What are the steps to reset the maintenance light on the X-Trail?
4 Answers
Steps to reset the maintenance light on the X-Trail: 1. Turn off the ignition switch; 2. While pressing the clock adjustment button "set", turn on the ignition switch; 3. Release the "set" button, then press the "set" button once more; 4. Turn off the ignition switch, then turn it on again to check if the light has been reset. If not, the process must be repeated from the beginning. The X-Trail is a model under Dongfeng Nissan, with body dimensions of 4675mm in length, 1820mm in width, and 1722mm in height. The X-Trail is equipped with an intelligent all-mode 4WD system, allowing drivers to freely choose between two-wheel drive, automatic, or locked four-wheel drive modes to handle various road conditions. The X-Trail also features advanced technological equipment, such as an advanced hill start assist system, hill descent control system, electronic brake differential lock, yaw moment control system, and vehicle dynamic balance system.
Just helped my cousin with his 2021 X-Trail a couple days ago, resetting that maintenance light is really not difficult. First, sit in the car without pressing the brake pedal, just press the start button twice to power on the vehicle until all dashboard lights illuminate. Here's the key part: watch the instrument cluster closely to locate that maintenance reminder symbol - either a little wrench icon or 'MAINT REQD' text. Then immediately press and hold that rectangular menu button on the left side of the steering wheel for a solid 5+ seconds without releasing. Click! Maintenance alert disappeared? That's it. Oh, absolutely make sure to do this with the car parked on level ground and turned off, otherwise accidentally triggering other functions would create chaos. After finishing, it's best to double-check the dipstick too, since having the maintenance light reset without proper actual maintenance would be even more troublesome.
After studying the maintenance reminder logic across different model years of the X-Trail, the core operation consistently involves entering engineering mode. For older X-Trail models, you need to turn the key to the ON position (dashboard lights fully illuminated but engine off), then rapidly toggle the black knob at the lower right corner of the instrument cluster back and forth. The process is much simpler for newer models with LCD instrument panels: first power on until the instrument self-check completes, use the up/down arrows on the right side of the steering wheel to navigate to the maintenance settings menu, then press and hold the OK button for 5 seconds to reset. Special reminder for owners to note year differences - pre-2019 models may require manual reset of the next maintenance mileage after the procedure. It's advisable to have the vehicle manual ready before operation, as some models additionally require fully depressing the accelerator pedal within 10 seconds.
Easy 3-step process: 1. Press the start button twice without stepping on the brake to power on. 2. Locate the wrench icon on the dashboard. 3. Hold the return button on the left side of the steering wheel for 10 seconds. The whole process takes less than 30 seconds - faster than clearing your phone's cache. Important: Ensure the vehicle is completely stopped with the parking brake engaged. There was a case where a car rolled backward and hit a wall when the owner attempted this on a slope. After resetting, remember to take a photo of your dashboard for records - show it to the technician during your next service for accurate maintenance cycle calculation.
