What are the skills for driving straight in C2 Subject 3?

2 Answers
JaylaRose
07/23/25 8:48pm
C2 Subject 3 straight driving skills: 1. Adjust your sitting posture: Lean your head against the headrest, look straight ahead at a point 100 meters away, keep your arms slightly inward (clipped inward), and hold both sides of the steering wheel naturally with your hands. The grip should be just firm enough to sense slight left and right movements of the steering wheel. Place your left foot on the floor of the driver's compartment to the lower left of the clutch pedal, rest your right foot lightly on the accelerator pedal, and lean your body back at an angle of about 110 degrees. 2. Find a reference point: Before entering the straight driving section, adjust the car to drive in the center of the road. Focus your attention and look far ahead, avoiding the habit of looking at the car hood or steering wheel. Choose a point in the center of the road about 100 meters ahead (you can use lamp posts as a reference, approximately four poles away). This point can also be slightly left of the center of the lane's wheel tracks, ensuring it aligns with the direction of travel. Keep your eyes fixed on this point as the car moves forward, maintaining alignment between the direction ahead and this point. 3. Correct the direction promptly: Turn the steering wheel gently and slowly to ensure a longer straight driving distance. Avoid sudden or sharp turns (overly quick or aggressive corrections). Try not to shift gears or honk the horn during straight driving. If you must shift gears or honk, keep your left arm slightly inward to stabilize the steering wheel. Avoid letting your left arm hang loose, which can destabilize the direction. If you notice any deviation from the reference point, correct it promptly with minimal adjustments. 4. Control the speed: Generally, it's easier to pass at higher speeds and harder at lower speeds. The recommended speed is around 35 km/h, with a maximum of 40 km/h for faster speeds.
Was this review help?
12
2
Share
LaCaroline
08/10/25 6:43pm
I remember teaching many students the skills for the straight-line driving section in Subject 3, where the key is maintaining stability. Keep the speed between 30 to 40 km/h—avoid sudden acceleration or deceleration, as a steady speed is easiest for maintaining a straight line. Hold the steering wheel loosely, don’t grip it too tightly; think of it as resting lightly in your hands so minor adjustments don’t cause sharp turns and deviations. Always look far ahead—don’t fixate on the hood or the road right in front of you. Instead, focus on a point about 100 meters away, like distant scenery or the extended centerline of the lane, to detect deviations early. When adjusting, turn the steering wheel just slightly—a degree or two is enough—don’t overcorrect. A common mistake is tensing up, leading to jerky steering when the car drifts, which only worsens the deviation. During practice, find a straight road segment and drive it repeatedly to build muscle memory. During the test, avoid staring at the dashboard—stay focused on the distance, and you’ll pass.
Was this review help?
5
2
Share
Expand All
More Forum Discussions

How to Turn On the Rain-Sensing Wipers?

The control switch for the rain-sensing wipers is located on the right-hand stalk near the steering wheel. The knob can be used to adjust the sensitivity of the rain-sensing wipers. The right-hand stalk has three adjustable positions in the forward and backward directions: the stop position "0", the automatic wiper position, and the continuous wiper position. While driving, to activate the rain-sensing wipers, push the right-hand stalk forward once, and the car will display a message indicating "Rain-sensing wipers are on". After setting the stalk to the automatic wiper position, rotate the rain-sensitivity adjustment knob to allow the wipers to activate automatically based on the intensity of the rain.
13
1
Share

Where to Turn On Car Bluetooth?

Locate the Bluetooth function in the car entertainment system, which is generally similar to mobile phone operation. In the connection or settings options, there will be a Bluetooth icon indicating the Bluetooth menu. The following is relevant information about car Bluetooth: 1. Concept: Bluetooth hands-free is also called car Bluetooth or car hands-free. The Bluetooth technology in car Bluetooth systems is derived from mobile phone Bluetooth technology and shares the same transmission system. The Bluetooth hands-free system is an in-vehicle wireless hands-free system designed and developed based on wireless Bluetooth technology. 2. Main functions: Automatically identifies mobile phones and connects to them without cables or phone holders; the owner can control the phone without touching it, even keeping both hands on the steering wheel, using voice commands to answer or make calls. Users can conduct calls through the car's audio system.
11
3
Share

What is the problem when the trolley of the tower crane does not move?

The immobility of the tower crane trolley may be caused by the motor burning out, the trolley fuse in the distribution panel blowing, the control line of the trolley transfer switch in the control panel breaking, or a phase loss due to a broken trolley power line. Here is additional information: Transfer switch damage: If there is simply no forward or backward movement, it may be caused by a damaged transfer switch or contactor. Failure of the lifting mechanism to start: Check for wiring errors in the control circuit by comparing with the wiring diagram. If the fuse is blown, check if the fuse capacity is too small and replace it with a larger one if necessary. Short circuit, grounding, or open circuit in the motor winding: Locate the short or open circuit and repair it.
19
2
Share

Can I Drive Without a Driver's License Now?

Now you cannot drive without a driver's license. Here are the relevant details: 1. New traffic regulations: According to the new traffic regulations, you still need to carry a driver's license when driving a motor vehicle. Although portable query terminals are used by traffic police, they are not available in all regions. In addition, electronic driver's licenses have not yet been popularized nationwide, and there are no mobile terminals, so their practicality is not high. Among them, shared car rental is a common way to use electronic driver's licenses. 2. Penalty: If you drive without a driver's license and are caught, the motor vehicle will be detained, the driver will be fined a small amount, and one point will be deducted. The motor vehicle can only be retrieved after the driver provides valid documents.
7
0
Share

Is Hill Start Assist Automatically Activated?

Hill Start Assist is automatically activated and remains on by default, with no manual shut-off button. This feature primarily assists the vehicle when climbing slopes. Simply put, when encountering an uphill section, Hill Start Assist aids the vehicle in ascending, making driving easier and reducing effort. Several conditions must be met for Hill Start Assist to function: first, the vehicle must be on an incline; second, it should not be in Park (P) gear; third, the accelerator should not be pressed; fourth, the vehicle must be stationary; and fifth, the handbrake should not be engaged. Only when all these conditions are satisfied will Hill Start Assist activate. Known as HAC (Hill-start Assist Control), this system is a derivative function based on the ESP (Electronic Stability Program) system. It allows the vehicle to remain braked for a few seconds after the driver releases the brake pedal, facilitating a smooth start on a slope without using the handbrake.
3
3
Share

How to Remove 3M Adhesive from Window Trim?

Methods to remove 3M adhesive from window trim are: 1. Use a hairdryer to blow hot air until it becomes too hot to touch, then immediately apply even force to peel off the sticker. The remaining adhesive can be sprayed with tar remover, left for a while, and then wiped clean with a damp cloth; 2. First, use a wet towel to moisten and soften the paper on the sticker, then rub it off. The remaining adhesive can be treated with essential balm, alcohol, or hand cream, which is very effective for removing adhesive traces; 3. For glass that already has a film, never use cleaning agents as some chemicals may damage the film. In this case, use a towel dipped in a small amount of carburetor cleaner to repeatedly wipe the label area, but never spray the cleaner directly on the glass to avoid damaging the film. It is important to note that these are flammable substances, so be cautious of open flames during use.
19
2
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.