···
Log in / Register

What brand is Marquis tires?

4 Answers
DelBriella
09/05/25 4:33am

Marquis is a tire brand under Cheng Shin. Marquis focuses on balanced performance, with advertised product features including long service life, durability, economy, and good safety performance. The supported tire sizes range from 13 inches to 16 inches in diameter. Since tires are in contact with the ground and subjected to friction, as well as bearing loads and impacts from road potholes during driving, they require regular inspection and replacement. Tires should generally be replaced after about 50,000 kilometers. Many car owners often neglect tire inspections, which can easily lead to tire aging or blowouts. Additionally, after changing tires, a dynamic balance should be performed because the weight and position of the wheel hub have relatively changed, rendering the previous balance weights ineffective.

Was this review help?
8
0
Share
ElainaRose
09/17/25 5:02am

I've been driving for ten years and often tinker with tires. Marquis is actually a sub-brand created by Dunlop for the Asia-Pacific region, much like a secondary line in sports shoes. This brand is particularly common in Southeast Asia, often featuring a small crown logo on the tire sidewall, mainly targeting the working-class market. My old car used a set of their wear-resistant tires, which lasted 50,000 kilometers before replacement. They were very fuel-efficient for city driving but had noticeably weaker grip in rain or snow. If you're on a tight budget and mainly drive in the city, you might consider them. However, if you frequently drive on highways, it's advisable to spend a bit more on tires with better wet performance.

Was this review help?
7
3
Share
Expand All
StLeilani
10/31/25 5:32am

Having repaired cars for 15 years, I've seen too many car owners using Marquis tires. This brand is essentially a budget-friendly alternative to Dunlop, with most factories located in Indonesia and Malaysia. Just last week, an old Sylphy came in for tire replacement, originally equipped with Marquis MD-407 tread pattern, showing severe inner tire wear. Their tire compound is notably hard and wear-resistant, but the road noise is as loud as an airplane. The rubber tends to harden and slip as it ages, so it's best to check the groove depth before heading out in the rainy season.

Was this review help?
7
1
Share
Expand All
DelBarrett
12/14/25 5:40am

When choosing tires, I specifically researched Marquis, which is essentially Dunlop's budget-friendly line. I remember checking the information—they mainly focus on HT highway tires and SUV tire series, like the MD-SPORTS tread pattern. Last time, I replaced all four tires on my Fit with them, costing just over 2,000 yuan. They held up fine for two years, though they were quite bumpy over speed bumps. Nowadays, many domestic tires offer better noise reduction, but if you're on a tight budget, these sub-brands of international names are still a reliable choice.

Was this review help?
13
2
Share
Expand All
More Forum Discussions

Do all China VI vehicles have particulate filters?

China VI vehicles all have particulate filters. The China VI standard is essentially a more stringent requirement based on the China V standard. It not only imposes strict limits on the emissions of carbon monoxide, hydrocarbons, and nitrogen oxides but also sets specific requirements for the number of particulate emissions. Therefore, upgrading from China V to China VI is not just about catalytic reduction of exhaust gases; it also requires the installation of a device called a particulate filter to reduce particulate emissions. Below are the requirements of the China VI emission standard: The China VI standard is extremely high and is among the strictest vehicle emission standards in the world. Compared to the China V emission regulations, China VI adds limits for nitrous oxide and particulate matter particle count. Additionally, during cold start conditions, carbon monoxide content must be reduced by 50%, hydrocarbon content by 30%, and carbon monoxide content by 30%. After the implementation of the China VI standard, China V vehicles can still be driven on the road: Even after the China VI standard is implemented, China V vehicles can still be driven, though registration and licensing may become more difficult. For those China V vehicles in inventory, they will certainly be sold at discounted prices, and the closer the implementation date of China VI gets, the cheaper they will become.
16
3
Share

Can a Tire with a Sidewall Hot Patch Be Used on the Highway?

Tires with a sidewall hot patch cannot be used on the highway. Generally, if the sidewall of a tire is damaged, it is recommended to replace the tire. This is because the sidewall is relatively weak, and any damage indicates that the internal cord fibers have broken. Neither mushroom plug repairs nor hot patch methods can restore the broken cord fibers in the tire sidewall, so replacement is necessary when the sidewall is damaged. Below is relevant information about tire repairs: Mushroom Plug Repair: Offers better and more durable results but is relatively more expensive and time-consuming, mainly suitable for larger damages. String Repair: Does not require removing the tire or performing wheel balancing, making it quick and convenient; however, it involves enlarging the damage and may lead to air leakage over time. Patch Repair: Takes less time and is cheaper, but it is less durable and suitable for smaller damages.
9
0
Share

Can I make a left U-turn when the left turn signal is red?

Whether you can make a left U-turn when the left turn signal is red depends on whether there is a no U-turn sign at the intersection. If there is no prohibition sign, you can make a U-turn. If there is a no U-turn sign or no U-turn marking, you cannot make a U-turn. Additionally, you must not drive over the crosswalk, especially when the light is red. Even if U-turns are allowed, you must not affect other vehicles. Below are the precautions for making a U-turn: U-turns are allowed when there is no prohibition sign: Generally, if there is no no U-turn sign, you can make a U-turn as long as it does not interfere with normal traffic flow and is safe. Typically, the central median barrier will change from a solid line to a dashed line near the intersection. U-turns are allowed on yellow grid lines: You can make a U-turn on yellow grid lines where there is no central barrier. Yellow grid line areas indicate no stopping and are usually set up at intersections prone to congestion due to temporary parking or at entrances to important facilities.
3
4
Share

Will Water Enter the Vehicle Chassis When Wading?

Water will not enter the vehicle chassis when wading. As long as the water level does not reach half of the wheel, it will not cause water to enter the engine's intake system. However, if the wading height reaches or exceeds half of the wheel, the engine, electronic equipment, components, and wiring in the vehicle may be affected. Below is an introduction to vehicle insurance: Introduction: Vehicle insurance (also known as motor vehicle insurance, car insurance, or auto insurance for short) is a type of property insurance. It covers the vehicle itself and third-party liability, providing compensation for personal injuries or property damage caused by natural disasters or accidents involving motor vehicles. Classification: Vehicle insurance can be divided into commercial insurance and compulsory traffic insurance (CTPL). Commercial insurance further includes primary vehicle insurance and additional insurance. The main clients of vehicle insurance are legal entities and individuals who own various motor vehicles. Definition: A widely available insurance type in China, it provides coverage for motor vehicles such as cars, electric vehicles, battery-powered vehicles, motorcycles, and tractors. Vehicle insurance can be categorized into commercial insurance and compulsory traffic insurance. Commercial insurance also consists of primary vehicle insurance and additional insurance.
12
3
Share

How to Deal with Clogged Drain Holes in BMW 3 Series?

Simply use a soft steel wire to unclog it. Below is an introduction to car drain holes: 1. Air conditioning drain hole: If the air conditioning drain hole is clogged, pay attention to the floor. If it gets wet, check if the air conditioning drain hole is blocked. 2. Engine compartment drain hole: The engine compartment drain hole is prone to clogging, which can cause engine failure and affect the engine computer in some car models. 3. Sunroof drain hole: Since the sunroof drain hole is located at the top, it is easily clogged by leaves and dirt, requiring regular inspection and maintenance. 4. Fuel tank cap drain hole: While driving, some debris can accumulate in the fuel tank cap's crevices. In rainy or humid conditions, this can lead to water accumulation, corroding the fuel tank cap and door panels, so regular checks are necessary. 5. Door drain hole: Due to its low position, the door drain hole can be affected when driving on muddy or waterlogged roads. If water accumulates inside the door, it can damage the window regulator and audio equipment. 6. Trunk drain hole: The trunk drain hole rarely gets waterlogged, but if water enters the trunk on waterlogged roads or due to spills, it should be drained as soon as possible, often requiring manual opening of the trunk drain hole.
12
4
Share

What Does Coating Do?

Car paint coating involves the professional application of coating products evenly on the surface of the vehicle. Through a chemical reaction with the car paint, it forms a dense glass protective layer (limited to inorganic coatings), which acts like a hard, transparent glass covering the car paint surface. This layer protects the paint from external factors such as extreme temperatures, acids, alkalis, UV rays, and minor scratches, while also enhancing the paint's brightness and restoring a new-car-like appearance. Below are some post-coating precautions: Avoid Rolling Down Windows: Do not roll down the windows for a week after applying the coating. In most cases, the car coating takes 5-7 days to firmly adhere to the windows. During this period, avoid rolling down the windows as much as possible to prevent displacement of the coating that hasn't fully bonded. Avoid Wiping: Do not wipe the coating for a week after application. Newly applied coatings may develop fogging or similar conditions, which is a normal part of the drying process. Such occurrences within a week to half a month are normal—simply wait for the fogging to disappear and avoid wiping. Avoid Using Sharp or Hard Tools: After applying the coating, never use sharp or hard tools to scrape or wipe it. If done carelessly, such actions can significantly reduce the coating's light transmittance.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.