What brand is the Lynk & Co 03?

What is the wading capability of the NIO ES6?

The maximum wading depth of the NIO ES6 is approximately 300-500mm. The wading depth of the NIO ES6 is determined by the height of the vehicle's chassis, which is the ground clearance listed in the model's parameter configuration table. Generally, the greater the ground clearance, the higher the chassis, and the higher the safety factor when driving through waterlogged roads. Therefore, in terms of safe wading depth, the advantages of off-road vehicles and SUVs are obvious. However, for most compact and small cars with low chassis, the position of the vehicle's air intake should be used as a benchmark when passing through waterlogged roads. If the air intake of the NIO ES6 is below the water level during wading, water will be sucked into the engine's cylinders. Since water cannot be compressed like air, it will cause severe damage to the engine's mechanical components (such as connecting rods, pistons, crankshafts, etc.). Therefore, the wading depth must not exceed the height of the engine's air intake. The height of the engine's air intake, and thus the maximum wading depth, can also be increased by installing a snorkel. If wading is unavoidable, the following safe and correct operations should be performed: Before driving through water, always turn off the auto start-stop function to prevent the vehicle from automatically restarting after stalling in the water, which could cause severe engine damage due to water ingress. Assess the underwater road conditions based on the passage of vehicles ahead and choose an appropriate entry point. Observe the path taken by other vehicles and follow their tracks at low speed, avoiding sudden acceleration or deceleration. On roads prone to water accumulation, observe warning water level markers, trees, and reference points such as the wheels and doors of other vehicles to estimate the water depth before deciding whether to proceed. Know your vehicle's safe wading depth. If the water depth exceeds half the height of the tires or the engine's air intake, do not attempt to drive through; instead, choose an alternative route.

2

3

Share

What is the function of the car VVT valve?

The function of the car VVT valve is to adjust the amount of intake (exhaust) and the timing and angle of valve opening and closing. Here are the relevant details: 1. VVT: VVT stands for Variable Valve Timing, referring to the variable timing valve system. This is a technology used in automotive piston engines. VVT technology can adjust the overlap time and timing of the engine's intake and exhaust systems, reducing fuel consumption and improving efficiency. The advantages are fuel efficiency and a high power-to-weight ratio; the disadvantage is insufficient torque at mid-range speeds. 2. Principle: The principle of the engine's variable valve timing technology is to adjust the intake (exhaust) amount, valve opening and closing time, and angle based on the engine's operating conditions, so that the amount of air entering reaches the optimal value, improving combustion efficiency.

7

5

Share

What is the current of the 12V power supply in the car cigarette lighter?

The car cigarette lighter is 12V 10A. There are two current values for the car cigarette lighter socket, 10A and 20A. The battery's rated voltage is 12V, with corresponding rated power outputs of 120W and 240W, and the motor's usage power matches these values. More information about the cigarette lighter is as follows: Methods to measure the voltage of the cigarette lighter: 1. Multimeter: First, prepare a multimeter and set the range to 50V. Be sure to set the multimeter to the DC range, otherwise, it may be damaged. 2. Testing: Use the black probe of the multimeter to test the outer wall of the cigarette lighter socket, and the red probe to test the center of the socket's base. When using the red probe, avoid touching the outer wall to prevent a short circuit, which could burn out the multimeter.

14

1

Share

What is a Vauxhall car?

Vauxhall is a British automotive brand. Here are some key details about Vauxhall: 1. Overview: Vauxhall Motors is a major British car manufacturer that began producing vehicles in 1903. It was acquired by General Motors in 1925 and is currently a subsidiary of PSA Group. 2. Logo introduction: Vauxhall has redesigned its griffin emblem. The new logo, featuring an enlarged and more prominent griffin figure with a more modern appearance, will debut on the Vauxhall Insignia. The word "Vauxhall" has been incorporated as part of the redesigned emblem.

14

0

Share

Where is the water temperature gauge on the Vezel?

The Honda Vezel does not have an actual water temperature gauge, but it is equipped with a water temperature indicator light. This light is located on the left side of the instrument panel, near the tachometer, and appears as a sailboat-shaped icon. It turns blue when the temperature is too low and red when the temperature is too high. Below are the detailed explanations: 1. Indicator light: The blue light illuminates when the engine has not reached the normal operating temperature and turns off once the normal temperature is achieved. As long as the red light does not come on, there is no issue. Generally, if the water temperature gauge shows excessively high temperatures, it indicates a fault in the engine cooling system. 2. Common faults: Malfunctions in the thermostat of the engine cooling system can prevent it from opening, obstructing the flow of coolant within the engine and leading to excessively high coolant temperatures. Additionally, if the cooling system fan is not functioning properly, it can result in poor coolant heat dissipation, causing the temperature to rise and the water temperature light to illuminate.

14

5

Share

What is the SOS button in a car used for?

The SOS system in a car is an onboard self-rescue system. It is an emergency system designed to quickly seek rescue assistance when the vehicle experiences a malfunction or accident, or when encountering dangerous or sudden situations. More information about the SOS system is as follows: 1. SOS System: The vehicle emergency warning and rescue system includes an emergency warning and rescue platform and several onboard terminals wirelessly connected to the platform. The emergency warning and rescue platform consists of: a data collection server, a data storage server, a warning analysis server, and a rescue guidance server. 2. Usage Method: In case of an emergency, press and hold the SOS button for more than 2 seconds, and the in-car connected system will automatically make a voice call to the customer service.

16

3

Share

What brand is the Lynk & Co 03?

What is the wading capability of the NIO ES6?

What is the function of the car VVT valve?

What is the current of the 12V power supply in the car cigarette lighter?

What is a Vauxhall car?

Where is the water temperature gauge on the Vezel?

What is the SOS button in a car used for?

What is the difference between single axle and double axle?

Which Honda CR-V models and years are affected by engine oil dilution?

How Many Degrees Does Each Mark on the Temperature Gauge Represent?

What kind of car is the Verano 15S from Buick?