What Causes a Car to Pull to the Right While Driving?

1 Answers
DeHenry
07/30/25 1:11am
When a vehicle pulls to the right while driving, it could be due to tire issues or alignment data problems. The specific reasons are analyzed as follows: Tire Issues: A significant difference in tire pressure between the left and right tires can cause the car to pull toward the side with lower tire pressure. Uneven tire wear on both sides can also cause the vehicle to pull toward the side with shallower tread. Alignment Data Problems: Incorrect alignment data can also lead to pulling. The vehicle tends to pull toward the side with a larger camber angle or toward the side with a smaller caster angle. Vehicle pulling is not an overly severe or complex issue; it mainly occurs due to imbalances between the left and right sides. When such a problem arises, it is necessary to adjust the car properly to avoid further safety hazards.
Was this review help?
17
0
Share
More Forum Discussions

What are the solutions for multiple warning lights on the Roewe eRX5?

When multiple warning lights appear on the Roewe eRX5, a diagnostic computer should be used to read the fault codes to identify the specific cause and faulty components, enabling targeted repairs. Introduction to the Roewe eRX5: 1. Exterior: The Roewe eRX5 adopts the same "Rhythm" design concept as the RX5, featuring an integrated large grille design at the front. As the Roewe eRX5 is a plug-in hybrid, a charging port has been added to the right side of the vehicle. The only difference at the rear is that the exhaust pipe has been changed to a hidden design. 2. Powertrain: The Roewe eRX5 is equipped with a plug-in hybrid system consisting of a 1.5T engine and a permanent magnet synchronous motor. The engine has a maximum power output of 119kW and a peak torque of 250 Nm. Combined, the entire powertrain system can achieve a peak torque of 704 Nm.
3
3
Share

What are the reasons why the Audi A6L door cannot be opened?

Audi A6L door may not open due to remote control failure; unresponsive buttons; low battery; environmental factors such as strong signal interference or shielding; anti-theft system malfunction; or the need for remote control re-encryption matching. Replacing the remote control battery or the remote control itself can resolve the issue. Avoid slamming the door: Frequently slamming the car door can cause severe paint peeling around the door, accelerate the aging of the car's system functions, and lead to wiring detachment, resulting in gradually less flexible seats. Secure the child safety lock: Children are naturally active and curious. If they pull the door handle and open the door during the ride, it can be extremely dangerous. When there are children in the car, parents must ensure the safety lock is engaged.
10
1
Share

What are the differences between the Vios and Yaris?

The main differences between the Vios and Yaris lie in the chassis, braking system, and maintenance costs, while other aspects such as power are largely similar. The Vios was developed specifically for the Southeast Asian market, whereas the Yaris is a global model with a smaller body size. The later Yaris L (Zhixuan) is essentially a hatchback version derived from the Vios. Differences in chassis: The Yaris L (Zhixuan) feels more solid and tighter, while the Vios is slightly looser. Differences in braking: The braking of the Yaris L (Zhixuan) is not very linear and can feel a bit abrupt, whereas the Vios offers a more linear braking experience. Differences in maintenance: Maintenance costs at GAC Toyota are higher than those at FAW Toyota, with a noticeable difference in the cost of minor services.
7
2
Share

What causes a Jetta to lack engine oil?

Jetta lacks engine oil due to reasons such as aging valve stem seals, piston ring issues, excessive wear, and sticking problems. Aging valve stem seals: Rubber loses elasticity, causing poor sealing, allowing engine oil to seep into the combustion chamber and burn. Piston ring issues: Excessive clearance between piston rings and cylinder walls, improper piston ring installation, or degraded sealing performance, weakening the oil ring's oil scraping function. Excessive wear: Excessive wear gap between the guide and valve stem, causing oil droplets from the valve cover to enter the combustion chamber along the gap during driving. Sticking problems: The crankcase ventilation valve sticks and cannot move, losing its function of controlling ventilation volume. Excessive oil vapor in the crankcase then enters the intake pipe through the crankcase ventilation tube.
20
3
Share

What engine does the Malibu XL use?

The Malibu XL offers two models, equipped with a 1.3T turbocharged engine and a 2.0T turbocharged engine respectively. Here are the details: 1. In terms of power, the 1.3T engine delivers a maximum power of 121 kW and a maximum torque of 240 Nm, while the 2.0T engine provides a maximum power of 177 kW and a maximum torque of 350 Nm. 2. For transmission, the 1.3T model is paired with a CVT continuously variable transmission, and the 2.0T model is matched with a 9-speed automatic manual transmission. 3. Regarding the interior, the Malibu XL features extensive use of soft materials and chrome decorations, offering a refined and upscale feel. It comes standard with an 8-inch central control screen, and higher-end models are equipped with an 8-inch LCD instrument panel, emphasizing simplicity and practicality in the interior design.
18
0
Share

Components and Functions of the Cooling System

Components and Functions of the Cooling System are as follows: I. Components of the Cooling System: The cooling system consists of the thermostat, water pump, water pump belt, radiator, cooling fan, water temperature sensor, liquid storage tank, heating device, expansion tank, water jackets in the engine block and cylinder head, etc. II. Functions of the Cooling System are as follows: 1. Adjust the cooling intensity in real-time based on the engine's load, speed, and temperature changes. 2. Provide different cooling intensities for different working parts of the engine. 3. Dissipate the heat generated during engine operation into the air and ensure the engine operates within an appropriate temperature range. The cooling system must prevent both engine overheating and excessive cooling during winter. After a cold start, the cooling system also ensures the engine warms up quickly to reach the normal operating temperature as soon as possible.
6
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.