What brand is the car with the Song character logo?

Why does the car shake violently when starting in first gear with half-clutch and no throttle?

The shaking of the car when starting in first gear with half-clutch may be caused by the following reasons: Reason 1: The clutch pressure plate is unevenly worn, resulting in insufficient power. Reason 2: Incomplete fuel combustion, excessive engine carbon deposits, or insufficient engine power itself. Reason 3: The engine and transmission are not properly aligned. Reason 4: The connection between the transmission and the chassis is loose. To determine the exact cause, each of these conditions should be checked one by one. It is recommended to go to a 4S shop for repair. Tips: Familiarize yourself with the clutch pedal operation and develop good habits—press it all the way down when engaging and release it slowly. Always use first gear when starting and pay attention to the coordination between the throttle and clutch.

3

5

Share

Can you turn right at a Y-shaped intersection with a red light?

At a Y-shaped intersection, you can turn right when the light is red if there is a clear right-turn arrow signal, and you must obey the traffic light. If there is no red light prohibiting right turns at the intersection, you can turn right. Most traffic lights do not have arrow indicators, while some have left-turn arrow signals. At such intersections, you can still turn right when the light is red. At certain special intersections, right turns must also comply with the traffic light, and these intersections usually have signs to alert drivers. When driving on general urban roads, as long as you do not speed, run red lights, smoke while driving, make phone calls, and fasten your seatbelt, you will not commit any traffic violations. Laws and Regulations: According to the "Road Traffic Safety Law," the regulations on traffic lights are as follows: Article 25, Paragraph 2 states that traffic signals include traffic lights, traffic signs, traffic markings, and the directions of traffic police. Article 26 states that traffic lights consist of red, green, and yellow lights. A red light indicates prohibition of passage, a green light indicates permission to pass, and a yellow light serves as a warning. Article 38 states that vehicles and pedestrians shall pass in accordance with traffic signals; when directed by traffic police on-site, they shall follow the directions of the traffic police; on roads without traffic signals, they shall pass under the principles of safety and smooth traffic. Article 62 states that pedestrians crossing intersections or roads shall use crosswalks or pedestrian facilities; when crossing signalized crosswalks, they shall follow the traffic light signals; when crossing intersections without traffic signals or crosswalks, or crossing roads without pedestrian facilities, they shall cross only after confirming safety. Article 89 states that pedestrians, passengers, or non-motor vehicle drivers who violate road traffic safety laws or regulations regarding road passage shall be given a warning or fined between 5 and 50 yuan; non-motor vehicle drivers who refuse to accept the fine may have their vehicles impounded. Driving a motor vehicle in violation of traffic light signals results in a 6-point penalty. Right-Turn Precautions: Observe oncoming straight-moving vehicles: When turning right, check both the right and left sides for oncoming traffic. Observe opposing left-turning vehicles: In addition to watching for straight-moving vehicles, also check for opposing left-turning vehicles. When turning right, yield to vehicles on the left, whether they are turning left or going straight. Watch for pedestrians: When turning right, besides crosswalks before the intersection, there may also be crosswalks at the corner. Always check for pedestrians on the crosswalks.

8

5

Share

What is the maximum speed for first gear?

First gear should not exceed 5 km/h. Below are detailed explanations about car gears: Speed aspect: Vehicle speed refers to the distance a car travels per unit of time. The corresponding speed for first gear is 0-5 km/h. Second gear corresponds to 5-20 km/h, third gear to 20-40 km/h, fourth gear to 40-60 km/h, and fifth gear to 60-100 km/h. Gear shifting timing: Vehicle speed can also generally refer to motor vehicle speed. For most cars, the optimal gear shifting occurs when the engine reaches 2000 r/min and should not exceed 2500 r/min. For high-displacement, high-power engines, shifting can be done around 3000 r/min.

15

0

Share

Will the Engine Stall When Braking?

First gear semi-clutch braking will not cause the engine to stall. When the clutch is in the semi-engaged state, the friction between the pressure plate and the friction disc is less than that in the fully engaged state. Below is the relevant introduction: Because the semi-engaged clutch means the clutch is between disengagement and engagement, and the transmission system is between connection and disconnection, it can provide a flexible power output, which is often used in complex road conditions, starting, turning, and short-distance following. During driving, the driver can press or release the clutch pedal as needed to temporarily separate or gradually engage the engine and the gearbox, thereby cutting off or transmitting the power input from the engine to the transmission. The clutch is a common component in mechanical transmission, allowing the transmission system to be separated or engaged at any time. The basic requirements for the clutch are smooth engagement, quick and thorough disengagement, easy adjustment and repair, small external dimensions, light weight, good wear resistance, and sufficient heat dissipation capacity.

17

4

Share

Can you shift directly from first gear to second gear by pulling down?

You can shift directly from first gear to second gear by pulling down. Here is some extended information about manual transmission cars: Introduction: A car that uses a manual shift mechanical transmission (also known as manual transmission, MT) to adjust speed. This means you need to manually move the gear lever to change the gear engagement position inside the transmission, altering the gear ratio to achieve the desired speed. The gear lever can only be moved when the clutch is depressed. Principle: The power input shaft is connected to the clutch, and the power transmitted from the clutch is directly passed through the input shaft to the gear set. The gear set consists of gears with different diameters, and different gear ratios result in completely different power transmission effects. The gear shifting commonly referred to in daily driving means changing the gear ratio.

10

0

Share

Will the engine stall if the clutch is fully released in first gear without accelerating?

Releasing the clutch fully in first gear without accelerating will not cause the engine to stall. However, if the clutch is released too quickly, increased resistance without sufficient fuel supply may lead to stalling. Below are some precautions for driving a manual transmission car: When shifting gears, the driver should quickly depress and release the clutch, avoiding the semi-engaged state. Prolonged semi-engagement can cause rapid wear of the clutch disc, reducing its service life. Ensure the clutch is fully depressed when shifting gears. Failing to do so not only makes it difficult to engage the gear accurately but also causes severe damage to the manual transmission over time. Regularly inspect and clean the friction disc and pressure plate in the clutch. Replace the friction disc if cracks, extensive burning, or wear below 3.4 mm thickness are observed. After cleaning or replacing the clutch bearing, apply an appropriate amount of grease.

20

4

Share

What brand is the car with the Song character logo?

Why does the car shake violently when starting in first gear with half-clutch and no throttle?

Can you turn right at a Y-shaped intersection with a red light?

What is the maximum speed for first gear?

Will the Engine Stall When Braking?

Can you shift directly from first gear to second gear by pulling down?

Will the engine stall if the clutch is fully released in first gear without accelerating?

Should the X-Trail use 92 or 95 octane gasoline?

How long does it usually take to practice for Subject 3 before taking the test?

What is the maximum number of points that can be deducted from a driving license?

What Causes the Vehicle's Engine Malfunction Light to Stay On?