What Causes a Car to Suddenly Stall While Running?

1 Answers
DeDylan
07/29/25 11:04pm
The reasons for a car suddenly stalling while running include: 1. Short circuit in the low-voltage circuit; 2. Damage to the fuel pump or rupture of the fuel line; 3. Clogging at the carburetor fuel inlet or an empty fuel tank; 4. Sensor malfunction; 5. Disruption in the engine timing system; 6. Issues with the engine overheating and anti-explosion system; 7. Faults in the ignition coil and electrical components. Solutions for a car suddenly stalling while running: 1. Check the engine oil lubrication; 2. Inspect if the carburetor vent pipe is blocked; 3. Examine whether the trigger coil has a short circuit at high temperatures; 4. Check for damage, looseness, or compression in the negative pressure tube and fuel line of the fuel system.
Was this review help?
3
2
Share
More Forum Discussions

Can You Drive with Only a Driver's License and No Vehicle License?

You cannot drive with only a driver's license and no vehicle license. Below is an introduction to obtaining a vehicle license: Process for obtaining a vehicle license: Currently, replacing a vehicle license no longer requires providing vehicle photos. Only the owner's identity information is needed. After scanning and reading the owner's ID card, staff can complete online verification, review, and other procedures for the owner's identity and vehicle information through the integrated service platform, eliminating the need to drive to the site for verification and photography. Points to note when obtaining a vehicle license: It is important to note that once an online application for replacement or renewal of a vehicle license is submitted successfully, it cannot be canceled. Replacing a lost vehicle license does not require providing the original damaged vehicle license, whereas renewing a vehicle license requires submitting the original damaged license. Mailing is two-way, and the cost is doubled.
6
0
Share

Symptoms of Motorcycle Clutch Wear

Here is a detailed introduction to the symptoms of motorcycle clutch wear: Starter motor freewheeling: If the overrunning clutch is damaged, because the driving force cannot be transmitted to the engine crankshaft, the electric starting system will experience a freewheeling phenomenon. Engine not moving: If the overrunning clutch is damaged and stuck, it will cause the engine to fail to rotate normally, mainly because the overrunning clutch cannot disengage. Here is some additional information: The clutch plate is the medium that transmits engine power to the gearbox. Similar to brake pads, the friction material of clutch plates is mainly made of asbestos-based material, which has certain high-temperature resistance. During vehicle operation, when the clutch pedal is depressed, the clutch plate separates from the engine flywheel. When the pedal is released, the clutch plate engages with the engine flywheel, allowing the engine power to match the driving speed.
4
2
Share

Is it permissible to reverse when there's insufficient space for a U-turn at an intersection?

Reversing is allowed when a U-turn cannot be completed. The U-turn should be initiated at the position of the foremost line. In terms of right-of-way, reversing vehicles have the lowest priority and must yield to any vehicles approaching from behind. Precautions for reversing: Reversing is more challenging than forward driving, primarily due to limited visibility, making it difficult to clearly see the road and obstacles behind. Additionally, during reversing, the rear wheels become the leading wheels, and the front wheels become the trailing wheels, altering the subjective perception and the control points for steering. Consequently, reversing maneuvers may feel less intuitive, convenient, flexible, and precise compared to driving forward. When reversing, always check for oncoming vehicles and pedestrians in front and behind, signal your intention to reverse, and sound the horn to alert other vehicles and pedestrians. Maintain a steady pressure on the accelerator pedal, keeping the speed below 5 km/h, and avoid sudden speed changes to prevent stalling or dangerous situations caused by excessive reversing force. Continuously monitor your progress through the rear windshield and mirrors, and adjust the steering as needed to prevent scraping the front or rear of the vehicle.
19
1
Share

What is the Driving Stick?

Here is an introduction about the driving stick: Display average fuel consumption: When the small black stick on the dashboard is pressed, the small LCD screen on the dashboard will show L/100km, which is the vehicle's average fuel consumption. After resetting to zero, it records the fuel consumption generated during driving. After each refueling, you can press this driving stick to record the average fuel consumption after refueling, eliminating the need for manual recording. Display average speed: When the driving stick is pressed once, it usually shows the vehicle's average fuel consumption, but when pressed again, it switches to display the vehicle's average speed. The real-time speed of the vehicle can generally be displayed through the speedometer to determine if you are speeding. This function is mainly used in interval tests to record your average speed and avoid speeding. Display remaining range: If the driving stick is pressed a third time, the information on the dashboard will switch to display "remaining range," allowing the vehicle system to accurately determine the remaining fuel and how much distance can be covered.
13
2
Share

What Are the Hazards of Pure Electric Vehicles Encountering Water Accumulation?

The following are the hazards of pure electric vehicles encountering water accumulation: Being trapped in the vehicle: The biggest problem for electric vehicles encountering storms and water accumulation is not the issue of electric leakage, but the greatest possibility is that the interior gets soaked, or the driver gets trapped inside the vehicle and cannot get out. Additionally, although the vehicle's battery pack outputs high-voltage direct current of 300 to 600V, current electric vehicles are generally equipped with insulation and electric leakage detection functions. If high-voltage components experience leakage, the management system will directly cut off the voltage output from the battery box. Therefore, the possibility of being 'electrocuted' is relatively small. Component damage: Electric vehicles do not have intake components and all electrical parts are waterproofed. However, land vehicles still need to avoid wading through water because the vehicle frame cannot be completely sealed. Vehicle frames generally have some hollow components with openings, which can accumulate water. After water accumulation, it can corrode the steel. Moreover, the composition of water accumulation on ordinary roads is relatively complex, which may have a corrosive effect on waterproof components, or sand and other hard particles in the water may enter moving parts and scratch them.
1
1
Share

What is the difference between adding a D license and taking the test directly?

The difference between adding a license and initial learning is that some subject items can be reduced. The difference between adding a B2 license with a C1 license and taking the test directly is that the start dates are different. The initial issuance date and the effective start date of the B2 driver's license are the same day. If it is an added license, the initial issuance date and the effective start date will not be the same day. The probation restrictions are different. After successfully adding a B2 license with a C1 license, driving a minibus during the probation period is not restricted by the probation period. A directly applied B2 license is subject to probation restrictions for any vehicle. The scoring cycle is different. Adding a B2 license requires meeting the condition of no 12-point record in the previous scoring cycle and the current scoring cycle, while directly applying for a B2 license does not have this restriction. The application age is different. The minimum age to apply for a C1 test is 18 years old, while the minimum age to apply for a B2 test is 21 years old. B2 requires the applicant to be at least 21 years old. The fees for adding a license and initial learning are the same. It takes at least three years to add a B2 license with a C1 license.
15
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.