What are the simulated lighting test items in Subject Three?

1 Answers
VonKathryn
07/30/25 7:12am
Subject Three lighting simulation involves adjusting to the specified lighting within 5 seconds after hearing the voice announcement, then waiting for the next voice announcement to adjust to the next specified lighting without turning it off. The following are detailed explanations: 1. Introduction: Subject Three, including road driving skills test and safety and civilized driving knowledge test, is part of the motor vehicle driver's license assessment. It is the abbreviation for the road driving skills and safety and civilized driving knowledge test subjects in the motor vehicle driver's test. The content of the road driving skills test varies for different types of driving licenses. 2. Content: The road driving skills test for Subject Three generally includes: preparation before getting on the car, simulated lighting test, starting, driving straight, gear shifting operations, changing lanes, pulling over, going straight through intersections, turning left at intersections, turning right at intersections, passing pedestrian crossings, passing school zones, passing bus stops, meeting vehicles, overtaking, making U-turns, and driving at night. The safety and civilized driving knowledge test generally includes: requirements for safe and civilized driving operations, safe driving knowledge under adverse weather and complex road conditions, emergency handling methods for situations such as tire blowouts, and knowledge of handling after traffic accidents.
Was this review help?
3
1
Share
More Forum Discussions

What is the width of a 17.5-meter flatbed truck?

About the width of a 17.5-meter flatbed truck, the introduction is as follows: 1. Dimensions of a pure flatbed truck. A pure flatbed truck refers to a truck with a low platform without guardrails, commonly seen in large vehicles. The dimensions of a 17.5-meter flatbed truck are as follows: the platform length is 17.5 meters, and the width can be 2.6 meters, 2.8 meters, or 3 meters. It is generally a high-low platform, with the high platform part accounting for 3 to 4.5 meters in length and 1.5 meters from the ground. 2. Uses of flatbed trucks. The low platform part accounts for about 13 to 14.5 meters in length, with varying heights from the ground (1.2 meters, 1 meter, 0.8 meters, 0.6 meters, or 0.5 meters). These models are suitable for transporting large mechanical equipment, such as pile drivers, excavators, drilling machines from construction sites, and large machines manufactured in factories with significant length and width dimensions. They are mainly used in factories, construction sites, and other large production or engineering bases.
6
1
Share

What is the maximum charging temperature for new energy vehicle batteries?

New energy vehicle batteries should not exceed 40 degrees Celsius during charging. The charging methods for new energy pure electric vehicles are as follows: 1. Slow charging (conventional charging, onboard charging): Suitable for onboard chargers and home wall-mounted charging piles, with relatively low current and power, typically requiring 6-8 hours for a full charge. 2. Fast charging (ground charging, emergency charging): Includes charging stations and mobile charging vehicles, primarily using non-onboard chargers to deliver high current directly to the battery, allowing the battery to reach approximately 80% charge in a short time, usually within 1 hour. 3. Battery replacement: When the power battery is depleted, replace the low-charge battery pack with a fully charged one, and send the replaced battery to the swap station for slow charging. 4. Wireless charging: Automatically connects to the power grid for charging and discharging through wireless charging panels embedded in roads and parking spaces without the use of wires or cables. This method is convenient and safe but has not yet been mass-produced or widely used.
20
5
Share

How to Deal with P0303 Detected Misfire in Cylinder 3?

p0303 detected misfire in cylinder 3 requires checking the spark plug, ignition wire, and ignition coil, and timely replacement of the spark plug or ignition coil. For troubleshooting engine misfires, sometimes reading the engine data stream alone may not reveal the issue, and an oscilloscope is needed for further diagnosis. Below is relevant information: 1. Considerations: Factors to consider for ignition include ignition timing, whether the spark plug is functioning properly, whether the resistance of the high-voltage wire is within the standard range, and whether the ignition coil is working correctly (whether the power and signal wires are properly connected). 2. Inspection: Also, check whether the engine control unit is functioning properly (including signals provided by CAN data). It is recommended to use diagnostic tools for inspection whenever possible.
18
4
Share

Can BP Ultimate 95 Really Clean Carbon Deposits?

BP Ultimate 95 cannot clean carbon deposits. However, it can reduce the formation of carbon deposits. Using 95-octane gasoline can lower the likelihood of engine knocking and slightly improve engine performance. More relevant information is as follows: 1. Differences between octane ratings: Gasoline with different octane ratings has varying levels of octane values. 95-octane gasoline has a higher octane value than 92-octane, and 98-octane gasoline has a higher octane value than 95-octane. 2. About octane values: Octane values enhance the stability of gasoline. It must be mentioned that there is an abnormal combustion phenomenon in engines called knocking. When the engine is in the compression stroke, the piston moves upward to compress the air-fuel mixture. As the piston compresses the mixture, the pressure and temperature of the mixture increase. If the gasoline's stability is insufficient, the mixture may ignite spontaneously before the spark plug fires, resulting in knocking.
16
0
Share

Why is the Volvo engine so loud?

Volvo engine noise is loud for the following reasons: 1. Cold engine state: If it is in the morning, the car is in a cold state, the engine oil settles in the oil pan, and the fluidity of the oil is relatively poor at low temperatures. Chain-type engines are noisier compared to belt-type engines. Wait patiently for a few minutes, and the noise will reduce once the oil lubrication is sufficient. 2. Moving parts: When the engine is cold, the moving parts have smaller gaps due to thermal expansion and contraction, which also results in louder noise. 3. Pulleys: When the engine is cold, the noise from the pulleys and other wheels will be relatively louder. If the noise does not change after the engine reaches normal operating temperature, it is recommended to have it inspected and repaired at a 4S shop.
8
5
Share

What Are the Elements of Off-Road Spirit?

1. Off-Road Spirit – Compassion: The essence of off-road spirit embodies compassion. Driving a massive off-road vehicle equipped with a tow rope in the trunk, when encountering vehicles stuck in deserts or mud, the immediate response is to pull them out—not for profit or reward, but because our hearts hold a compassionate balance, believing all under heaven are brothers. 2. Off-Road Spirit – Wisdom: The essence of off-road spirit represents wisdom. On solo off-road journeys, challenges are inevitable, but in the absence of external aid, the only savior is one's own wisdom. Applying this wisdom to life and work brings one closer to success. 3. Off-Road Spirit – Sharing: The essence of off-road spirit signifies sharing. Those with off-road spirit are never selfish; they share untold experiences and convey unseen landscapes through photos. In life, such individuals are open-hearted and generous, naturally surrounded by many friends. 4. Off-Road Spirit – Loyalty: The essence of off-road spirit stands for loyalty. There is no betrayal, only a shared sense of hardship, faithfulness to companions, work, and family. Even in storms or dire straits, they never abandon their commitments.
16
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.