What brand of engine oil should be used for the Changan CS75?
1 Answers
When performing maintenance on the Changan CS75, it is sufficient to replace it with the original Changan SL-grade 5W-30 engine oil. The steps for adding engine oil to the Changan CS75 are as follows: 1. Run the engine until it reaches operating temperature. Then use a jack to lift the vehicle, engage the handbrake, and secure the front wheels with wooden wedges. 2. Place an old oil container under the oil pan, locate the oil pan drain plug, and slowly loosen it, being careful not to come into contact with the hot oil. Allow the oil to drain for a while. Check the drain plug and reinstall it, taking care not to overtighten it to prevent damage to the oil pan. 3. Move the oil container under the oil filter. Use an oil filter wrench to loosen the filter, then unscrew it by hand. If the filter is still hot, remember to wear gloves. Even if the filter was previously tightened very firmly, there is no need to worry about damaging it during removal, as long as the filter mounting interface screws and surrounding components are not damaged, since the removed filter will not be reused. 4. Apply some new engine oil to the gasket of the new filter. If the filter is installed vertically, you can pour some new oil into the filter to reduce dry friction during the next engine start. Hand-tighten the filter and then tighten it further as instructed (usually an additional 3/4 turn after hand-tightening). 5. Pour the new engine oil into the oil pan, referring to the user manual for guidance. A funnel can be used to prevent spilling oil on the engine exterior. Check for leaks under the engine. If there are no leaks, lower the vehicle, check the oil dipstick, and start the engine. The indicator light on the dashboard should turn off immediately after starting. Finally, turn off the engine and recheck the oil level. Dispose of the used oil and filter according to local regulations.
