What are the symptoms of automatic transmission clutch slipping?

2 Answers
FernandoMarie
08/28/25 8:01am
Automatic transmission clutch slipping symptoms are as follows: 1. When pressing the accelerator pedal to start, the engine speed rises quickly but the vehicle speed increases slowly. 2. When trying to accelerate to overtake during driving, the engine speed increases but the vehicle speed improves very slowly. 3. When going uphill or under heavy load, the engine speed is very high but lacks power. The reasons for automatic transmission clutch slipping are as follows: 1. Incomplete clutch pedal operation leads to clutch slipping. 2. Prolonged use of the clutch disc causing wear and sintering prevents the clutch from being properly engaged, resulting in slipping. 3. Damage to the clutch actuator may also cause clutch slipping.
Was this review help?
9
2
Share
LawsonMarie
09/10/25 6:09am
As a seasoned driver of automatic transmission vehicles, I've encountered clutch slippage issues before. That time on the highway when trying to overtake, I stepped on the gas and heard the engine revving loudly, but the car just wouldn't accelerate as it normally would - the difference was huge. It was even more noticeable when climbing hills; the car felt powerless with an added humming noise, and fuel consumption skyrocketed by nearly one-third compared to normal. After inspection, it turned out the clutch in the transmission was worn out, and insufficient lubrication could cause similar problems. Delaying repairs might lead to complete transmission failure, which ended up costing me a fortune to fix. Remember not to overlook these minor warning signs - they affect both driving safety and your wallet. Regular maintenance is key: check transmission fluid periodically and avoid sudden acceleration. My advice? If something feels off while driving, head to the repair shop immediately. Losing power suddenly on the highway can be extremely dangerous, especially when traveling with family.
Was this review help?
7
0
Share
Expand All
More Forum Discussions

How many degrees should the steering wheel be turned for a small right turn?

For a small right turn, the steering wheel should be turned approximately 150 to 160 degrees. The steering wheel is a wheel-shaped device used to control the direction of vehicles such as cars, ships, and airplanes. Its function is to convert the force applied by the driver on the edge of the steering wheel into torque, which is then transmitted to the steering shaft. The steering wheel mainly consists of a frame, foam, and mounting clips or screw holes corresponding to the driver's airbag (DAB). Typically, the steering wheel is connected to the steering shaft via splines. Using a larger diameter steering wheel reduces the hand force required by the driver when turning. The steering intermediate shaft, acting as a connector between the steering gear and the steering shaft, facilitates the standardization of the steering gear, compensates for errors during manufacturing and installation, and ensures a more rational installation of the steering gear and steering wheel in the vehicle.
15
0
Share

How to Turn Off the Engine After Remote Starting a CRV?

After remote starting a CRV, you can use the remote control system on the smart key to turn off the engine by pressing the start button in the middle of the remote again. Once the engine is remotely started, the vehicle will operate continuously for ten minutes. If no further instructions are received, the engine will automatically shut off after this period. The principle of remote start involves the smart key sending a signal to the car to start the engine remotely. The Honda CRV is a classic urban SUV model produced by Dongfeng Honda Automobile Company. It features a MacPherson strut independent front suspension and a multi-link independent rear suspension. In terms of body dimensions, it measures 4621mm in length, 1855mm in width, and 1679mm in height, with a wheelbase of 2661mm.
1
0
Share

How to Remove and Install the Cabin Air Filter in Volvo XC60?

Volvo XC60's cabin air filter is located under the glove box on the passenger side. The removal and installation steps are as follows: 1. First, remove the passenger side foot mat, then pull out the carpet to reveal the cabin air filter cover of the Volvo XC60; 2. Next, open the cabin air filter cover to see the filter inside, take out the old filter and replace it with a new one, then reinstall it following the original steps. Detailed instructions for removing and installing the Volvo XC60 cabin air filter are as follows: 1. First, remove the clips located at the front of the passenger side in the engine compartment, then take out the sound insulation cotton. Be careful to avoid damaging the clips. 2. Remove the filter. After taking out the sound insulation cotton, reach in to remove the baffle, then reach in again to take out the cabin air filter. Note that there is an arrow indicator on the outside of the filter; avoid installing it backwards. When driving with the air conditioning on, the car draws in outside air into the cabin, but the air contains various particles such as dust, pollen, soot, abrasive particles, ozone, odors, nitrogen oxides, sulfur dioxide, carbon dioxide, benzene, etc. Cleaning tip: If the filter is dirty, clean it by blowing compressed air from the opposite side. Hold the air gun about 5 cm away from the filter and blow at a pressure of 500 kPa (5.0 kgf/cm²) for about 2 minutes. The cabin air filter easily collects a lot of dust; use a blower or high-pressure air to remove the dust. Do not wash it with water, as this can easily ruin it.
13
1
Share

How to solve the 'nokey' display issue in Lavida?

The solution to the 'nokey' display issue in Lavida is: check if the car key needs a battery replacement, then inspect whether the smart key sensor connector in the trunk is loose, and reinsert it properly. 'nokey' means the key cannot be detected, and the reasons may include: 1. Insufficient key battery; 2. Interference from in-car devices; 3. Sensor malfunction; 4. Loose smart key sensor wire. Lavida is a compact sedan produced by Shanghai Volkswagen, featuring a MacPherson strut front suspension and a torsion beam semi-independent rear suspension. In terms of body dimensions, it measures 4670mm in length, 1806mm in width, and 1474mm in height, with a wheelbase of 2688mm.
10
0
Share

What do the buttons on the driver's door of the Audi A4 mean?

The buttons on the driver's door of the Audi A4 are for the interior monitoring and trailer alarm switch. When activated, if the vehicle's windows are damaged, the system will detect it and trigger an alarm. Exterior design: While maintaining the stable style of the previous generation, some details have been modified. For example, the headlight design is more robust, and the body lines are more three-dimensional. All these subtle changes make the car look sharper. Interior design: The interior design leans towards the Q7, with the center console more inclined towards the driver, embodying the driver-centric concept. The 12.3-inch virtual cockpit, when displaying the full-screen navigation interface, offers an ultra-large and ultra-clear view that is both satisfying and addictive.
5
1
Share

What are the body dimensions of the Lavida P?

The Lavida P has body dimensions of 4670x1806x1474mm with a wheelbase of 2688mm. Exterior: The exterior features a horizontal grille connected to the headlights, a very mainstream design style. The grille also has a full-width chrome strip, giving it a broad appearance. The internal structure of the headlight cluster is also quite refined, likely equipped with LED low and high beams, as well as LED daytime running lights. Interior: The interior follows Volkswagen's family design style, with straighter lines in the new model. The gradient trim and newly designed instrument panel add a touch of vitality to the interior.
2
3
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.