What brand are the original tires on the Nissan X-Trail?

1 Answers
LeZoe
07/30/25 5:35am
The original tires on the Nissan X-Trail are Dunlop brand tires. Tire maintenance: Maintain a safe distance when driving at high speeds, avoid unnecessary or frequent braking to reduce tire damage. For your own safety, pay attention to the tread depth of the tires. Tires that are nearly worn out have reduced friction with the road surface, resulting in longer braking distances, so avoid high-speed driving. There is a direct correlation between tire load and pressure. Overloading is similar to low pressure and can cause tire damage. Frequent overloading can reduce tire lifespan by 20%-50%. Incorrect loading methods can also lead to uneven tire load distribution, causing excessive load on individual tires and reducing their lifespan. Tire pressure is crucial for tire longevity. The inflation pressure must comply with national standards for different types and specifications of tires. Regularly check tire pressure, as both overinflation and underinflation can cause irregular wear, tread groove cracking, cord breakage, ply separation, and tire blowouts. Dunlop: Dunlop is a Japanese tire brand under the Sumitomo Group. Originally founded in Japan by the British Dunlop Company, the Dunlop rubber factory was later taken over by the staunchly right-wing Sumitomo Group during World War II after Japan declared war on Britain.
Was this review help?
10
2
Share
More Forum Discussions

How to Fix the Black Screen Issue with Mercedes-Benz Rearview Camera?

Here are the perfect solutions for the black screen issue with the Mercedes-Benz rearview camera: 1. If the rearview camera shows a black screen, it is highly likely due to poor line contact. It is necessary to promptly check the connection between the lines and the vehicle's installation, and properly secure any loose parts. 2. If the video power cord is aging, you can try replacing it with a new one. Below is some extended information about the rearview camera: 1. The car rearview camera is a vehicle system. This newly developed rearview system is intuitive and clear, providing great convenience to drivers. 2. The rearview camera allows the driver to monitor the video feed of the areas outside the vehicle's sides and rear in real-time, helping to avoid accidents and theft.
13
4
Share

How many kilometers should an AT transmission fluid be changed?

AT transmission fluid should be changed every 60,000 to 80,000 kilometers. More knowledge about AT transmissions is as follows: 1. An automatic transmission is a device that can automatically shift gears based on the vehicle's speed and engine RPM, as opposed to a manual transmission. It mainly includes four types: hydraulic automatic transmission, continuously variable transmission (CVT), electronically controlled mechanical automatic transmission, and dual-clutch transmission. 2. A hydraulic automatic transmission achieves automatic shifting through a combination of hydraulic drive and planetary gears. It generally consists of components such as a torque converter, planetary gear set, shift actuators, shift control system, and shift operation mechanism.
20
4
Share

Do car spark plugs work all the time?

Car spark plugs work continuously when the engine is running. Spark plug working principle: The spark plug's ground electrode is connected to the metal shell, which is attached to the engine block via the cylinder head threads. The insulator primarily serves to isolate the metal shell from the center electrode. The terminal nut is the part of the spark plug that contacts the high-voltage coil. When current passes through the terminal nut and center electrode, it ionizes the medium between the center electrode and ground electrode to generate a spark, thereby igniting the air-fuel mixture in the cylinder. Spark plug replacement cycle: Under normal maintenance conditions, replacement is recommended after driving 40,000-60,000 kilometers. However, this may vary depending on the brand and engine type, so it's advisable to follow the owner's manual. The following standards can be referenced for maintenance replacement: Platinum spark plugs should be replaced at 40,000 km, ordinary nickel alloy spark plugs at 20,000 km, and iridium spark plugs at 60,000-80,000 km.
4
3
Share

What is the normal amount of car battery drain?

The normal range of car battery drain current is around 45 milliamperes. Some cars have dark current, which falls within the normal range of battery drain. The specific measurement steps for checking car battery drain with a multimeter are as follows: 1. Turn off the ignition switch, all possible electrical devices, and all doors. 2. Lock the car with the remote (for smart cars, keep the smart key more than 3 meters away from the car) and wait for 5-10 minutes to allow the vehicle to enter sleep mode. 3. Loosen the screw on the negative battery terminal. 4. Switch the digital multimeter to the current measurement mode (Note: Move the test leads to the corresponding jacks). 5. Connect the red test lead (to the negative terminal clamp) and the black test lead (to the negative terminal post). 6. Slowly move the negative terminal clamp and the red test lead upward together, completely separating them from the terminal post (at this point, the black test lead should be inside the clamp). 7. Observe the current value on the series ammeter. Generally, non-smart cars should show around 0.03A (30mA), and smart cars should show around 0.05A (50mA). If the value exceeds this significantly or even doubles, it indicates an abnormality.
1
0
Share

Why is there noise in car audio?

Car audio has a buzzing sound, the reasons and solutions are as follows: 1. Poor contact of the audio cable. Check the audio cable to see if it is properly connected. Because the audio cable is most susceptible to current interference. 2. The ground wire is too long. Check the ground wire to see if it is too long (it is recommended that the ground wire be about 0.5 meters). Because the ground wire current is relatively weak, if it is too long, it is easy to produce noise. Regardless of whether the grounding surface is good or not, the ground wire must be polished and cleaned when connecting to the frame screw position, otherwise poor contact will cause current interference noise. 3. The power cable and audio cable are not routed separately. Check whether the 12V power cable and audio cable are routed separately. Because some car modification and car beauty shop workers will connect the power cable and audio cable together, which will produce current interference noise. 4. Software issues. The buzzing sound in the audio caused by software reasons, such as differences in music formats or noise introduced during recording, can be solved by trying to play music in different formats.
5
3
Share

What is the reason for the ASR light on a truck?

ASR light on indicates that there may be a fault in the vehicle's traction control system. The solutions are as follows: 1. The vehicle should be sent to a 4S shop for inspection and repair as soon as possible. Such faults are usually caused by wiring issues and require a fault diagnostic tool to identify the cause. After repair, the fault light can be cleared. 2. The ASR light may also be on because the ASR off button (ESP-OFF button) was pressed. You can try pressing the button again and check if the indicator light on the dashboard disappears. If it does not, proceed to a 4S shop for repair.
5
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.