What are the standard dimensions for a reverse parking garage?

[McChloe]

The standard dimensions for a reverse parking garage are as follows: The garage is 5.25 meters long and 2.3 meters wide. The total length of the road is 15.9 meters, with a single side length of 6.8 meters and a width of 5.8 meters. Evaluation criteria for reverse parking: failing to follow the designated route or sequence results in disqualification; the vehicle body crossing the line results in disqualification; failing to fully enter the garage results in disqualification; stopping midway results in disqualification; exceeding 4 minutes results in disqualification. Reverse parking mnemonic: Reversing in and out isn't hard, fasten seatbelt, shift gear, left signal flash. Press clutch, release handbrake, slowly lift clutch to start smoothly. Watch the right line to adjust the car body, left mirror vertical seam aligns with the right line. Stop when the front line reaches shoulder level, shift to reverse gear, release clutch. When the left mirror covers the corner of the horizontal line, turn the steering wheel fully to the right. Watch the left mirror for the garage line, at a 30-degree angle, turn back one circle. When the car is parallel to the line, straighten the steering wheel with two full turns. When the left mirror covers the front corner of the garage, press clutch and brake. Shift to first gear to exit, turn the steering wheel fully to the left when the car touches the line. Stop when the car hood covers the line, keep the steering wheel position and reverse. Watch the right mirror for the garage line, at a 30-degree angle, turn back one circle. When the car is parallel to the line, straighten the steering wheel with two full turns. When the left mirror covers the front corner of the garage, press clutch and brake. Shift to first gear to exit, turn the steering wheel fully to the right when the car touches the line. Stop when the car hood covers the line, adjust the car body skillfully. New garages have no poles to look at, only ground markings. The garage length is much shorter than before, just enough to fit a car completely. Currently, the test involves two garages, left and right. Starting from 2013, it was only one garage. The process involves reversing into the garage from the right, then driving out to the left, reversing back in, and finally driving out to return to the starting point. This process is much simpler, eliminating the current test step of moving the car within the garage.