What brand are the tires on the Haoying?

1 Answers
OOmar
07/29/25 12:43pm
The tires on the Haoying are Michelin. Below is expanded information about the Haoying's tires: Haoying tire specifications: The Haoying is equipped with Michelin PILOTSPORT4 model tires, with specifications of 225/40R20. Function of tires: Car tires are one of the important components of a vehicle, directly contacting the road surface and working together with the car's suspension to mitigate impacts during driving. They ensure good ride comfort and smooth driving; maintain excellent adhesion between the wheels and the road surface; enhance the car's traction, braking, and maneuverability; and bear the weight of the vehicle.
Was this review help?
4
0
Share
More Forum Discussions

What does an average fuel consumption of 15.6L/100km mean?

It means the vehicle consumes 15.6 liters of fuel when driving 100 kilometers on the road. The fuel consumption per 100 kilometers = the volume of a certain amount of fuel (liters) ÷ the mileage covered by that fuel (kilometers). Below is relevant information: 1. Road conditions: Road conditions are an important factor affecting fuel consumption. Each vehicle has its own "economical speed," typically designed within the range of 70-90 kilometers per hour. If the vehicle can travel unimpeded in the city at this speed, the fuel consumption value should be comparable to the value measured during standard test track conditions. 2. Driving habits: If driving habits are improper, the vehicle's fuel consumption can increase significantly. With the advent of the automobile era, the number of non-professional drivers in our country has grown, inevitably bringing about a major issue: incorrect driving habits lead to increased vehicle fuel consumption.
2
4
Share

What causes the steering wheel to shake when turning right while stationary in a GL8?

Possible reasons for the steering wheel shaking when turning right while stationary in a Buick GL8 include front toe-in malfunction, loss of wheel dynamic balance weights, loose tie rods, loose wheel hub bearings, or damaged steering dampers. Below is a partial introduction to steering wheel shaking while stationary: 1. Hazards: The impact of damaged pressure bearings cannot be ignored. In minor cases, it affects comfort, increases tire noise, and causes the vehicle to pull to one side. In severe cases, it can lead to suspension damage, causing the steering system to fail and resulting in traffic accidents. 2. Wheel hub bearing issues: Loose wheel hub bearings and severe wear on the left and right steering knuckle ball joints can cause inaccurate front wheel alignment. Steering dampers: When the car is in motion, damaged or leaking steering dampers, or deformed front suspension springs can also affect the vehicle's stability.
8
5
Share

How to Replace a Dead Battery in an Audi Car Key?

Audi car key dead battery replacement method is: 1. Open the mechanical key and hold the key vertically; 2. Use a screwdriver to wedge into the gap where the key retracts; 3. Pry open the key casing; 4. Remove the old battery and replace it with a new one. Taking the Audi A3 as an example: The Audi A3 has a length, width, and height of 4343mm, 1815mm, and 1458mm respectively, with a wheelbase of 2630mm. This car is equipped with a 1.4T L4 engine, featuring turbocharged intake, delivering a maximum horsepower of 150ps and a maximum torque of 250nm. The body type is a 5-door, 5-seat hatchback, paired with a 7-speed dual-clutch transmission.
17
5
Share

What does it mean to have ETC stolen?

Having ETC stolen refers to the situation where the ETC gantry recognizes your vehicle when passing through the ETC lane, but due to slow speed, another vehicle cuts in and passes the toll entrance ahead of you. Below is some information about ETC toll collection: 1. How to prevent ETC theft: (1) Regularly check if the onboard OBU device is functioning properly. A prompt tone will be heard when the ETC card is inserted. (2) When using ETC to pass through a highway toll booth, drivers should slow down to ensure the device successfully senses the information and allows safe passage. (3) Maintain a distance of more than 10 meters between the rear vehicle and the front vehicle to avoid the front vehicle using the rear vehicle's information. 2. What to do if ETC is stolen: If your vehicle's ETC is stolen when entering the highway, and it still cannot be recognized after reversing and re-entering, you can switch to the manual lane and swipe the ETC card, and you will still be charged normally.
14
2
Share

What is the matching method for the tire pressure sensor on the Buick LaCrosse?

Buick LaCrosse tire pressure sensor matching method: 1. Press the vehicle's one-touch start button to start the vehicle engine; 2. Press the close button on the left side of the multifunction steering wheel; 3. Then press and hold the SET button on the left side of the multifunction steering wheel until a beep is heard, then release. The Buick LaCrosse has a body size of 5026mm in length, 1866mm in width, and 1462mm in height, making it a mid-size sedan. In terms of power, the Buick LaCrosse is equipped with a 2.0-liter turbocharged engine across the lineup, delivering a maximum horsepower of 241, and complies with the National VI vehicle emission standards. For tire specifications, the Buick LaCrosse uses 235/50R18 tires.
17
0
Share

Why does the sunroof fail to close and automatically rebound?

The reasons why the sunroof cannot be closed are as follows: Sunroof motor stuck or damaged: In this case, it is necessary to check the control circuit of the sunroof motor. If the control circuit is normal, a new sunroof motor needs to be replaced, and then the sunroof motor matching reset should be performed. Sunroof slide rail deformation: In this situation, it is necessary to go to a repair shop to check the degree of deformation of the slide rail to see if it can be repaired. If the deformation is particularly severe, the sunroof slide rail needs to be replaced. Sunroof control panel failure: The sunroof does not work due to a short circuit or poor connection in the integrated circuit board inside the sunroof control panel. In this case, the sunroof control panel needs to be disassembled and inspected.
7
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.