What are the serious quality issues with the Peugeot 3008?

1 Answers
JaylaFitz
07/29/25 10:50pm
Serious quality issues with the Peugeot 3008: 1. Bizarre exterior design: The windshield is too long and has an excessive slope, making the side profile resemble that of a sedan. 2. High fuel consumption: During traffic jams or uphill driving, the instantaneous fuel consumption can soar to around 15 liters per 100 kilometers, a common issue in most vehicles. 3. Limited rear seat space: The passenger space in the Peugeot 3008 is not very spacious, and the rear seat area is quite compact when fully occupied. 4. Outdated technology: Equipped with a 1.6T engine that has been in use since the first-generation Peugeot 3008 in 2013.
Was this review help?
5
2
Share
More Forum Discussions

How to Test the Throttle Position Sensor?

Testing the throttle position sensor: For switch-type throttle position sensors, use a multimeter to check the continuity of the idle switch and full load switch. For linear variable resistor-type throttle position sensors, measure the resistance of the linear potentiometer. More information about the throttle position sensor is as follows: 1. The throttle position sensor is one of the most important sensors in the automotive electronic control system, primarily used in engine electronic fuel injection systems and electronically controlled automatic transmission systems. 2. The throttle position sensor is installed at one end of the throttle shaft on the throttle body to detect or monitor the degree and rate of change of the throttle opening. It converts the position signal into an electrical signal and inputs it into the electronic control unit. This is used to determine various engine operating conditions, thereby controlling different fuel injection amounts and ignition timing.
6
5
Share

What Causes the Reddish-Brown Color on the Spark Plug Tip?

The reddish-brown color on a spark plug is caused by early ignition timing or a lean air-fuel mixture. Methods to determine if a spark plug is damaged: Remove the spark plug and observe its appearance to assess its condition. A normal spark plug's insulator skirt and electrodes should appear gray-white, gray-yellow, or light brown. A properly functioning spark plug has a reddish-brown insulator skirt, with an electrode gap between 0.8-0.9mm and no signs of electrode burn. If the spark plug is coated with oil or deposits but is otherwise undamaged, it can continue to be used after cleaning off the oil and deposits. If the spark plug is severely damaged—showing signs like blistering at the tip, black streaks, cracks, or melted electrodes—the cause of the damage should be identified and the issue resolved before replacing the spark plug. Additionally, if the spark plug appears black as if smoked, it indicates the wrong heat range was selected, the air-fuel mixture is too rich, or engine oil is entering the combustion chamber.
20
5
Share

How many kilometers should the spark plugs of a Prado be replaced?

The spark plugs of a Prado should be replaced every 40,000 kilometers. Methods to determine if the spark plugs are damaged: Remove the spark plugs and observe them. The condition of the spark plugs can be judged based on their appearance and color. Normal spark plugs have a skirt and electrodes that appear gray-white, gray-yellow, or light brown. A properly functioning spark plug has a skirt that is reddish-brown, with an electrode gap between 0.8-0.9mm, and no signs of electrode burning. If the spark plugs are covered with oil or deposits but are not damaged, they can continue to be used after cleaning off the oil and deposits. If the spark plugs are severely damaged, showing signs such as blistering at the top, black streaks, cracks, or melted electrodes, the cause of the damage should be identified. After troubleshooting, replace the spark plugs with new ones. Additionally, if the spark plugs appear black as if smoked, it indicates that the wrong heat range was selected for the spark plugs or that the air-fuel mixture is too rich, or there is oil leakage.
3
4
Share

What is the fuel tank capacity of the Roewe RX5 in liters?

Roewe RX5 has a fuel tank capacity of 55 liters, which is the officially announced data. Owners who have purchased the Roewe RX5 can also check this information on the vehicle's configuration sheet. The Roewe RX5 uses 92-octane gasoline, with a fuel consumption of 6.8 to 6.9 liters per 100 kilometers. A full tank can cover a distance of 797 to 809 kilometers. During daily driving, it is necessary to pay attention to the remaining fuel level in the tank. This is usually observed through the fuel gauge inside the vehicle. If there are no other issues, the fuel level will be accurately reflected on the gauge. The fuel gauge typically has 5 to 6 segments, and it is advisable to refuel when there are only 2 segments left to avoid running out of fuel midway. During actual refueling, the amount of fuel may exceed the marked capacity. This is because the fuel tank capacity marked by the manufacturer is measured from the bottom of the tank to the safe fill level. There is additional space from the safe fill level to the tank opening, which is designed to allow for fuel expansion when temperatures rise, preventing overflow. If fuel is filled up to the tank opening during refueling, the actual amount of fuel added may exceed the marked tank capacity.
15
5
Share

What is the reason for water dripping from the car chassis after a bump?

The reasons for water dripping from the car chassis can be divided into two situations: 1. Normal water leakage after turning on the air conditioning. Just like household air conditioners have a condensate drain pipe, the same applies to car air conditioners. Condensation water from the air conditioning will also drip from the bottom of the car. In this case, there is no need to worry as it is completely normal, even if the car has been scraped underneath, the water storage area is not damaged. 2. Leakage caused by antifreeze or windshield washer fluid. If the water is colorless and odorless, it indicates normal air conditioning condensation water. However, if it is of other colors, such as the common yellow-green, pink, or orange of antifreeze, it indicates antifreeze leakage. In this case, the car should not be driven further, as it may lead to overheating in the engine compartment. It should be sent to a repair shop immediately for servicing.
11
2
Share

Can I Change My License Plate Number If I Don't Want It Anymore?

If the license plate number has already been registered with the vehicle management office, it cannot be changed. More information about changing license plate numbers is as follows: 1. If you have only selected a number online but not registered it, you can change the license plate number. After selecting a number through the online vehicle management office's license plate selection system, the owner must submit the relevant documents to the vehicle management office within the specified time frame to complete the registration process. If the application is not submitted on time, the selected number will automatically become invalid and be returned to the pool of available numbers. 2. Currently, license plates are issued for the lifetime of the vehicle. Once a license plate is assigned to a car, it cannot be changed unless the vehicle is transferred to a new owner, at which point a new license plate can be issued.
3
1
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.