What brand is the Odyssey?

1 Answers
Terri
07/24/25 4:17pm
Odyssey is a mid-sized MPV introduced by the Japanese automaker Honda. In China, it is produced in collaboration with Guangzhou Automobile Group and is known as the GAC Honda Odyssey. Below are some relevant details: 1. Taking the 2021 Odyssey as an example, its body dimensions are: length 4847mm, width 1820mm, height 1702mm, wheelbase 2900mm, and curb weight 1822kg. The 2021 Odyssey features a MacPherson strut front suspension and a torsion beam rear suspension. 2. The 2021 Odyssey is equipped with a 2.0L naturally aspirated engine, delivering a maximum horsepower of 146ps, maximum torque of 175nm, and maximum power of 107kw, paired with an electronic continuously variable transmission.
Was this review help?
20
2
Share
More Forum Discussions

Where is the crankshaft position sensor located on the Buick GL8?

The crankshaft position sensor on the Buick GL8 is located at the rear right side of the engine, specifically at the junction between the transmission and the engine oil pan. Below is relevant information about the crankshaft position sensor: 1. Function: The primary role of the sensor is to determine the position of the crankshaft, specifically its rotation angle. It typically works in conjunction with the camshaft position sensor to establish the basic ignition timing. 2. Sensor Signal: The engine initiates ignition at the end of the compression stroke. The signals from both the crankshaft position sensor and the camshaft position sensor are used to calculate this timing. The crankshaft position sensor identifies which piston is at top dead center, while the camshaft position sensor determines which piston is in the compression stroke.
4
4
Share

How to Determine How Much to Turn the Steering Wheel?

Steering wheel rotation is generally determined based on the brand logo and horn markings on the steering wheel. The specific judgment methods are as follows: 1. Full turn judgment: After a full turn, the positions of the brand logo and horn remain unchanged. 2. Half-turn judgment: After a half-turn, the brand logo and horn appear upside down from the driver's perspective. Note: The principle of the steering wheel is that the rack-and-pinion gear set is enclosed in a metal tube, with each tooth end of the rack protruding outside the metal tube and connected by tie rods. The pinion is connected to the steering shaft. When the steering wheel is turned, the gear rotates, driving the rack to move. The tie rods at each tooth end of the rack are connected to the steering arm of the steering shaft.
15
4
Share

How to activate the sport mode in the 2019 Buick Excelle?

To activate the sport mode in the 2019 Buick Excelle, press the 'sport' button located on the left side of the multifunction steering wheel. Once the sport mode is activated, the electronic control unit will increase the engine speed to maintain sufficient torque for quick acceleration and deceleration. It will also adjust other vehicle settings, such as stiffening the suspension for better support, enhancing throttle sensitivity, and increasing engine air intake. The 2019 Buick Excelle is a compact sedan under the Buick brand, equipped with a 1.0L turbocharged 3-cylinder engine. It delivers a maximum power of 92kW at 5600rpm and a maximum torque of 170Nm, paired with a 6-speed dual-clutch transmission.
17
3
Share

How to Release Freon in a Car?

To release Freon in a car, follow these steps: 1. Connect the manifold pressure gauge to the compressor and the refrigerant tank. 2. Open the refrigerant tank, loosen the nut on the middle injection hose, and tighten the nut after hearing the sound of refrigerant vapor flowing to expel air from the hose. 3. Open the low-pressure manual valve to allow refrigerant into the cooling system, and close the manual valve when the pressure reaches 0.4 MPa. 4. Start the engine and turn on the air conditioning, setting both the fan speed and temperature to the highest levels. Open the manual valve on the manifold pressure gauge to allow more refrigerant into the cooling system until it reaches the specified value of 1.37 to 1.67 MPa.
13
3
Share

What is the Principle of a Supercharger?

The principle of a supercharger is: it uses the engine's own power to drive the turbine for boosting. It is connected to the engine crankshaft pulley via a belt, utilizing the engine's rotational speed to drive the internal blades of the supercharger, thereby generating pressurized air that is sent into the engine's intake manifold. This increases the air pressure within the intake manifold, overcoming valve interference resistance while maintaining the original dimensions of the intake manifold, valves, and camshaft. Due to the increased intake pressure, more air is forced into the combustion chamber during each valve opening period, and the fuel injection quantity is correspondingly increased, enhancing the engine's working efficiency compared to before the supercharging.
10
3
Share

Where is the mechanical key ignition position of the X-Trail?

The mechanical key ignition position of the X-Trail is located on the driver's side door. More information about the X-Trail is as follows: 1. Introduction: The X-Trail is a model launched in Japan at the end of 2000, a very classic SUV, directly targeting competitors like the Toyota RAV4 and Honda CR-V. 2. Configuration: The design concept of the X-Trail is positioned as a "city four-wheel-drive vehicle." The interior design is exquisite, equipped with advanced technologies such as a digital 6-disc high-fidelity theater CD+AUDIO sound system, intelligent remote key system, intelligent voice navigation system, ASCD cruise control system, rearview camera, side-view system, multimedia entertainment system, anti-glare interior rearview mirror, external temperature display, and intermittent multi-level adjustable front wipers.
12
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.