What Brand is the escooter Mini Electric Vehicle?

What is the reason for the Chery engine malfunction light being on but the car running normally?

The engine malfunction light being on may be a warning, indicating that certain system parameters of the car may have exceeded the set range. At this time, the car can continue to drive, and the light is generally yellow. There is also a more serious situation where the light is red, indicating a very severe malfunction. The car may still be able to drive, but for safety reasons, it must be stopped immediately, the engine turned off, and driving prohibited until the fault is checked. There are mainly 7 reasons for the engine malfunction light being on: Sensor malfunction: The sensors mentioned here include water temperature, crankshaft position, air flow, intake temperature, oxygen sensors, etc. When these sensors are damaged, have poor contact, or signal interruption, the car's ECU cannot accurately obtain engine data, which will cause the engine malfunction light to come on. Fuel quality issue: If fuel and engine oil are not added according to the manufacturer's requirements, it may cause engine wear, leading to the malfunction light coming on. Poor mixture combustion: Poor mixture combustion can cause engine carbon deposits or knocking. After being detected by the oxygen sensor and reported to the ECU, the malfunction light will come on as a warning. Spark plug failure, ignition coil failure, fuel pump failure, fuel line blockage, etc., can all cause poor mixture combustion in the engine. Turbocharging issue: The intake turbocharging pipeline and turbocharger can also cause the engine malfunction light to come on. The most common is turbocharger damage, accompanied by symptoms such as oil leakage, high oil consumption, power loss, metal noise, and blue or black smoke from the exhaust pipe. Intake issue: If there is a problem with the car's intake, it may cause engine pipeline blockage, and in severe cases, the engine malfunction light will come on. If the air filter is not clean and not regularly cleaned, it can lead to intake problems. Exhaust issue: Exhaust malfunction can also cause the engine malfunction light to come on. Rear oxygen sensor, three-way catalytic converter, exhaust camshaft, and bearing failures are all causes of exhaust problems, with the three-way catalytic converter being the most common. Using leaded gasoline, lead or silicon-containing lubricant additives, physical damage to the three-way catalytic converter, or engine fuel supply system failures can easily cause three-way catalytic converter malfunctions. Anti-theft system malfunction: If the car's electronic anti-theft system malfunctions, or the anti-theft controller does not match the engine electronic controller, the anti-theft system can also cause the engine to not work properly, and the engine malfunction light will come on. If the engine malfunction light is on, you can follow these steps: First, pay attention to whether the engine is running normally, whether there is shaking, smoke, etc. If so, try not to start it again. Especially note that if the light is red, do not start the engine again. If the engine can start, turn it off for 5-10 minutes, then without pressing the brake, press the start button once, or without pressing the clutch, turn the key halfway to the 'on' position. The car will perform a self-check after powering on. Wait for 5-10 seconds and observe whether the malfunction light on the dashboard goes off. If the malfunction light does not go off, please go to a service station as soon as possible to find the cause. The service station can read the fault code with a portable diagnostic tool to obtain fault information and perform targeted repairs.

14

3

Share

What to Pay Attention to When Picking Up Your Car After Repair

When picking up your car after repair, you need to pay attention not only to the condition of the car when stationary but also to its performance while driving. Stationary inspection: The car should be parked on a flat surface for easy inspection. This inspection mainly ensures that other components were not affected during the repair process, such as inconsistent tire pressure between the left and right tires, issues with springs and shock absorbers, or deformations in the frame or fenders. The inspection includes observing the vehicle's exterior, checking the front of the car, inspecting the driver's cabin, examining the rear of the car, checking the fuel tank, and verifying the installation of the spare tire. Common post-repair issues include uneven tire pressure between the left and right tires, problems with springs and shock absorbers, or deformations in the frame or fenders. The owner should inspect the front of the car, including the driver's cabin, engine hood, left and right fenders, and front bumper, to ensure everything is properly aligned. Driving inspection: During the driving inspection, the engine should reach normal operating temperature, and you should check if all the gauges are functioning correctly. While driving, pay attention to whether the clutch disengages completely, engages smoothly and reliably, and operates without shaking or unusual noises. Initially, maintain a low speed of 2-3 km/h to allow the chassis components to warm up to normal temperature, and listen for any abnormal sounds. Gently press the brake pedal to test if the brakes are responsive and effective, then gradually increase speed. When testing the steering wheel, the steering system should be light and flexible, with no tendency to pull to one side.

1

2

Share

How Long Does It Take for a 4S Shop to Repair a Flooded Car?

After a car is flooded, a 4S shop typically takes 5-6 days to complete the repairs. Here is some relevant information: 1. Waterlogging Insurance: Also known as auto loss insurance or engine special loss insurance, different insurance companies may use varying terms, but the essence remains the same. This is a newly derived type of insurance, referring to an additional coverage purchased by the car owner specifically for the engine. 2. Claim Conditions: At the time of suffering from heavy rain or floods, the insured vehicle is submerged up to the exhaust pipe or intake pipe, and the driver continues to start the vehicle or uses inertia to start it; or after suffering from heavy rain or floods, the vehicle is started without undergoing necessary treatment.

13

1

Share

Under what circumstances is cylinder head gasket blowout prone to occur?

Two situations where the mating surfaces are uneven or the bolts are not tightened evenly can easily lead to cylinder head gasket blowout. Below is relevant information about cylinder head gaskets: 1. Introduction: The cylinder head gasket, also known as the cylinder bed, is located between the cylinder head and cylinder block. Its function is to fill microscopic gaps between the cylinder block and cylinder head, ensuring good sealing at the mating surfaces, thereby maintaining combustion chamber sealing to prevent cylinder gas leakage and water jacket coolant leakage. 2. Types: One type is the metal-asbestos cylinder head gasket, which contains metal wires or particles within asbestos and is covered with copper or steel sheets. Another type is made of solid metal sheets, commonly used in high-performance engines, with this type frequently employed in passenger cars and racing vehicles.

17

3

Share

Is the maximum speed 20 or 30 when visibility is 50 meters?

When driving a motor vehicle encountering fog, rain, snow, or other conditions with visibility within 50 meters, the maximum speed must not exceed 30 km/h. Below are the relevant details: 1. On highways: When visibility is below 200 meters, the speed limit is 60 km/h; when visibility is below 100 meters, the speed limit is 40 km/h; when visibility is below 50 meters, the speed limit is 20 km/h, and the vehicle should exit the highway as soon as possible (meaning to find the nearest exit and leave the highway promptly). 2. Article 58 stipulates: When driving at night without street lights, poor lighting, or encountering low visibility conditions such as fog, rain, snow, dust, or hail, motor vehicles should turn on the headlights, position lights, and rear lights, but when the following vehicle is driving close to the preceding vehicle in the same direction, the high beams should not be used. Motor vehicles driving in foggy conditions should turn on the fog lights and hazard warning flashers.

8

3

Share

How long does the entire Subject 2 test take?

The entire Subject 2 test takes 10 minutes. After entering the examination area and getting into the vehicle as arranged by the staff, you will need to scan your ID card to begin the test. There are a total of five test items, and there is no specified time limit for each individual item. You just need to complete all five items within the 10-minute timeframe. Related information: The Subject 2 test, also known as the small road test, is a part of the motor vehicle driver's license examination and is the abbreviation for the field driving skill test. The main contents of the Subject 2 test include stopping and starting on a slope, making a 90-degree turn, navigating an S-shaped curve, parallel parking, and reversing into a parking space. Before the test, the vehicle management office will provide candidates with a simulation of the test process. The training department of the vehicle management office states that completing the five test items within 10 minutes is reasonable and safe. Additionally, shortening the test time improves efficiency. The 10-minute duration fully meets the operational time requirements for the vast majority of test-takers, as long as candidates remain calm and composed, the time is more than sufficient.

8

1

Share

What Brand is the escooter Mini Electric Vehicle?

What is the reason for the Chery engine malfunction light being on but the car running normally?

What to Pay Attention to When Picking Up Your Car After Repair

How Long Does It Take for a 4S Shop to Repair a Flooded Car?

Under what circumstances is cylinder head gasket blowout prone to occur?

Is the maximum speed 20 or 30 when visibility is 50 meters?

How long does the entire Subject 2 test take?

Introduction to XRV Automatic Transmission Gears - What Are the Gear Positions?

Is Chery's Engine Truly Independently Developed?

What is the white color of Kia K3?

Can Car Vacuum Cleaners Be Left in the Car During Summer?