What brand are the original tires for the Toyota Corolla?

How to Drive a Manual Transmission Car in Congested Areas?

In congested areas, the driving method for a manual transmission car is to use the half-clutch technique. The half-clutch technique refers to operating the car in idle speed in 1st gear without pressing the accelerator, controlling the speed by adjusting the depth of the clutch pedal with the left foot. A manual transmission is a manual gearbox, and its working principle is: by using the gear shift fork to change the transmission ratio of the meshing gears, thereby altering the driving torque to suit different working conditions. The method to start a manual transmission car is: 1. Fully depress the clutch pedal; 2. Push the gear lever to engage the 1st gear as the starting gear; 3. Gently press down the turn signal lever to activate the left turn signal, indicating the front and rear of the vehicle; 4. Press the horn button to alert pedestrians in front of the vehicle that you are about to start; 5. Release the vehicle's handbrake; 6. Slowly lift the left foot until the clutch is in the half-clutch state, and the vehicle begins to vibrate slightly; 7. As the vehicle starts to move, release the clutch and gently press the accelerator.

6

2

Share

What is an ngkir spark plug?

ngkir is an NGK brand iridium electrode spark plug, which is a high-performance spark plug. Below is relevant information about automotive spark plugs: 1. Replacement cycle: Automotive spark plugs, commonly known as spark plugs. Conventional spark plugs should be replaced every 20,000 kilometers, while platinum or iridium spark plugs can last up to 60,000 kilometers or more before needing replacement. 2. Types of spark plugs: Standard spark plugs, insulator-tip spark plugs, fine-wire spark plugs, tapered-seat spark plugs, multi-ground spark plugs, and surface-gap spark plugs. 3. Function of spark plugs: The role of a spark plug is to discharge the high-voltage pulses delivered by the ignition cable (spark plug wire), breaking down the air between the two electrodes of the spark plug to generate an electric spark, thereby igniting the air-fuel mixture in the cylinder.

18

3

Share

Why is a car considered totaled when submerged in water?

The specific reasons why a car is considered totaled when submerged in water are as follows: 1. Engine damage: When a vehicle is submerged, water can enter the cylinders through the intake manifold. Due to the incompressibility of water, the piston's movement will be shortened, leading to bending or breaking of the engine connecting rods. In extreme cases, the broken connecting rods can pierce through the engine block. The reason a car stalls in water is that water entering the distributor cap disrupts the normal ignition function, and the engine air filter element getting soaked increases intake resistance and allows water to enter the combustion chamber, preventing the spark plugs from igniting. Attempting to restart the engine under these conditions can easily cause a hydro lock. 3. Compromised engine oil performance: If water enters the engine, it will also mix with the engine oil, causing the oil to degrade and lose its original properties. This means the oil can no longer perform its functions of lubrication, cooling, sealing, and corrosion prevention, ultimately harming the engine.

3

4

Share

What does the P0137 trouble code mean?

P0137 trouble code indicates a low voltage in the oxygen sensor circuit. Here is an introduction to automotive oxygen sensors: 1. Cause of the fault: The oxygen sensor fault code appears due to contamination of the oxygen sensor, crossover between the oxygen sensor's signal and ground circuits, short circuit in the oxygen sensor signal circuit, failure of the oxygen sensor itself, or electronic control module failure. 2. Function: It measures the oxygen content in the engine exhaust. The ECU controls or adjusts the engine's fuel injection quantity based on the sensor's readings to achieve better fuel economy. Typically, the ECU maintains the oxygen sensor's temperature by controlling the heater's switch. If the oxygen sensor fails to reach the required temperature within the specified time or cannot maintain the set temperature, the trouble code will appear.

9

3

Share

Can You Put Seat Covers on Genuine Leather Car Seats?

You can put seat covers on genuine leather car seats. The method for cleaning genuine leather seats is as follows: 1. Spray an appropriate amount of leather cleaner onto the seats to cover the leather surface; 2. Wait for about 3 to 5 minutes to allow the leather cleaner to fully dissolve stains; 3. Use a soft dry cloth to wipe away the stains and leather cleaner. The maintenance of genuine leather seats includes: 1. Keep car leather seats away from heat sources, as being too close to heat can cause the leather to crack; 2. Avoid prolonged exposure to direct sunlight to prevent the leather from fading; 3. Regularly clean and maintain the seats by wiping off dust with a semi-dry damp cloth to keep them dry and tidy; 4. Use a small amount of multi-purpose foam cleaner for cleaning and ensure the leather surface remains dry; 5. When sitting on the leather seats, avoid contact with items like keychains or metal buttons on clothing to prevent scratches; 6. Prevent liquids from soaking into the seats; 7. Use a car vacuum cleaner to clean the surface.

6

3

Share

How Long After Applying Car Window Tint in Summer Can It Be Used Normally?

After applying car window tint in summer, it can generally be used normally after 5-7 days. Below is relevant information about car window tinting: 1. Concept: Car window tinting (Auto-film) involves applying a thin film-like material to the vehicle's front and rear windshields, side windows, and sunroof. This film-like material is also known as solar film or heat-insulating film. 2. Functions: It blocks ultraviolet rays, reduces heat, prevents injuries from shattered glass, and reduces glare. Additionally, due to the one-way transparency feature of the solar film, it helps protect personal privacy. Furthermore, it can minimize damage to interior items and passengers caused by UV exposure. Through physical reflection, it lowers the interior temperature, reduces the need for air conditioning, thereby decreasing fuel consumption and saving costs.

13

3

Share

What brand are the original tires for the Toyota Corolla?

How to Drive a Manual Transmission Car in Congested Areas?

What is an ngkir spark plug?

Why is a car considered totaled when submerged in water?

What does the P0137 trouble code mean?

Can You Put Seat Covers on Genuine Leather Car Seats?

How Long After Applying Car Window Tint in Summer Can It Be Used Normally?

Can I directly apply for the A3 license?

What Causes the Water Temperature Warning Light to Illuminate?

What are the symptoms of using low-quality fuel in a car?

What to Do If Paint Sticks to the Car?