What are the techniques for left and right reverse parking?

1 Answers
JamesFitz
07/25/25 12:27pm
The techniques for left and right reverse parking are as follows: 1. Adjust the rearview mirrors: First, adjust the left and right rearview mirrors of the vehicle to an angle where the rear wheels of the vehicle can be seen. Then, at the corner of the garage where you are preparing to reverse into, draw a circle with a diameter of approximately 800mm centered on the corner. Next, you can proceed to practice reverse parking. 2. Observe the rear wheels of the vehicle: While reversing, observe the position of the rear wheels through the rearview mirrors. When the rear wheels press into the circle, you need to straighten the steering wheel at this time, and then continue to reverse. If the reversing space is not very sufficient, you can move the vehicle forward or backward to make appropriate adjustments. However, when moving, try to keep the rear wheels from leaving this circle.
Was this review help?
9
3
Share
More Forum Discussions

How to Replace the Remote Battery for Toyota Vios?

Toyota Vios remote battery replacement steps: 1. Use a tool to pry open the car key shell, and you can see the battery inside after opening; 2. Take out the old battery and install the new one; 3. Finally, close the car key shell. The Vios is a compact sedan under Toyota, with dimensions of 4435mm in length, 1700mm in width, and 1490mm in height, and a wheelbase of 2550mm. The Vios is equipped with a 1.5-liter naturally aspirated four-cylinder engine, which delivers 110 horsepower and a maximum torque of 138 Nm. The engine's maximum power is achieved at 6000 rpm, and the maximum torque is reached at 4200 rpm. This engine features an aluminum alloy cylinder head and block.
8
5
Share

What situations can cause excessive cylinder pressure?

Causes of excessive cylinder pressure: 1. Increased carbon deposits in the combustion chamber reduce the combustion chamber volume and increase the compression ratio, creating a false impression of high cylinder pressure; 2. Overly rich air-fuel mixture in the combustion chamber or excessively low engine temperature, as well as poor exhaust flow or clogged catalytic converter can also lead to excessive cylinder pressure; 3. High or low cylinder pressure directly affects the temperature at the end of compression. If the compression pressure is high, the temperature of the compressed air-fuel mixture or pure air will also rise. In this case, gasoline engine fuel is more easily ignited by the spark plug, while diesel engines may experience spontaneous combustion.
6
4
Share

Where is the defogging button on the Volkswagen Lavida?

The defogging button on the Volkswagen Lavida is located on the air conditioning panel, featuring a rectangular shape with a steam symbol. In winter, using hot air for defogging works by blowing hot air from the air conditioner to clear the fog on the windows. However, hot air defogging does not take effect immediately. When you first use hot air to blow on the windows, the fog on the windows may initially increase because the hot air enlarges the temperature difference between the inside and outside of the car. But after a while, the moisture on the windows will be dried, and the fog will disappear. The Lavida is a compact sedan under the Volkswagen brand, available in both hatchback and sedan versions. The sedan version has a wheelbase of 2688 mm, with length, width, and height dimensions of 4670 mm, 1806 mm, and 1474 mm, respectively.
19
3
Share

Where is the cabin air filter located in the Volkswagen CC?

The cabin air filter in the Volkswagen CC is located behind the glove compartment on the passenger side. The owner needs to lower their head into the footwell area below the passenger seat and look upwards to spot two plastic screws. After unscrewing these screws, the foam padding can be removed, revealing the lower cover of the cabin air filter. Push this cover towards the right side (in the direction of vehicle travel) until it reaches its limit, then the cabin air filter can be pulled out. The Volkswagen CC is a mid-size sedan produced by FAW-Volkswagen. In terms of body dimensions, the vehicle measures 4,812 mm in length, 1,855 mm in width, and 1,417 mm in height, with a wheelbase of 2,712 mm.
12
1
Share

How to Reset the Service Light on a Skoda Octavia?

Steps to reset the service light on a Skoda Octavia: 1. Turn off the ignition switch and shut down the vehicle; 2. Use your left index finger to press and hold the "0.0" button located below the instrument panel; 3. With your right hand, turn on the ignition switch. Note that your left hand must continue to hold the "0.0" button until the instrument panel displays a confirmation to reset the service data, then release the button; 4. After releasing, press the "0.0" button below the instrument panel once more to reset the service light. The Skoda Octavia is a compact sedan under the Skoda brand, with a wheelbase of 2686 mm, and dimensions of 4675 mm in length, 1814 mm in width, and 1460 mm in height. In terms of power, the Skoda Octavia is equipped with three engines: a 1.5L naturally aspirated engine, a 1.2L turbocharged engine, and a 1.4L turbocharged engine. The 1.5L naturally aspirated engine delivers 113 horsepower and a maximum torque of 145 Nm, the 1.2L turbocharged engine produces 116 horsepower and a maximum torque of 200 Nm, and the 1.4L turbocharged engine offers 150 horsepower and a maximum torque of 250 Nm.
1
3
Share

How to Handle a Traffic Accident for Beginners

Methods for beginners to handle a traffic accident: 1. In case of minor collisions, stop the vehicle promptly and set up a warning triangle behind the car. This is essential to alert other passing vehicles and prevent secondary accidents. 2. Exchange and check each other's documents, including driver's license and vehicle registration. If any documents are incomplete, it is advisable to call the police to avoid further complications. 3. Take photos for evidence. For minor collisions, take clear photos of the license plate numbers, with one photo from the front and one from the rear of the vehicles. Also, photograph the details of the collision and any skid marks, which will help the traffic police determine liability. 4. If traffic is heavy, after recording all relevant evidence, move the vehicles to a location that does not obstruct traffic and wait for the police to arrive. If opting for a private settlement, also move the vehicles to a place where they do not hinder traffic.
10
4
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.