What brand is the XPeng P5?

How to Deal with Scratches on the Front Lip of a Car?

Here are the methods to deal with scratches: 1. If the scratch is not obvious, you can wash the car, apply coarse wax first, then polish it in a circular motion with fine wax, and finally wipe off the wax. 2. If the mark is more noticeable, you can use a touch-up paint pen to spray the area, then apply fine car wax. 3. Waxing is the most well-known method of car paint maintenance. Generally, car wash places offer waxing services. The paint after waxing looks shiny as if oiled, but it has a strong odor because the main component of car wax is petroleum extract. 4. Glazing improves upon waxing. Glazing uses high-molecular polymers and petroleum-based solvents as the main ingredients. Like car wax, it is prone to oxidation and acidification and has a pungent smell. However, glaze is harder than wax and can protect the car paint from minor scratches for a certain period.

13

3

Share

Where is the cabin air filter located in the Mercedes-Benz GLK300?

The cabin air filter in the Mercedes-Benz GLK is located above the footwell on the passenger side, and it can be seen after removing the cover panel. The general replacement interval for the cabin air filter is every 10,000 kilometers. Below is an introduction to replacing the cabin air filter: 1. If the airflow from the air conditioner is significantly reduced, the cabin air filter may be clogged. First, clean the filter or replace it if necessary. 2. The frequency of cleaning depends on road conditions (such as dusty roads, etc.). It is recommended to clean it earlier. 3. The cabin air filter should be correctly installed in its position. Using the air conditioner when the cabin air filter is removed may degrade dust-proof performance and affect the air conditioner's performance.

10

1

Share

Is a Wheel Alignment Necessary After Rotating Tires?

The mileage interval for normal tire rotation often coincides with the recommended interval for a wheel alignment check. The wheel alignment procedure is as follows: 1. Determine the repair direction. 2. Inspect the chassis condition. 3. Install the alignment equipment. 4. Adjust the front and rear wheel camber. 5. Adjust the front and rear wheel toe. Additional information: 1. A wheel alignment is necessary if the vehicle's driving performance is affected. 2. A wheel alignment is required if the chassis or suspension is damaged due to an accident. 3. Uneven tire wear indicates the need for a wheel alignment. 4. A wheel alignment is necessary if components of the axle or suspension have been removed. 5. The four wheels, steering mechanism, and front and rear axles of a vehicle must be installed with specific relative positions as per the manufacturer's standard values. Adjusting and restoring these positions is what constitutes a wheel alignment.

3

1

Share

How to Drive an Automatic Transmission Car Best?

Here are some driving tips for automatic transmission cars: 1. The shift timing of the transmission varies for each car model. The engine RPM at which the automatic transmission shifts under normal driving conditions is called the shift range. Generally, the shift range for automatic transmissions under normal driving conditions is between 2000 and 2500 RPM. 2. The transmission of an automatic vehicle adjusts the shift timing automatically based on the driver's driving behavior. If the accelerator is pressed hard, the transmission will delay the shift timing to maintain high power output for a longer period, usually shifting up after 3000 RPM. Under full throttle, the transmission will shift up only when the RPM reaches the redline zone. 3. Conversely, if the accelerator is pressed gently, the transmission may shift up as early as below 2000 RPM to align with the driver's intention and achieve fuel efficiency. Under normal driving conditions, the shift timing for the new Accord is typically at 2400 RPM, with the gear shifting up to 2nd, 3rd, 4th, and 5th gears at speeds of 20, 40, 60, and 80 km/h, respectively. 4. The transmission does not have a fixed shift timing; it can adjust the shift timing earlier or later based on the driver's intention.

10

3

Share

What does the EDC light mean on a car?

When the EDC fault warning appears in a car, it indicates a problem with the vehicle's high-pressure electronic injection and electronic control system. If this fault occurs, it is necessary to take the car to a 4S shop for repair, as it involves the engine and requires advanced repair skills. Do not attempt to dismantle or repair it yourself. More information about engine faults is as follows: 1. Strange odor in the engine compartment: This may be caused by burnt or melted wires around the engine, or it could be due to the use of a large amount of lubricating grease during maintenance, which can also produce an odor when the temperature rises. 2. Increased lubricant consumption: This could be due to a decrease in the sealing of the engine pistons, leading to a larger gap between the pistons and the cylinder walls. Alternatively, severe wear of internal engine components can increase the gaps between parts. Poor-quality lubricants can also lead to increased consumption. 3. Severe engine carbon buildup: Current engine technology is not yet capable of achieving complete combustion, so carbon buildup is inevitable during the combustion process. Excessive carbon buildup can lead to a series of problems, such as increased fuel consumption, shaking at idle, reduced power, excessive exhaust emissions, and difficulty starting.

3

4

Share

Where can the manual transmission oil filler port be seen on the Shuaike?

The transmission oil filler port of the Shuaike is located on top of the transmission. Location of the transmission oil filler port: Find the engine compartment lock handle at the lower left side of the vehicle cabin, pull the handle to unlock the engine compartment. Push the handle at the front of the engine compartment to open the hood. Use the hydraulic rod to prop up the hood. You can then see the layout of the engine compartment; the oil filler port is located on top of the transmission. Method for adding oil to the Shuaike transmission: Remove the air filter assembly, and you will see a black cylinder (the transmission vent). Remove the cap on top. You can then add ATF fluid. Be careful when filling, as pressure inside will increase when adding through the vent. It is advisable to make a funnel out of cardboard and add the fluid slowly.

9

5

Share

What brand is the XPeng P5?

How to Deal with Scratches on the Front Lip of a Car?

Where is the cabin air filter located in the Mercedes-Benz GLK300?

Is a Wheel Alignment Necessary After Rotating Tires?

How to Drive an Automatic Transmission Car Best?

What does the EDC light mean on a car?

Where can the manual transmission oil filler port be seen on the Shuaike?

Which car is the Volkswagen TREK?

How to Repair Oxidized Rims?

How to Check the Production Date of Car Tires?

Where is the ignition coil located in a Toyota Prado?