What are the steps to clear the inspec on the Volkswagen Sagitar?
2 Answers
The steps to clear the inspec on the Volkswagen Sagitar are: 1. Turn off the ignition switch; 2. Press and hold the right button on the instrument panel to reset; 3. While holding the right button, turn on the ignition switch; 4. Release the right button and press the left menu button once. Taking the Sagitar 2021 model as an example, its body dimensions are: length 4753mm, width 1800mm, height 1462mm, wheelbase 2731mm, fuel tank capacity 50l, and trunk capacity 553l. The Sagitar 2021 model is equipped with a 1.2t turbocharged engine, with a maximum power of 85kw and a maximum torque of 175nm, matched with a 5-speed manual transmission. It adopts a McPherson independent front suspension and a multi-link independent rear suspension.
I often clear the maintenance reminder for my 2018 Sagitar. This INSP reset is actually quite simple. First, turn the key to the power-on position (do not press the brake to start the engine), then press and hold the '0.0' button at the lower right corner of the instrument panel. After about 5 seconds, the screen will display an English prompt saying 'Reset maintenance data?'. At this point, release the button and immediately press the '0.0' button again to confirm. The whole process takes just over ten seconds. After turning off and restarting, the yellow wrench symbol will disappear. For older models without this button, you may need to operate through the menu key on the wiper stalk. After completing the operation, it's best to drive a few kilometers to see if the reminder pops up again.
