What brand does the Sylphy belong to?

1 Answers
OscarFitz
07/30/25 5:11am
The Sylphy belongs to the Dongfeng Nissan brand. Taking the Sylphy 2021 Classic Manual Comfort Edition as an example, its body dimensions are: length 4631mm, width 1760mm, height 1503mm, wheelbase 2700mm, front track 1540mm, fuel tank capacity 50 liters, and trunk capacity 510 liters. The Sylphy 2021 Classic Manual Comfort Edition is equipped with a 1.6L naturally aspirated engine, with a maximum power of 90 kW and a maximum torque of 155 Nm, paired with a 5-speed manual transmission. It adopts a MacPherson independent front suspension and a torsion beam non-independent rear suspension.
Was this review help?
8
3
Share
More Forum Discussions

How to Deal with Fuel Line Leakage?

When a vehicle's fuel line is leaking, you must not continue driving to avoid potential safety hazards during operation. After discovering a fuel line leak, immediately seek assistance from professional repair shops or 4S dealerships to promptly address the issue and prevent unnecessary complications.
1
5
Share

How to adjust the throttle cable?

Canned spray-type oil film remover works very well for removing oil film. Just spray for 3 seconds within the wiper's sweeping range to remove the oil film. Remove the cap and press the bottle firmly to spray the liquid. Spray it within the wiper's operating range on the windshield, with a usage method roughly similar to the spray type.
11
1
Share

What to do if the fuel gauge doesn't move after overfilling the tank?

There is a small chip sensor at the very top of the fuel float. It might get dirty due to poor fuel quality, requiring cleaning with an eraser. After removing the instrument panel, use a multimeter and a large needle to locate and test the circuit corresponding to the fuel gauge on the panel. Then proceed with the appropriate repairs.
17
5
Share

How to Use Oil Film Remover?

Thoroughly sand the area that needs repair, then apply glue to the area that needs repair. Use an electric soldering iron to weld the damaged area. First, tilt the oil tank to temporarily stop the oil leak. Wipe the leaking area, apply glue to the leaking area, and wait for the glue to dry.
2
2
Share

How to Stop an Oil Drum Leak?

Thoroughly sand the area that needs repair, then apply glue to the area that needs patching. Use a soldering iron to weld the damaged area. Tilt the oil drum so that the leak stops temporarily. Wipe the leaking area, apply glue to the leak, and wait for the glue to dry completely.
20
5
Share

What to Do When the Fuel Gauge Doesn't Show Fuel Level?

Remove the fuel float from the fuel tank, clean it, repair it, and try again. If it still doesn't work, consider replacing it. The above phenomenon occurs due to poor contact between the main fuel level sensor and the auxiliary fuel level sensor. It is recommended to replace the relevant sensors.
7
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.