What are the steps for replacing the power window regulator in a Magotan?
4 Answers
The steps for replacing the power window regulator in a Magotan are: 1. Pry open the door panel, unscrew the regulator's screws, and remove the regulator; 2. Disconnect the wiring harness plug from the regulator; 3. Connect the wiring harness plug to the new regulator; 4. Position the new regulator and tighten the screws; 5. Apply sound insulation foam and secure the clips; 6. Test the window's normal operation before reinstalling the door panel. Taking the 2020 Magotan as an example, its body dimensions are: length 4865mm, width 1832mm, height 1471mm, with a wheelbase of 2871mm, a fuel tank capacity of 66 liters, and a trunk capacity of 533 liters. The 2020 Magotan features a front MacPherson strut independent suspension and a rear multi-link independent suspension. It is equipped with a 1.4L inline 4-cylinder turbocharged engine, producing a maximum horsepower of 150PS, a maximum power of 110kW, and a maximum torque of 250Nm, paired with a 7-speed dual-clutch transmission.
I recently replaced the window regulator on my Magotan myself, and the process was quite thrilling! For tools, I prepared a Phillips screwdriver, plastic pry bar, and a small wrench. First, turn off the car and lower the window to the middle position for easier access. Use the pry bar to gently remove the inner door panel, which has several clips—be careful not to break them, or the panel might become loose. Disconnect the power connector to prevent short circuits. When removing the old regulator assembly, watch out for the steel cables to avoid cutting your hands; common issues include cable wear or motor failure. When installing the new regulator, ensure the sliding rails are aligned and tighten the screws securely. Then, reconnect the motor plug and test the window: move it up and down a few times to check for smooth operation without noise. If everything works, reattach the door panel and press the clips firmly into place. The whole DIY took about two hours—it might be a bit challenging the first time, but it saved me hundreds in repair costs and taught me new skills. Afterward, check the weatherstripping to ensure it's intact and prevent water leaks.
As a female family driver who daily drives a Magotan, I have dealt with window regulator failures before. Simple steps: First, prepare basic tools like a screwdriver, and avoid taking on the task alone if the risks seem high. When removing the door trim panel, be careful—use soft tools to gently pry it open to avoid damaging internal wiring. Then, disconnect the power to the old regulator and remove the assembly; sometimes, the cause of failure is rainwater corrosion or dust buildup. Before installing the new regulator, clean the tracks, ensure proper alignment, and then tighten the screws. Test the functionality before reassembling the door panel, pressing firmly to prevent rattling. The replacement process isn’t difficult but requires patience; if inexperienced, it’s best to visit a professional shop—safer, hassle-free, and with free warranty service. Regular replacement of regulators improves durability, and remember to add lubricant during the next maintenance to prevent future issues.
I've worked on many Magotan cars, and replacing the window regulator is a small job. Use a screwdriver to carefully remove the door panel clips without rushing. After lowering the window for stability, disconnect the plug and remove the screws of the old regulator assembly. Install the new one, ensure it's aligned properly, and test for smooth operation. Just make sure the door panel is securely fastened. The process is straightforward with basic tools and takes about half an hour—beginners might take a bit longer, but it's easy to learn. Common issues like wire jams or motor failures are fixed by replacing the part. Remember to wear safety gloves and avoid touching wires carelessly.
