What Causes a Car to Keep Stalling?

1 Answers
DelJack
07/30/25 12:05am
The reasons why a car keeps stalling are: 1. Short circuit in low-voltage lines; 2. Damaged fuel pump or ruptured fuel line; 3. Clogged carburetor fuel inlet or empty fuel tank; 4. Faulty sensors; 5. Disordered engine timing system; 6. Issues with the engine overheating and anti-explosion system; 7. Faulty ignition coil or electrical components. Solutions for a car that keeps stalling include: 1. Check the engine oil lubrication; 2. Inspect if the carburetor vent pipe is blocked; 3. Check if the trigger coil has a short circuit at high temperatures; 4. Examine the negative pressure tube and fuel line for damage, looseness, or compression.
Was this review help?
2
4
Share
More Forum Discussions

Do You Need to Press the Clutch When Applying the Handbrake?

Applying the handbrake does not require pressing the clutch. The handbrake, also known as the parking brake, functions to provide resistance to the car when parked, preventing it from rolling. The parking brake, whether it's a handbrake or the parking gear in an automatic transmission, locks the drive shaft or rear wheels. Its braking force is much weaker compared to the service brake, just enough to prevent the car from rolling on a slope. Parking brakes come in different types, including mechanical systems operated by hand or foot, as well as electronically controlled parking systems, commonly known as electronic parking brakes. An electronic parking brake integrates the temporary braking function during driving with the long-term braking function after parking, and it achieves parking braking through electronic control technology.
11
1
Share

Can You Keep Driving When the Car Radiator Boils Over?

You should not continue driving when the car radiator boils over. Upon noticing the boiling, first pull over to the side of the road but do not immediately turn off the engine. There are various reasons that can cause a car radiator to boil over, though typically only one specific issue is at play each time. If you shut down all other functions, the water temperature may remain excessively high, potentially damaging the engine. The correct approach is to idle the engine, open the hood, turn on the heater to dissipate heat as quickly as possible, and ensure the car is parked in a shaded area. Next, the owner should check if the coolant level is sufficient. This situation often arises from the owner neglecting to top up the coolant regularly. It is crucial to use the same brand and model of coolant when refilling, as mixing different types may cause chemical reactions that render the antifreeze ineffective. Additionally, a coolant leak could be the reason for the low level. In such cases, the owner should thoroughly inspect for any leaks and have them repaired promptly.
11
1
Share

How to Open the Trunk of a Mercedes-Benz E300?

There are two methods to open the trunk of a Mercedes-Benz E300: 1. Press and hold the trunk button on the car key to open it; 2. The owner can find the trunk release button in front of the door storage compartment. The Mercedes-Benz E-Class is a mid-to-large-sized high-end business sedan, coupe, and station wagon developed by Mercedes-Benz, positioned between the C-Class and S-Class. The E300 is equipped with a 2.0T turbocharged engine, delivering a maximum power of 245 horsepower and a peak torque of 370 Nm, paired with a 9-speed automatic transmission. In terms of dimensions, the E300 measures 4947mm in length, 1850mm in width, and 1470mm in height, with a wheelbase of 2939mm.
5
1
Share

How to Remove a Car Tire?

The method to remove a car tire: 1. The car owner needs to prepare all the tools and equipment required for the entire process of removing the car tire, including a tire wrench, small hook, jack, etc.; 2. Take out the small hook, hook it into the hole of the screw cap, and then pull it outward to remove the screw cap; 3. Take out the tire wrench, place the specialized tire wrench on the screw, and turn it counterclockwise to loosen all the screws; 4. Take out the jack, locate the support point of the reinforcement on the car chassis, and then use the jack to lift the vehicle; 5. Take out the tire wrench again, remove the previously loosened screws that secure the tire, and then the car tire can be taken off.
16
3
Share

Where are the airbag locations in the Macan?

The airbag locations in the Macan are primarily distributed in three areas: the front of the vehicle (driver and front passenger seats), the sides (front and rear rows), and the roof. These locations are marked with SRS or Airbag labels externally. Many positions in the car are labeled with 'Airbag' or 'SRS,' both of which indicate the presence of airbags. The airbag system is a passive safety protection system that, when used in conjunction with seat belts, provides effective collision protection for occupants. In the event of a car collision, the airbags can reduce head injuries by 25% and facial injuries by approximately 80%.
5
4
Share

What is the correct way to use the one-button start in Volkswagen Sagitar?

Volkswagen Sagitar one-button start correct usage is: First press the start button, after the ACC light turns on, press the start button again, at this time the one-button start will turn green indicating vehicle self-check; After the vehicle completes self-check, depress the brake pedal and press the one-button start once more to start the engine. The Sagitar series is equipped with three engine options: 1.4TSI, 1.8TSI and 1.6L naturally aspirated, providing consumers with more choices. The Sagitar is a spacious A+ class comfort sedan featuring a mature 1.6L naturally aspirated 4-cylinder engine technology with 4 valves per cylinder. Compared to the previous generation's 2 valves per cylinder, this configuration improves both intake and exhaust flow, enhancing low-speed torque and high-speed power output.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.