What are the symptoms of a faulty car throttle pedal sensor?
2 Answers
Car throttle pedal position sensor failure can result in uncontrollable throttle response or no acceleration response. If one or both sensor signals are interrupted, the electronic throttle fault indicator will activate. When the two internal resistor sets of the sensor cannot mutually verify, the ECU fails to obtain the correct current throttle pedal position, manifesting as weak engine acceleration. The car throttle pedal is a vehicle accessory designed to enhance driver control and improve driving safety. Most throttle pedals feature aluminum alloy construction, and installing an additional pedal can significantly increase vertical contact surface area. Repair methods for faulty throttle sensors: Timely maintenance is required for damaged throttle sensors. Remove the throttle assembly, locate the sensor's signal output wires, measure circuit resistance with a multimeter, operate the pedal while observing meter value changes to diagnose faults. Check for broken wires or disconnected connectors in the sensor harness, replacing if damaged. Throttle pedal sensor fault detection procedure: Remove the throttle pedal assembly, locate the throttle position sensor, identify its corresponding signal output wires, measure circuit resistance with a multimeter, operate the pedal while monitoring multimeter value changes to determine faults.
I've experienced this before. While driving, it feels like pressing the accelerator has no response, as if stepping on air, and the engine response is extremely sluggish. The tachometer jumps up and down erratically, unstable, especially during acceleration. The engine warning light on the dashboard will definitely illuminate, alerting you to a major issue. Some models may even enter a speed-limiting mode, preventing speeds from exceeding 50km/h, which is extremely dangerous on highways. Worse yet, prolonged neglect can lead to a sharp increase in fuel consumption, damage the engine, and easily cause rear-end collisions. Always pay attention to these signs while driving. Go to a repair shop immediately to check the fault codes with a diagnostic tool. If it's a sensor issue, just replace it—don't wait until an accident happens.