What are the speed requirements for the automatic transmission in Subject 3?
3 Answers
In the automatic transmission Subject 3, there is a section of the road where you need to accelerate to above 45 km/h and maintain it for at least three seconds. The following are the relevant details about the automatic transmission Subject 3: 1. If it is a straight driving test point, you need to maintain a speed of around 35 km/h. 2. If you are at a bus stop, school zone, or pedestrian crossing, you need to slow down and brake to pass. 3. On normal road surfaces, there is no specified speed limit, but the speed should not exceed 30 km/h. 4. Subject 3 is part of the motor vehicle driver's license assessment and is the abbreviation for the road driving skills and safe and civilized driving knowledge test in the motor vehicle driver's examination. Stay calm and complete the test as required.
When I was practicing for the automatic transmission driving test (Subject 3), speed control was crucial. At the start, gently press the accelerator and gradually increase speed—avoid stomping on it suddenly to prevent stalling or instability. On straight sections, maintain a steady speed of around 30 to 40 km/h to avoid fluctuations; driving too slow may make the examiner think you're overly cautious, while going too fast appears impatient. Speed is key when changing lanes—accelerate appropriately to exceed 20 km/h, signaling your intention to merge safely. Always slow down at intersections, especially with traffic lights or crosswalks, reducing speed below 20 km/h to ensure clear visibility. During parking preparation, gradually ease off the accelerator to decelerate smoothly to a stop—no sudden braking to avoid jerking. Practice throttle control often at driving school to get accustomed to speed changes and develop good habits. Safety first, after all!
The core of speed control for automatic transmission in Subject 3 is stability and safety. For example, gently press the accelerator when starting, and let the speed increase gradually without being aggressive. Maintain a steady speed of about 30 to 35 km/h during straight-line driving, as this rhythm is most favored by examiners. Driving too slowly can disrupt traffic flow and result in point deductions, while driving too fast is unsafe. During lane changes, briefly accelerate to over 20 km/h to smoothly merge into another lane, and the maneuver should be decisive without hesitation. Slowing down at intersections is a strict requirement—reduce speed to under 20 km/h, observe the surroundings carefully, and proceed without rushing. When parking, ease off the accelerator in advance to let the vehicle glide to a stop. These requirements may seem simple, but with practice, they will become second nature. Also, pay attention to any specific speed limit signs on the test route to avoid speeding.
