are the Gear and Speed Standards?

Here is an introduction to the corresponding speeds for each gear in a manual transmission: 1. Start with 1st gear: The economical speed for 1st gear is 15-20 km/h. When driving continuously uphill, use a lower gear, such as 1st or 2nd gear, to ensure sufficient power for the vehicle. 2. 2nd gear: The economical speed is 25-40 km/h. When driving continuously downhill, use a lower gear, such as 2nd or 3rd gear, to ensure the vehicle does not go too fast. This reduces the need for prolonged braking and protects the brake pads. 3. 3rd gear: The economical speed is 40-60 km/h. 4. 4th gear: The economical speed is 60-75 km/h. 5. 5th gear: The economical speed is above 75 km/h.

3

0

Share

What is the significance of engine oil grades?

The significance of engine oil grades is to indicate the viscosity and quality of the oil. The functions of engine oil include: lubrication and anti-wear, auxiliary cooling, cleaning, sealing and leak prevention, rust and corrosion prevention, and shock absorption. Engine oil can be classified into: 1. Conventional mineral oil; 2. Semi-synthetic oil; 3. Full synthetic oil. The method for changing engine oil is: 1. Lift the vehicle, remove the undercover, and place a container of about 10 liters under the oil drain plug; 2. Loosen the oil drain plug, use an air gun to blow for two minutes at the oil filler port, tighten the oil drain plug after draining, and wipe it with a tissue to check for leaks; 3. Reinstall the undercover and lower the vehicle, then use a funnel to add oil through the filler port.

16

3

Share

What Causes a Motorcycle to Fail to Start After Sitting for Two Years?

Which gear should a manual transmission car be in when parking downhill?

Where is the air intake of a sedan located and what is its wading depth?

Is 10L/100km Fuel Consumption High?

What is the ground clearance of the BMW 325im Sport Night Edition?

What Are the Gear and Speed Standards?

What is the significance of engine oil grades?

Where is the car's signal booster slot located?

How many meters of reversing on the highway will result in penalty points?

Can the car be locked with the power on?

Is There a Relationship Between Urea and Fuel Consumption?