What are the safety precautions for road sweepers?

1 Answers
MacFinn
07/30/25 6:35am
Safety precautions for road sweepers are as follows: 1. Beware of fire hazards: During road sweeper maintenance, flammable materials such as fuels and cleaning agents are frequently used. It is essential to follow standard operating procedures and implement fire prevention measures. Always keep a fire extinguisher on hand to prevent fires. Do not smoke or ignite flames near the fuel tank or battery, as spilled fuel vapors and hydrogen gas from the battery can easily catch fire. 2. Beware of burns: After prolonged use, components of the engine (such as the radiator, exhaust pipes, power steering fluid reservoir, and spark plugs) can become extremely hot. Avoid contact to prevent burns. 3. Beware of mechanical injuries: Check the initial gear position before starting to avoid collisions caused by excessive speed. When working under the engine hood, ensure the cab is clear to prevent accidental injury from sudden engine movement or improper operation by others. 4. Avoid damaging the sweeper: Take care not to damage the road sweeper, especially to prevent brake fluid leaks. Brake fluid can damage the sweeper's paint film and, if accidentally splashed into the eyes, can impair vision or cause blindness. In case of accidental exposure, rinse immediately with clean water.
Was this review help?
14
2
Share
More Forum Discussions

What to Do When Your Car Battery Lacks Power?

If a battery is left unused for a long time, it will gradually discharge on its own until it becomes unusable. Therefore, it is advisable to start the car periodically to recharge the battery. Another method is to disconnect the two terminals of the battery. It is important to note that when removing the positive and negative terminal cables from the battery posts, the negative cable should be disconnected first, or the connection between the negative terminal and the car chassis should be removed. When the ammeter needle indicates insufficient charge, the battery should be recharged promptly. The battery's charge level can be reflected on the dashboard. If you find that the battery is low while on the road and the engine cannot be started, as a temporary measure, you can seek help from another vehicle to jump-start your car by connecting the negative terminals and positive terminals of both batteries. The density of the electrolyte should be adjusted according to the standards for different regions and seasons. When the electrolyte level is low, distilled water or a specialized replenishing fluid should be added. Avoid using drinking water as a substitute, as it contains various trace elements that can adversely affect the battery. Continuously using the starter when starting the car can cause the battery to be damaged due to excessive discharge. The correct method is to limit each starting attempt to no more than 5 seconds, with intervals of at least 15 seconds between attempts. If the car still does not start after several attempts, check other potential issues such as the electrical circuit, ignition coil, or fuel system.
1
4
Share

What to Do When the MG6 Hood Won't Open?

If the engine hood won't open, it might be due to not finding the correct method. Typically, there is an engine hood release lever located under the dashboard on the driver's side. Simply pull it to open the hood. If it still doesn't open, check if tools can be used to pry it open. If that doesn't work, it's necessary to visit a 4S store for repairs. Below are the functions of the engine hood: 1. It serves as an air deflector, where its shape helps adjust the airflow direction relative to the car's movement and reduces aerodynamic drag. 2. It protects the engine and surrounding pipelines and components. 3. The hood can adjust the direction of reflected light, reducing glare that affects the driver.
12
1
Share

Focus Door Lock Automatically Pops Open After Locking

Here are the reasons why the Focus door lock automatically pops open after locking: 1. Lubrication: The door lock mechanism is not lubricated enough. Lubricating oil should be added to each door lock mechanism. 2. Insufficient motor power: The central control motor lacks sufficient power. Check which motor is faulty and replace it. 3. Motor push rod: If the remote lock is an aftermarket installation, it could also be due to improper adjustment of the central control motor push rod length. 4. Overview: The working principle of the central door lock is to convert electrical energy into mechanical energy, using a motor to drive gears to open and close the door. The basic components mainly include the door lock switch, door lock actuator, and door lock controller.
18
0
Share

How Many Years Does a Sylphy Battery Generally Last?

The battery of a new Sylphy typically lasts 3-5 years. The designed lifespan of the battery is 27 months, but for most family vehicles that are used conservatively, the battery often lasts 3-4 years. However, after the first replacement, it usually needs to be replaced every 2 years or so. Below is an introduction to battery maintenance: 1.1. Use a damp cloth to wipe the exterior of the battery, cleaning off dust, oil, white powder, and other contaminants that could cause leakage on the panel and terminals (the positive and negative poles). Regular cleaning prevents the accumulation of white acidic corrosion powder on the terminals, extending the battery's lifespan. 2. Open the battery's water-filling caps to check if the water level is within the normal range. There are usually upper and lower limit markers on the side of the battery for reference. If the water level is below the lower marker, distilled water must be added. In an emergency, filtered tap water can be used if distilled water is unavailable. Do not overfill; the standard is to fill to the midpoint between the upper and lower markers. 3. Check if the battery is charging properly. If you have a multimeter, measure the voltage across the battery terminals after starting the engine. It should exceed 13V to be considered normal. If the charging voltage is too low, a professional should inspect the charging system. If you don't have a multimeter, you can use a visual method: after starting the engine, open the battery's water-filling caps and observe if there are bubbles in each cell.
17
0
Share

What Causes the Car Screen to Not Light Up?

The car screen not lighting up can be caused by many reasons. The car display screen not only provides access to navigation, reverse camera images, vehicle fuel consumption information, but also offers a variety of multimedia entertainment systems for operation. It not only provides convenience to the occupants but also enhances the interior aesthetics. However, if the car display screen malfunctions, the inconvenience it brings to the driver will be obvious. Therefore, if there is an issue, it should be checked and repaired promptly. Next, let's take a look at the possible causes. 1. Check whether the screen is damaged, the wiring is faulty, or the IC and motherboard caused a crash. This is the most common issue. If it's a hardware problem, you can only take it to a 4S shop for maintenance or to a repair shop for inspection. 2. Check if the software version is outdated or not updated in time, which may cause the display screen to malfunction. If so, simply upgrade the software version. 3. If the DVD operation is lagging and the car display screen does not light up or respond to touch, try restarting the power supply of the car screen. 4. Third-party software is incompatible with the system. Check if any new software has been downloaded recently. A crash may be caused by unstable programs or insufficient memory. In this case, you need to free up some memory and uninstall the related software. 5. Finally, if many methods have been tried and still don't work, the only solution is to perform a car diagnostic test and replace the navigation device with a new one.
17
2
Share

How Long Can Hongqi Last?

Hongqi is very resilient and will last for a long time. Here is some relevant information about Hongqi: 1. Introduction to Hongqi: Hongqi is a premium automotive brand directly operated by FAW Group. On January 8, 2018, FAW Group announced the new Hongqi brand strategy, with "Chinese New Noble Refinement" as its brand concept. On July 31, 2018, the 60th anniversary celebration of the Hongqi brand officially commenced. On October 23, 2018, Hongqi became the diamond partner of the 5th World Internet Conference. 2. Hongqi's Service Philosophy: Establishing the "Hongqi Heart Service System," which includes offline experience centers, digital experience centers, the Qishituan community, Hongqi car-sharing services, and a lifetime free service commitment (warranty, rescue, and pickup/delivery).
18
0
Share
Cookie
Cookie Settings
© 2025 Servanan International Pte. Ltd.