What Causes a Car's Air Conditioning Compressor to Stop Working?

1 Answers
GeorgeLynn
07/29/25 1:59pm
The following are the reasons why a car's air conditioning compressor may stop working: 1. Severe internal wear of the compressor: It's important to understand that the compressor plays a crucial role in the air conditioning system, primarily responsible for compressing and delivering refrigerant. This results in the compressor operating at high speeds for extended periods, which is one of the reasons it may fail to function properly. 2. Lack of refrigerant in the car's air conditioning system: The compressor is used to compress and deliver refrigerant, so check for any leaks in the refrigerant. 3. Electrical system failure: A fault in the electrical system can prevent the car's air conditioning compressor from working correctly. Inspect the circuit for continuity and check the temperature sensor solenoid valve.
Was this review help?
5
3
Share
More Forum Discussions

Precautions for Novice Drivers on Highways

Precautions for novice drivers on highways are as follows: Maintain a steady speed while driving: After passing the highway toll station, first drive on the acceleration lane and observe whether there are vehicles approaching from behind. Enter the main lane without affecting the normal traffic in the left lane. Maintain a steady speed and avoid getting too close to the vehicle in front. Refer to the distance markers to keep a reasonable gap. Generally, if the speed is 100Km/h, the distance should be 100m. Stay in one lane as much as possible: Avoid frequent lane changes on the highway, and do not suddenly decelerate or stop without warning in the driving lane. Do not drive side by side with other vehicles, stay in the overtaking lane for too long, or attempt to overtake from the emergency lane. Additionally, prepare in advance when exiting or merging lanes. Slow down and move to the right lane or deceleration lane 500m before the exit or merging point. Avoid sudden lane changes or emergency braking after passing the exit. Be decisive when overtaking: When deciding to overtake, check if there are vehicles approaching from the left rear and ensure there are no obstacles in the overtaking lane. Use the horn or lights to alert the vehicle being overtaken, especially when passing trucks or buses, and accelerate decisively. After overtaking, do not immediately return to the driving lane. Wait until you are 50m-100m away from the overtaken vehicle before signaling and returning to the lane. Exercise caution when driving at night: Use high beams when driving on the highway at night and pay attention to the taillights of vehicles ahead. Avoid driving while fatigued. In case of heavy fog at night, slow down and turn on the hazard lights. Overcome adverse weather conditions: Visibility is poorer in rainy weather, increasing the risk of accidents on highways. Slow down and watch for standing water on the road to prevent hydroplaning and loss of control. Avoid sudden braking and sharp steering. Maintain a distance twice as long as in clear weather. Use necessary warnings when stopping: If you need to stop temporarily due to a malfunction, turn on the right turn signal in advance to exit the driving lane and stop in the emergency lane or on the right shoulder. Never stop in the driving lane. Turn on the hazard lights and place a warning sign 150m behind the vehicle. Additionally: According to Article 64, Paragraph 1 of "Regulation No. 123," the first 12 months after a driver obtains a new license or adds a new vehicle category is considered the probationary period (i.e., 12 months from the "initial license date" on the license). If the probationary period is extended, it becomes 24 months from the "initial license date." Article 65, Paragraph 2 of "Regulation No. 123" states that a probationary driver must be accompanied by a driver with a corresponding or higher-level license held for at least three years when driving on highways. Failure to comply will result in fines.
16
3
Share

Where is the handbrake of BMW X1?

The BMW X1 is equipped with an electronic handbrake, which is located next to the gear lever. The electronic handbrake is mainly used for long-term braking after parking, similar to the traditional mechanical handbrake. The electronic handbrake is also known as the Electronic Parking Brake (EPB), and its button symbol in the vehicle is 'P'. Here is an introduction to the electronic handbrake: 1. The working principle of the electronic handbrake is the same as that of the traditional mechanical handbrake, both achieving parking brake control through the friction generated between the brake disc and the brake pads, except that the control method has changed from the previous mechanical handbrake to an electronic button. 2. The structural principle of the electronic handbrake: Currently, the electronic parking brake technology applied in cars is mainly the caliper-integrated electronic parking brake system, which replaces traditional parking brake handles, mechanical levers, and cables with electronic buttons and motor components. 3. When parking, after the driver operates the electronic button of the electronic parking brake system, the electronic control unit will control the motor integrated in the left and right brake calipers to act, driving the brake caliper piston to rotate and generate mechanical clamping force to complete the parking.
6
3
Share

What are the reasons for the engine fault light to illuminate?

There are several reasons why the engine fault light may illuminate: 1. Poor engine combustion state: Oxygen sensors are installed on the engine to monitor the combustion state. If the combustion state is poor, not only will the fault light illuminate, but it will also lead to fuel wastage and excessive engine wear. 2. Dirty engine cylinders with carbon deposits: Over time, carbon deposits inevitably accumulate inside the engine. These deposits can alter the engine's design parameters and, due to their unstable nature and heat retention, can cause irregular ignition, leading to engine knocking.
12
3
Share

What are the units of horsepower?

Horsepower typically uses watts (W) or kilowatts (kW) as standard units. Here are the specific details: 1. Horsepower is a commonly used unit for measuring power in engineering technology, proposed by James Watt. 2. One metric horsepower equals the work of completing 75 kilogram-force meters in one second, also equivalent to 0.735 kilowatts, or known as metric horsepower. One imperial horsepower equals 550 foot-pounds per second, equivalent to 76 kilogram-force meters per second, or 0.746 kilowatts. 3. Applicable fields: automotive industry, internal combustion engines, air conditioning.
6
4
Share

What are the differences between the Volkswagen Multivan and Caravelle?

The differences between the Multivan and Caravelle are as follows: 1. Price: The Volkswagen Multivan is Volkswagen's first MPV model, with an official guide price ranging from 382,000 to 515,900 yuan, while the Caravelle's official guide price ranges from 355,000 to 382,000 yuan. From these prices, it can be seen that the Multivan is positioned relatively higher. 2. Exterior: The most notable feature of these two vehicles is their boxy design. Both retain the family-style design in their overall shape, featuring a flat front grille. It's worth mentioning that the Caravelle has a larger front grille area, visually extending the width of the front end. 3. Seating layout and configuration: There are some differences in seating layout and configuration between the Volkswagen Multivan and Caravelle. Both the Multivan and Caravelle are imported MPVs under the Volkswagen brand, and it's still quite difficult to distinguish them based solely on their exterior appearance.
11
0
Share

What is the function of a car steering gear?

The car steering gear is an important component of the car steering system. The function of the car steering system is to control the driving direction of the car according to the driver's intention. The following is an introduction to the car steering system: 1. Classification: It is divided into two categories: mechanical steering system and power steering system. 2. Composition: The car's steering system is generally composed of a steering gear and a steering transmission mechanism. The steering gear is composed of main components such as the steering wheel, steering shaft, steering worm, and sector gear. The steering transmission mechanism includes components such as the steering rocker arm, steering longitudinal tie rod, steering knuckle arm, left and right steering trapezoidal arms, and steering cross tie rod.
7
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.