What are the tips for using the M gear in a manual-automatic transmission?

1 Answers
VanEllie
07/29/25 3:36pm
The tips for using the M gear in a manual-automatic transmission are: 1. Step on the car's brake pedal; 2. Press the car's one-touch start button; 3. The car's instrument panel lights up, and the vehicle starts; 4. Place the car's automatic gear lever in the M gear position to enter manual mode; 5. Push the car's gear lever forward once to increase one gear; 6. Pull the car's gear lever backward once to decrease one gear; 7. Gently step on the car's accelerator, and the vehicle will start moving. A manual-automatic transmission car refers to a car equipped with a manual-automatic transmission, which combines manual shifting and automatic shifting modes. On this type of transmission, there are clear plus and minus signs, allowing manual gear shifting in this position.
Was this review help?
17
1
Share
More Forum Discussions

How Long Does It Take for a Car Battery to Drain If the Lights Are Left On?

The time it takes for a car battery to drain if the lights are left on depends on the specific situation: 1. For small lights with low power consumption, it takes about one night; 2. For two car lights, it takes about 8 hours; 3. For front LED headlights, it takes about 14 hours. The correct method for using car lights is: 1. Turn the left light control switch forward one notch for small lights; 2. Turn it forward two notches for low beams; 3. Push the light control lever forward once for high beams; 4. Lift the light control lever forward once for the right turn signal. Precautions for using car lights include: 1. Turn on low beams when driving at night; 2. Do not use high beams when driving closely behind another vehicle in the same direction; 3. When passing sharp curves, slopes, arched bridges, crosswalks, or intersections without traffic lights at night, alternate between high and low beams to signal.
14
1
Share

Does the Toyota C-HR automatically lock the doors after exiting the vehicle?

Toyota C-HR does not automatically lock the doors after exiting the vehicle. Below is relevant information about car doors: 1. Opening methods: They are divided into conventional-opening doors, reverse-opening doors, and horizontally-sliding doors. Conventional-opening doors can still be closed by air pressure while the car is moving, which is safer, and it's easier for the driver to observe backward when reversing, so they are widely used; reverse-opening doors, if not closed properly while the car is moving, may be blown open by oncoming airflow, so they are less commonly used, generally only adopted to improve entry/exit convenience or for ceremonial purposes; horizontally-sliding doors have the advantage of being able to fully open even when the side of the car is close to an obstacle. 2. Composition: Car doors are generally composed of three parts: the door body, door accessories, and interior trim panels. The door body includes the inner door panel, outer door panel, door window frame, door reinforcement beam, and door reinforcement panel; door accessories include door hinges, door opening limiters, lock mechanisms, inner and outer handles, door glass, window regulators, and sealing strips.
10
2
Share

Why Are Used Vianos So Cheap?

1.Discontinued or Out of Production: The Viano model has been completely discontinued or out of production, so there is no reference price for new vehicles; 2.Longer Usage Years: The used Viano models available are only those produced before the discontinuation, which means they have been used for a longer period, at least 5 years or more; 3.Price: The new Mercedes-Benz Vito, a similar model to the Viano, has a relatively lower price, which serves as a reference for the used car market, naturally making the used Viano cheaper. More related information is as follows: 1.Introduction: The Viano, an MPV business model from Fujian Benz, has not achieved high sales since its launch, according to sales data from Fujian Benz. Positioned as a high-end business vehicle with a relatively high price, the Viano's sales further declined, even described as dismal, with Fujian Benz's annual sales in 2013 being only 12,000 units. 2.Models: The Viano model versions ranged from the 2010 edition to the 2015 edition, meaning five different versions were updated over five years before being discontinued. It was also observed that the prices of these five versions gradually increased, with a 31% rise from the 2010 to the 2015 models.
20
4
Share

What to Do If a Piece of the Tire Sidewall Falls Off?

Tire sidewall falls off a piece of the treatment method is to replace the new tire as soon as possible, the role of the tire is: 1, to ensure that the car has a good ride comfort and driving smoothness; 2, to ease the impact of the car driving; 3, to ensure that the wheels and the road surface has a good adhesion, improve the car's traction, braking and passability; 4, to bear the weight of the car. The precautions for the use of tires are: 1, the car should not start too fiercely, should start smoothly at low speed; 2, driving on good roads should keep straight ahead and not swing left and right and make sharp turns; 3, when the vehicle is going down a long slope, the speed should be properly controlled according to the size of the slope, length and road conditions; 4, when the vehicle is going uphill, it should make full use of the inertia to drive, shift gears in time and change gears in time.
8
4
Share

What are the reasons for a car's one-button start not working?

The reasons for a car's one-button start not working are: 1. The gear is not in P position; 2. The key's radio waves are being interfered with; 3. The brake pedal is not pressed; 4. Quality issues with the car itself. The functions of the one-button start include: 1. Enabling start and shutdown; 2. Fully intelligent sensing start; 3. Intelligent sensing entry; 4. Intelligent sensing door closing; 5. Smart identity recognition between the driver and the car; 6. Anti-theft design that cuts off fuel and power. The steps to start the car with one-button start are: 1. When the driver sits in the cockpit, press the start button for the car to perform a self-check; 2. Press the brake pedal and press the one-button start button to ignite; 3. Press the foot brake, shift to D gear, and release the handbrake to start.
16
2
Share

What to Do If You React Slowly in Subject 3?

Be sure to stay relaxed and natural. The purpose of this is to accurately control the steering angle. Additionally, if you encounter unusual traffic conditions ahead, do not panic or become flustered, as this can easily lead to unconsciously gripping the steering wheel too tightly, which may cause the vehicle to veer off course. More relevant information is as follows: 1. Keep your hands steady while practicing: Your hands are not only responsible for controlling the steering wheel but also for many other operations, such as pulling the handbrake and shifting gears. When performing hand movements, ensure they are steady. Avoid gripping the steering wheel too tightly, as this can easily lead to veering. The common steering wheel grip is to place your hands at the 3 o'clock and 9 o'clock positions, staying relaxed and natural. This helps in accurately controlling the turning angle. Moreover, if you encounter unusual traffic conditions ahead, do not panic or become flustered, as this can easily lead to unconsciously gripping the steering wheel too tightly, which may cause the vehicle to veer off course. 2. Keep your feet flexible: Clearly remember the positions of the clutch, brake, and accelerator pedals. Some students often confuse the accelerator and brake pedals, mistakenly pressing the accelerator instead of the brake. When not accelerating, place your right foot on the brake pedal. Ensure your foot posture is correct. Use your heel as a pivot point, with the ball of your foot pressing the pedal. After pressing the pedal all the way down, make sure your leg is bent, allowing for smooth and easy pedal operation. Under the guidance of your instructor, familiarize yourself with the pedal sensitivity of different vehicles, especially the clutch. Remember, the clutch in the test vehicle may differ from that in the practice vehicle. Learn to recognize the vehicle's state when the clutch is in the semi-engaged position. In daily practice, besides coordinating your hands and feet, pay attention to observing more to master various driving skills flexibly.
13
5
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.