What Beginners Must Know About Taking the Driver's License Test

1 Answers
DelArcher
07/29/25 6:37pm
For the beginner's driver's license test, you need to prepare for four exams: Subject 1, Subject 2, Subject 3, and Subject 4. Below is an introduction to the preparation materials for the driver's license test: 1. Subject 1 Notes: For the Subject 1 exam, it is essential to download an app, with 'Driving School YDT' being highly recommended. Be meticulous, read the questions carefully multiple times to avoid pitfalls, and practice with numerous mock tests to estimate your exam score. 2. Subject 2 Notes: The Subject 2 exam consists of five items: reverse parking, parallel parking, slope driving, curve driving, and right-angle turns. Among these, reverse parking is the most challenging, while right-angle turns and curve driving are the simplest. Typically, allocate one week to practice reverse parking, another week for the other items, and the final week for combined practice of all items. Subject 2 requires attention to many details, primarily mastering the 30-centimeter practice, which makes other items relatively easier. Ensure accurate observation of reference points; clarity on these points is crucial to avoid mistakes during the exam. 3. Subject 3 Notes: Memorize the test route map, anticipate potential scenarios at the test site, and make pre-judgments. Before the exam, sketch the test site map, noting intersections, where to pull over, and straight-line driving, mentally preparing for appropriate reactions during the test. 4. Subject 4 Notes: The Subject 4 exam shares similar preparation tips with Subject 1, and again, the 'Driving School YDT' app is recommended to ensure a straightforward and passable experience.
Was this review help?
8
4
Share
More Forum Discussions

Can the Car Windshield Washer Reservoir Freeze and Break?

When the windshield washer fluid freezes, the reservoir can easily be damaged by the cold. Not only that, but it can also cause the hoses to crack. Additionally, if the driver continuously tries to spray the windshield by pulling the washer lever, it may lead to the motor burning out. In severe weather conditions, this can also affect driving safety by obstructing the view of the road ahead. Antifreeze Windshield Washer Fluid: During winter, it is essential to use antifreeze windshield washer fluid. It is best to choose a fluid with a freezing point at least 10 degrees lower than the lowest expected temperature to ensure it does not freeze. Choosing High-Quality Washer Fluid: Low-quality washer fluids may precipitate, change color, or develop odors. They often contain high levels of alcohol, which can damage the car's paint, cause rubber components to swell and dissolve, and reduce their hardness.
14
3
Share

Should Anti-Skid Be Turned On or Off in Snowy Weather?

When driving in snowy conditions, the anti-skid function should be turned on. This feature is enabled by default and does not require manual operation. Inside the vehicle, there is a button with the car skid symbol, which is used to turn off this function. Vehicle Anti-Skid System: The vehicle anti-skid system, also known as the traction control system, prevents the drive wheels from slipping when starting or accelerating, maintaining the stability of the vehicle's direction of travel. Function of Vehicle Anti-Skid: It prevents the drive wheels from slipping during acceleration, especially on special road surfaces with low friction such as rain, snow, hail, or icy roads. When the car accelerates, it controls the slip rate within a certain range to prevent rapid slipping of the drive wheels.
12
5
Share

Can You Still Drive When Mercedes Shows Brake Pad Wear?

Mercedes showing brake pad wear can still be driven for about one hundred kilometers. Car brake pads refer to the friction materials fixed on the rotating brake drum or brake disc of the wheel. The friction linings and friction blocks within them withstand external pressure, generating friction to achieve the purpose of vehicle deceleration. Check the brake fluid level: Open the engine compartment and check if the brake fluid level is at the normal position. Remove the tire: Use a jack to lift the bottom of the car. When the tire is completely off the ground, it can be removed. Remove the brake pads: Use a wrench combined with a socket to remove the bolts of the brake caliper, then directly take off the brake pads. Replace with new brake pads: Push the brake piston back in and install the new brake pads.
6
4
Share

Where is the oil filter located on the Mazda6 Atenza?

The oil filter on the Mazda6 Atenza is located underneath the engine. The oil filter, also known as the oil cleaner, functions to remove impurities, gum, and moisture from the engine oil, delivering clean oil to all lubrication points. Taking the 2020 Mazda6 Atenza as an example, its body dimensions are: length 4870mm, width 1840mm, height 1445mm, with a wheelbase of 2830mm, a minimum ground clearance of 162mm, and a fuel tank capacity of 56.2 liters. The 2020 Mazda6 Atenza is equipped with a 2.0L naturally aspirated engine, delivering a maximum power of 116kW and a maximum torque of 202Nm, paired with a 6-speed automatic transmission.
17
2
Share

Can the Volkswagen Talagon Handle Off-Road Driving?

The Volkswagen Talagon is capable of off-road driving. It offers 7 driving modes to choose from, allowing it to easily adapt to various road conditions. This ensures optimal performance in terms of off-road capability, fuel efficiency, and driving comfort across different scenarios. Regarding body dimensions: The Volkswagen Talagon measures 5152mm in length, 2002mm in width, and 1792mm in height, with a wheelbase of 2980mm. In terms of powertrain: The Talagon is equipped with an EA888-DPL 2.0T engine, delivering maximum power outputs of 186 horsepower and 220 horsepower, with peak torque of 320 Nm and 350 Nm respectively. It is paired with a 7-speed wet dual-clutch transmission.
12
0
Share

Where is the engine number located on the Santa Fe 2.7?

The engine number of the Santa Fe 2.7 is located at the lower left side of the engine block, typically consisting of a combination of 7 to 8 digits and letters. In addition to the above method, the engine number can also be found through the following 4 ways: The vehicle's driving license displays the engine number, usually located on the second-to-last line; The motor vehicle registration certificate records the engine number; The car purchase invoice includes the engine number; The vehicle purchase tax payment certificate states the engine number. It is important to note that the engine number is not the same as the engine model. The engine model refers to the specifications and size of the engine within the manufacturer's lineup, and engine models can be the same. The engine number, however, refers to the production serial number of the engine. Each engine can only have one unique engine number, and no two engines share the same number.
9
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.