What are the three dashed line techniques for reverse parking?

1 Answers
ElliottRose
07/24/25 11:00am
Here are the three dashed line techniques for reverse parking: 1. Adjust the initial position before reversing: Before reversing into the parking space, pull the car to a suitable position, observe the distance between the car body and the sideline, and ensure the car is aligned. 2. Maintain a distance of about 30cm between the car body and the parking corner: When the right rear wheel passes the corner and enters the parking space, if the distance between the right rear wheel and the sideline is more than 30cm, the left rear corner of the car will hit the infrared line in the test area. 3. Slow down and adjust the car body: When half of the car body is already in the parking space and the steering wheel is straightened, timely adjustments should be made if the car body is tilted. At this time, observe through the rearview mirror the distance between the rear of the car and the sideline, and turn the steering wheel towards the side with a larger distance. Therefore, the speed should be slow to facilitate adjusting the car body to be parallel to the sideline.
Was this review help?
2
2
Share
More Forum Discussions

What is the check brake light warning light?

check-brake-light is the brake system warning light. Here is relevant information: 1. Constant illumination: Normally lights up when turning on the ignition, pressing the brake pedal, or engaging the handbrake. If it stays on for prolonged periods, it indicates potential issues with the braking system. You should check if the brake fluid level is sufficient. If insufficient, inspect the brake calipers and brake lines for leaks. 2. Weak braking: If you feel reduced braking power or insufficient braking force, it suggests air in the brake system. Check the vacuum booster for leaks. Brake lights are generally installed at the rear of vehicles with red lenses to enhance light penetration, making it easier for following vehicles to detect braking even in low visibility conditions, thereby helping prevent rear-end collisions.
3
5
Share

Does driving with car tires in water during rain have any impact?

Driving with car tires in water during rain has no impact. Below are specific explanations regarding car tires in water during rain: 1. Reason: Tires are made of rubber, which does not dissolve in water or undergo chemical reactions with water. Therefore, soaking tires in rainwater for a day has no effect. 2. Impact: If there is accumulated rainwater in low-lying areas, it is best to park elsewhere, as deep water immersion can reach the wheel bearings, causing the grease inside to deteriorate and damage the bearings. Additionally, rainwater has certain corrosive properties and can react chemically with impurities stuck on the tires, leading to surface corrosion. Frequent soaking in rainwater can also cause the rubber to soften, deform, and age prematurely due to thermal expansion and contraction, increasing driving safety hazards.
13
3
Share

Is it mandatory to issue the driver's license within 24 hours after passing Subject 4?

It is not mandatory to issue the driver's license within 24 hours after passing Subject 4. Here are the relevant details: 1. After passing Subject 4: There are generally two modes of receiving the driver's license. One is waiting for one or two hours after the exam, and those whose names are called can collect it; or the staff may lead the drivers in a swearing-in ceremony before issuing the license. Otherwise, it will be mailed to the student the next day. 2. Note: After receiving the driver's license, it means you have obtained the driving qualification for the corresponding vehicle type. Generally, you can start driving immediately. However, for safety reasons, it is advisable to practice on less crowded roads first and gradually move to busier areas after becoming familiar with the roads.
20
2
Share

Does Sun Exposure Affect the Car?

Extended exposure to sunlight can cause a certain degree of damage to the car's rubber components, paint, and plastic interiors. Below is an introduction to the effects of prolonged sun exposure on cars: 1. Harmful Effects: The primary impact of prolonged sun exposure is the generation of harmful gases. Since most interior materials are made of plastic or leather, prolonged exposure can produce hazardous substances such as formaldehyde. If you enter the car and turn on the air conditioning immediately without opening the windows, these harmful gases will be inhaled, posing health risks. 2. Precautions: Car owners should take measures to protect their vehicles from the sun. When parking, try to choose shaded areas. For long-term storage, consider using a protective car cover.
12
4
Share

What Causes Inner Edge Wear on Rear Tires?

The causes of inner edge wear on rear tires are as follows: 1. If both edges of a tire show regular and roughly equal severe wear (excluding leaf spring issues), it is caused by insufficient tire pressure: Check and replenish tire pressure. 2. If all tires exhibit regular wear on one side edge, this indicates damaged thrust rod bushings: Replace with qualified tires promptly. 3. Poor road conditions where the tire tread pattern is unsuitable for specific surfaces; improper user maintenance, mixed tire installation, or untimely rotation: Replace bushings, adjust wheelbase, and ensure bushings are replaced periodically or based on mileage.
18
0
Share

What does CBS linked braking mean?

CBS linked braking means that both the front and rear brakes can be activated simultaneously during braking. Here are the relevant details: 1. Definition: The CBS system is a braking system that links the front and rear wheels together during braking. Compared to the ABS braking system, the CBS braking system has a simpler structure and a clear price advantage. 2. Principle: The CBS distributor is equipped with a delay spring. When the operating force applied to the cable is greater than or equal to the combined force of the piston spring and the delay spring, the cylinder piston on the CBS distributor starts to work, activating the front brake to begin braking. This is the working principle of the CBS system.
13
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.