What car brand is the 'h' logo?

Where is the trunk switch of the Fit located?

The trunk switch of the Fit is located at the tailgate handle where you press to open it. Here is some related information about the Fit: Fit trunk dimensions: The Fit trunk dimensions are a long depth of 1450mm, short depth of 650mm, width of 1020mm, height of 690mm, with a capacity of 380-1323L. Basic configurations of the Fit: Equipped with Honda's new EDT engine, a 1.5L direct-injection DOHC i-VTEC engine, CVT continuously variable transmission, Idle-stop engine energy-saving automatic start-stop system, VSA vehicle stability control system, three-mode rearview camera display system, ESS emergency brake warning system, and HSA hill start assist system.

1

5

Share

How to Replace the Battery in a Cadillac Remote Key?

There are two screws on the back cover of the Cadillac remote key. Use a screwdriver to remove each screw, then open the back cover to access the battery compartment. Remove the old battery and install the new one. Finally, reattach the back cover and secure the screws. Introduction to the Cadillac XTS: 1. Body dimensions: Length, width, and height are 5131mm, 1852mm, and 1501mm respectively, with a wheelbase of 2837mm. 2. The XTS features a futuristic and stylish exterior, a bold and muscular body, luxurious interior, high-tech configurations, spacious cabin, powerful performance, comfortable handling, and excellent safety features.

16

2

Share

What Causes an Overly Rich Idle System Fault?

The causes and solutions for an overly rich idle system fault are as follows: Causes of an overly rich idle system fault: Air leakage in the intake pipe from the turbocharger to the throttle; Faulty air flow sensor; Faulty boost pressure sensor; Mechanical failure of the turbocharger; Wiring issues with the air flow meter or boost pressure sensor. Solutions for an overly rich idle system fault: An overly rich idle system manifests as the engine light turning on, stalling when starting, and sluggish throttle response when the engine is cold. P2188 indicates the system is too rich at idle, and clearing the fault code is necessary to resolve the issue. It is recommended to visit a 4S shop for specialized diagnostic and repair using dedicated equipment.

4

Share

Rearview Mirror Distance to the Following Vehicle?

Rearview mirrors are divided into the left exterior mirror and the right exterior mirror. The methods to judge the distance of the following vehicle are as follows: 1. Left exterior mirror: When the body of the following vehicle enters the left quarter of the mirror, the distance between the two vehicles is approximately 3 meters, which is considered a danger zone. When the following vehicle is in the middle of the left mirror, the distance is about 9 meters. When the following vehicle is positioned slightly to the right in the left mirror, the distance is roughly 20 meters. 2. Right exterior mirror: When the following vehicle occupies half of the mirror area, with only half of its body visible, the distance is very close, around 3 meters. When the following vehicle occupies half of the mirror area but the entire vehicle is visible, the distance is about 10 meters. When the following vehicle is in the middle of the mirror with the whole vehicle visible, the distance is approximately 20 meters.

10

3

Share

Is a 10V reading normal for a 12V car battery?

No, a 10V reading is not normal for a 12V car battery. Normal voltage range for car batteries: The battery voltage should measure between 11.8V-12.8V before starting the engine, and between 13.2V-14.8V after starting. During engine cranking, the voltage shouldn't drop below 11V to be considered normal. Regularly check your battery's condition - immediate charging is required when voltage falls below 10.8V. Battery maintenance tips: Keep the battery clean and dry, ensuring vent holes remain unobstructed. Clean any oxide buildup on terminals or clamps, then apply a thin layer of grease to prevent corrosion. Fully charged batteries shouldn't remain undercharged for extended periods; perform regular charging to avoid permanent damage.

18

0

Share

Precautions for Driving an Automatic Transmission Car

When driving an automatic transmission car, be careful not to engage the clutch halfway or shift into reverse before the car comes to a complete stop. Below are detailed explanations: Do not engage the clutch halfway: The clutch's function is to disconnect or connect the power to the engine. If you frequently engage it halfway, fuel consumption will inevitably increase because the engine performs a lot of unnecessary work. Additionally, the clutch will overheat, accelerating wear and reducing its lifespan. Unless in traffic jams, following other cars, or other special circumstances, avoid engaging the clutch halfway—simply keep your foot on the side. Do not shift into reverse before the car comes to a complete stop: Before the car stops completely, the gears are still in motion. Shifting into reverse before stopping can easily cause gear grinding, which can damage the transmission over time.

4

Share

What car brand is the 'h' logo?

Where is the trunk switch of the Fit located?

How to Replace the Battery in a Cadillac Remote Key?

What Causes an Overly Rich Idle System Fault?

Rearview Mirror Distance to the Following Vehicle?

Is a 10V reading normal for a 12V car battery?

Precautions for Driving an Automatic Transmission Car

Does a newly purchased used car need an annual inspection?

What are the effects of replacing a fuel pump?

What does a yellow TC light mean?

What are the National Environmental Protection Standards for Vehicles?