Browse

Antiques Collectibles Apparel Baby Kids Items Books， Movies And Music Electronics Free Stuff Garden Outdoor Health Beauty Home Goods Home Improvement Supplies Musical Instruments Office Supplies Pet Supplies Sporting Goods Ticket Toys Games Transportation Others

Used Cars New Cars Others

Business Crafts Design And Web Events Home Improvement Legal Lessons Personal Pets Photography Repair And Technical Support Wellness Writing， Translation， And Transcription Others

Activities & Groups Artists & Musicians Classes & Lessons Events Friendship & Networking Lost & Found Rideshare Sports Teams Volunteers Travel & Travel Partners Skills & Language Swap Other

What are the symptoms of wear on the scooter's rear clutch shoes?

1 Answers

JourneyFitz

07/30/25 10:24am

There will be a situation where the motorcycle revs up but fails to accelerate, eventually coming to a complete stop. Below are the relevant details. Introduction: The rear clutch shoes of a scooter are part of the automatic centrifugal dry shoe clutch, which functions to automatically control the engagement and disengagement of the clutch based on the engine's RPM, thereby driving the rear wheel to rotate. Principle: From a principle standpoint, the motorcycle clutch is a device located between the engine and the transmission. Its primary function is to transmit or cut off the engine's power. The purpose of transmitting power is to propel the vehicle forward, while cutting off power is typically for easier gear shifting, as without disengaging the power, it is difficult to synchronize the driving and driven gears inside the transmission, making gear shifting challenging.

Was this review help?

12

0

Share

More Forum Discussions

What causes the fuel gauge to show less than full when the tank is actually full?

Reasons why the fuel gauge shows less than full when the tank is actually full: 1. There may be an issue with the fuel level sensor, usually caused by poor contact. Check whether the fuel float can send normal signals. Remove it and move the float to the highest position to see if the fuel gauge indicates full. Determine whether the fault lies with the gauge or the float and replace accordingly. 2. The fuel gauge may be inaccurate. Check if the instrument circuit has been modified. Visit a 4S shop to verify whether the gauge pointer can reach the maximum line and if the indication is accurate. 3. The fuel gauge pointer may be stuck, in which case the entire instrument must be replaced. Gasoline is a volatile, flammable hydrocarbon mixture liquid obtained from petroleum through fractionation, cracking, or pyrolysis, and it is used as fuel.

What Causes Water in the Engine Cylinder?

Reasons for water entering the engine cylinder: Water entering through the air filter: If the engine only has a mixture of water vapor entering through the air filter, the issue is minor and can be resolved with simple treatment. Small amounts of water in the oil or fuel: There may be small amounts of water in the oil or fuel, requiring an oil change and cleaning of related engine components. Minimal water in the engine: If there is more water but not a significant mixture, and the car hasn't been started, the engine won't be damaged. In this case, the water needs to be drained, the interior cleaned thoroughly, reassembled, and the oil replaced. Significant water in the engine: If there is a significant amount of water in the engine and it cannot run after starting, the only options are to replace the engine or scrap the car entirely.

Is the Daytime Running Light Displayed on the Dashboard?

Daytime running lights do not have an icon on the dashboard, and no indicator light will illuminate on the dashboard when they are turned on. Function of daytime running lights: They serve as a signal while driving, without providing illumination, making the vehicle more easily recognizable during daytime driving. When the car engine starts, the daytime running lights automatically turn on and gradually increase in brightness to attract the attention of other motor vehicles, non-motor vehicles, and pedestrians on the road. Definition of daytime running lights: There are generally two, with the outer one being the light switch. Daytime running lights, also known as DRLs, are installed on the front sides of the vehicle to signal its presence during the day. When the car engine starts, the daytime running lights automatically turn on and gradually increase in brightness to attract the attention of other motor vehicles, non-motor vehicles, and pedestrians on the road.

What maintenance items are required for a car with over 50,000 kilometers?

Maintenance items required for a car with 50,000 kilometers: 1. Spark plugs: The replacement cycle depends on the material, generally ranging from 2 to 4 years; 2. Air filter: If it hasn't been replaced for a while, it should be replaced now; 3. Belts and chains: If the vehicle's engine uses a timing belt, it should be inspected or replaced at 50,000 kilometers. If the engine uses a timing chain, inspection is sufficient without replacement; 4. Engine oil and oil filter: Under high temperature and high pressure conditions in the engine, the shelf life of engine oil is significantly reduced, and its performance declines sharply. Over time, it fails to protect the engine effectively.

Can the Kawasaki Z900 carry a passenger?

Kawasaki Z900 cannot carry a passenger. Motorcycle working principle: When the pedal is depressed, the mechanism pressurizes the spring, causing the outer edge of the spring to lift and separate the pressure plate from the friction plate. At this point, the friction plate and flywheel are no longer connected, so even if the engine continues to run, power will not be transmitted to the gearbox and wheels. This allows the rider to shift gears or come to a complete stop without stalling the engine. Power transmission: When the crankshaft speed is low, the two friction plates cannot contact the housing, preventing power transmission. At high crankshaft speeds, centrifugal force causes the friction plates to move outward and engage with the housing, enabling power transmission.

What is the recommended speed for a new car during the break-in period?

For a new car during the break-in period, it is recommended to maintain a speed between 70 to 80 kilometers per hour, with the engine speed not exceeding 2,200 RPM. The break-in period for a new car is necessary because many components have not undergone prolonged coordinated operation after production. Although the car has undergone initial running-in, the surfaces of the parts are still relatively rough. During the break-in period, the following points should be noted: 1. Engine warm-up: When starting the car cold, it is best to wait until the coolant temperature reaches at least 40 degrees Celsius before driving; 2. Driving control: For a car in the break-in period, it is essential to control the driving speed and avoid high speeds; 3. Frequent gear changes: Do not use a single gear for extended periods. Start in a low gear and gradually shift to higher gears, driving progressively.

Trending Ranking

What is the emission standard for the 2009 Buick Excelle?

What is the tire specification model of the Regal?

What is the pass rate for the first attempt at the Driving Test Part 3?

How Many Liters of Antifreeze Should Be Added to a Family Car?

Can a Dash Cam Pick Up Sounds Inside the Car?

How to Fold Up the Rear Seats in Cadillac XT4?

What is the replacement interval for Mazda6 brake pads?

Where is the air conditioning filter of Dongfeng Tianjin located?

What is the fuel tank capacity of the Chery Tiggo 8?

Is China IV actually China V?

More Forum Discussions

How Long Does It Take to Learn Car Wrap and Color Change?

How to Use the Cigarette Lighter in an Audi Car?

What are the body dimensions of the Binyue?

How to Clean the Sunroof Drain Pipe of the Envision?

Help

Cookie

Cookie Settings

© 2025 Servanan International Pte. Ltd.