What brand is the Lavida audio system?

What to Do When the Original Owner Tows Away a Repossessed Vehicle?

After the debt became due and was not repaid, ownership of the vehicle was obtained based on the mortgage, and the original owner constitutes the crime of theft. It is generally not considered a crime but can be deemed a breach of contract. You may file a civil lawsuit demanding the other party to repay the debt in advance.

10

0

Share

How to Use Reference Points and Steer for Right-Angle S-Turns

During practice, you exit the garage and then reverse back in. When exiting, focus on the left rearview mirror. When reversing into the garage, watch the left rearview mirror. When the lower edge of the mirror covers the yellow line, turn the steering wheel fully to the right, then check the right rearview mirror. When the wheel is 30 centimeters away from the garage corner, turn the steering wheel fully to the right again. Then straighten the wheels when the vehicle body aligns properly.

6

0

Share

How to Choose Between T-Cross and Tacqua?

The most significant difference between T-Cross and Tacqua is that the front face adopts a through-type design, extending to the headlights on both sides, creating a visual effect of 'eagle spreading wings'. Tacqua offers more abundant and practical configurations, such as adjustable front seat headrest height, rear air vents as standard, rearview camera, roof lining, and USB ports. Both vehicles are equipped with 1.5L/1.4T engines. Through parameter comparison, Tacqua has an advantage in engine performance. Tacqua comes with a 5-speed manual, 6-speed automatic manual, and 7-speed dual-clutch transmission, featuring superior power tuning. In contrast, T-Cross does not offer a 5-speed manual model. As Tacqua was launched later, it boasts better technological capabilities compared to T-Cross.

19

0

Share

What are the reasons for the Honda Avancier's reverse radar not making sound?

Introduction to the reasons why the Honda Avancier's reverse radar does not make sound: Check whether the reverse radar wiring at the rear bumper is properly connected; See if the reverse light turns on when shifting to reverse gear. If not, check the reverse light switch; Remove the right lining panel of the trunk and test the continuity of the wires to the radar; Open the fuse box and use a multimeter to check the continuity of the fuses related to the reverse radar; The reverse radar module or buzzer is damaged and needs to be replaced. Apart from malfunctions, the reverse radar will not respond in the following situations: Obstacles that are too low: Generally, obstacles that are 10~15cm below the center of the probe may be ignored by the probe. Moreover, the closer the obstacle is to the parking space, the lower this height value becomes, and the greater the danger. Obstacles that are too thin:

20

5

Share

How to Drive Over Speed Bumps?

Methods for driving over speed bumps: 1. Observe the road conditions ahead in advance, especially when the vehicle has entered a speed-limited section. Reduce speed and apply linear braking upon spotting a speed bump to slow down beforehand, maintaining a speed of approximately 10 to 20 km/h; 2. Having both left and right wheels contact the speed bump simultaneously can distribute the impact force evenly across both wheels, balancing the load on the suspension systems on both sides and minimizing damage to the greatest extent; 3. Release the brakes before the wheels are about to pass over the speed bump. This shifts the vehicle's center of gravity backward, relieving the load on the front shock absorbers and allowing them to be in optimal condition to absorb the impact of the speed bump.

7

5

Share

How to Identify the Quality of an Ignition Coil?

Identifying the quality of an ignition coil can be done through the following methods: 1. Feel the temperature of the ignition coil casing by hand; it should feel warm under normal conditions, but if it feels too hot to touch, it indicates an inter-turn short circuit fault in the ignition coil. 2. Use a multimeter to measure the resistance of the primary and secondary windings. If the resistance is infinite, it means there is an open circuit fault in the winding. If the resistance is too high or too low, it indicates poor contact or an inter-turn short circuit in the winding. 3. Use the substitution method with a comparative spark test. Compare the spark intensity of the ignition coil being tested with that of a known good ignition coil to see if they are the same. Faults in the ignition coil can lead to: 1. No secondary voltage being generated or the secondary voltage being too low to ignite. 2. Although a spark may occur, the reduced secondary voltage results in insufficient ignition energy, causing high-speed misfires, incomplete combustion, difficulty in starting the engine, unstable idle, reduced power, increased exhaust pollution, and higher fuel consumption.

6

0

Share

What brand is the Lavida audio system?

What to Do When the Original Owner Tows Away a Repossessed Vehicle?

How to Use Reference Points and Steer for Right-Angle S-Turns

How to Choose Between T-Cross and Tacqua?

What are the reasons for the Honda Avancier's reverse radar not making sound?

How to Drive Over Speed Bumps?

How to Identify the Quality of an Ignition Coil?

How to Clear the Maintenance Reminder on Infiniti Q50?

How to Deal with Odors Inside the Car?

How to Fix iOS CarPlay Black Screen Issue?

How to Remove the Original Car Floor Mat Clips?