What car is featured in the drama 'We All Have to Be Good'?

1 Answers
MacMadeline
07/30/25 1:48am
The car featured in the drama 'We All Have to Be Good' is the Citroën DS5. Brand Introduction: The Citroën DS5 is a model launched by the French PSA Peugeot Citroën in 2011. It is a high-end large two-box model that emphasizes design aesthetics. Citroën showcased it independently during the 2011 Shanghai Auto Show. Model Introduction: The Citroën DS5 primarily features a 1.6T turbocharged gasoline engine, available in two different power outputs: 160 horsepower and 200 horsepower. Its exterior design resembles that of a concept car, with a stylish and eye-catching appearance. The interior is dynamic and fashionable, with a well-organized layout, rich and practical configurations, and a strong sense of technology.
Was this review help?
13
4
Share
More Forum Discussions

What Causes Unstable Idle Speed When Starting a Cold Engine?

Unstable idle speed when starting a cold engine can be caused by the following reasons: 1. Oil residue and carbon buildup in the throttle body, or a dirty intake manifold: Over time, the car's intake manifold can become clogged, and carbon deposits or oil in the throttle body can lead to unstable idle speed or even low idle. Carbon buildup in the throttle body affects the air intake, which can also cause low idle speed when starting a cold engine. 2. Weak spark due to faulty spark plugs: As spark plugs age, they can accumulate carbon deposits. Severe carbon buildup can cause weak sparks in some cylinders, affecting the car's performance and resulting in low idle speed. It is recommended to clean or replace the spark plugs promptly. 3. Faulty idle control valve: When the car's related sensors malfunction, the engine may not achieve the correct air-fuel ratio. Common issues include faulty coolant temperature sensors, oxygen sensors, or throttle position sensors, leading to high fuel consumption and low idle speed.
8
2
Share

How to Deal with Outer Edge Tire Wear on Front Wheels?

There are several solutions for outer edge tire wear on front wheels: 1. Adjust tire pressure to always maintain normal tire pressure. 2. Regularly perform wheel dynamic balance testing for the tires. If imbalance is found, balance lead weights should be installed. 3. Pay attention to tire maintenance and rotation. It's best to rotate the tires every 5,000 kilometers, preferably with diagonal swapping, to ensure even wear and extend lifespan. 4. Regularly visit professional repair shops for four-wheel alignment to ensure accurate vehicle alignment data, at least once a year. 5. Check whether wheel hub screws are loose, whether chassis components are deformed, and whether steel rims are deformed. 6. Avoid overloading and pay attention to tire load balance. Avoid parking the vehicle on uneven surfaces for extended periods.
20
3
Share

What to Do When Hydraulic Tappet Valves Malfunction?

When hydraulic tappet valves exhibit poor performance, performing a comprehensive cleaning and maintenance on the hydraulic tappets can usually resolve the issue. Generally, malfunctioning hydraulic tappet valves in vehicles can lead to abnormal noises. More details are as follows: 1. Hydraulic tappets are precision components in automobiles, characterized by their complex structure and high machining precision requirements. They are relatively rare in heavy-duty vehicles but more common in high-end sedans. 2. The use of hydraulic tappets in vehicles eliminates the need for adjusting valve clearances, reduces noise in the valve train during engine operation, and ensures that the valves remain tightly sealed. One end of the tappet contacts the camshaft, while the other end contacts the valve, transmitting the camshaft's thrust to the valve.
19
4
Share

How to Solve Black Smoke from Diesel Vehicles?

Solutions for black smoke from diesel vehicles are as follows: 1. Remove the air filter and observe the exhaust smoke color. If the black smoke condition improves, the issue is caused by severe contamination of the air filter. 2. Check if the fuel supply timing is too early; if so, adjust it. 3. During engine operation, conduct a cylinder-by-cylinder fuel cut-off test. When cutting off fuel to a specific cylinder, if the engine speed decreases, black smoke significantly reduces, and knocking sounds weaken or disappear, it indicates excessive fuel supply to that cylinder. If the engine speed changes little but the black smoke disappears, it suggests poor spray quality of the injector in that cylinder. After identifying the faulty cylinder, disassemble and inspect the injector. If necessary, replace it with a new injector for comparison. If the issue disappears with the new injector, it confirms a fault in the original injector.
2
5
Share

Can a car be registered under two names?

A car cannot be registered under two names; it can only have one owner. In the traffic management bureau's system, a vehicle must have a name, and it must be unique. The vehicle's registration certificate must also display the owner's name, which is likewise unique. When issues arise with the vehicle, such as accidents, hit-and-runs, or inquiries, there can only be one corresponding person—the owner named on the registration certificate. Legally, a vehicle as property can be jointly owned, but this is limited to property rights. In principle, as long as it is a legal marriage, the car is considered joint property regardless of whose name it is registered under. Therefore, the owner can only establish property rights through notarization for purely property-related purposes.
6
2
Share

What are the penalties for not driving in the designated lane?

Driving not in the designated lane will result in a deduction of 2 to 3 points and a fine. Motor vehicles passing through intersections controlled by traffic signals should follow the prescribed rules. At intersections with designated lanes, vehicles must enter the appropriate lane based on their intended direction of travel. On some road sections where turning or U-turns are not allowed and no signs are installed, yellow prohibition markings are painted on the lanes to warn drivers that turning or U-turns are not permitted on these sections. When approaching an intersection, pay attention to the directional markings on the road. If you intend to turn left, choose the leftmost lane; if you intend to turn right, choose the rightmost lane; for going straight, choose the middle lane. It is important to select the correct lane for your intended direction of travel in advance. If you accidentally choose the wrong lane and need to change lanes, do not force yourself to continue in the original direction. Instead, make a U-turn or detour ahead and then choose the correct lane to proceed.
7
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.