What are the voice commands for Stage 3 lighting test?
4 Answers
Stage 3 lighting voice commands are as follows: 1. High beam: Driving at night on roads without streetlights or with poor illumination. 2. Low beam: Meeting non-motor vehicles on narrow roads at night, following vehicles closely in the same direction at night, and meeting vehicles at night. 3. Alternating between high and low beams: Passing through arches and crosswalks at night, navigating sharp turns and slopes at night, and crossing intersections without traffic signals at night. 4. Hazard warning lights: Vehicle breakdown on the road at night that obstructs traffic and is difficult to move, and driving in foggy conditions. Additional information: During the test, there will be voice prompts for lighting usage. Operations must be completed within 5 seconds after the voice prompt ends. Do not act too slowly, but also do not act before the prompt finishes.
I remember when I was taking the third driving test, the voice commands for the lighting exercises were a real headache for beginners. For example, the examiner would say 'simulate driving under poor nighttime lighting conditions,' and I had to immediately turn on the low beams. When 'approaching a sharp curve ahead,' I had to flash the high and low beams alternately to warn others. 'Meeting another vehicle' required switching to low beams to avoid glare. The 'overtaking' maneuver involved first signaling left and then flashing the high beams, followed by signaling right after completing the overtake. And for 'temporary parking,' I had to turn on the parking lights and hazard lights. During the test, I was so nervous, afraid that any delay in flashing the lights would cost me points. Looking back, these command drills are crucial—they help build good habits and reduce nighttime accidents. For practice, I recommend having someone simulate the commands frequently to get familiar with them. Once you're used to it, you won't panic, because safe driving is a serious matter.
As a seasoned driver with years of experience, the lighting commands in Subject 3 simulate real-life scenarios. 'Driving at night on well-lit roads' requires turning off the high beams; 'close-range following ahead' mandates using low beams; 'passing through a crosswalk' necessitates flashing lights alternately to alert pedestrians; 'unlit roads' call for high beams; and 'simulating a breakdown' requires activating the hazard warning lights. These practices aren't just for the test—they're essential for daily driving. Proper light operation is crucial for safety, especially at night to prevent collisions. When preparing for the test, it's best to review the common command list for your local exam and practice reaction speed. Mastery ensures you won't fumble during the actual test.
The Stage 3 lighting voice commands are quite straightforward. During the test, 'poorly lit road' requires low beam; 'sharp curve section' needs alternating between high and low beams; 'following or meeting another vehicle' uses low beam to avoid glare; 'overtaking process' involves turning signals and flashing lights; 'temporary stop' switches to parking lights and hazard lights. The key is to listen carefully to the commands and act without hesitation. Common mistakes include delayed flashing or incorrect use of high beams—just remember the rules.
